参数资料
型号: AD8022ARMZ-REEL7
厂商: Analog Devices Inc
文件页数: 8/17页
文件大小: 0K
描述: IC OPAMP VF DUAL LN LP 8MSOP
设计资源: AD7266 SAR ADC in DC-Coupled Differential and Single-Ended Appls (CN0039)
AD7265 in Differential and Single-Ended Configurations Using AD8022 (CN0048)
标准包装: 1
放大器类型: 电压反馈
电路数: 2
转换速率: 50 V/µs
-3db带宽: 130MHz
电流 - 输入偏压: 2.5µA
电压 - 输入偏移: 1500µV
电流 - 电源: 4mA
电流 - 输出 / 通道: 55mA
电压 - 电源,单路/双路(±): 4.5 V ~ 26 V,±2.25 V ~ 13 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: 8-MSOP
包装: 标准包装
其它名称: AD8022ARMZ-REEL7DKR
Data Sheet
AD8022
Rev. C | Page 15 of 16
+VIN
–VIN
+VOUT
–VOUT
191
Ω
1%
191
Ω
1%
243
Ω
1%
243
Ω
1%
249
Ω
1%
422
Ω
1%
249
Ω
1%
COMMON-
MODE
VOLTAGE
SIGNAL CM LEVEL
8200pF
10%
8200pF
10%
6800pF
5% NPO
6800pF
5% NPO
0.1
μF
50V
5%
NPO
0.1
μF
16V
10%
X7R
AD8022
12V
3
2
8
1
AD8022
6
5
4
7
01053-041
Figure 41. Differential Input Sallen-Key Filter
Using AD8022 on Single Supply, +12 V
FREQUENCY (Hz)
(dB)
7.5
–42.5
–37.5
–32.5
–27.5
–22.5
–17.5
–12.5
–7.5
–2.5
2.5
10k
10M
1M
100k
01053-042
Figure 42. Frequency Response of Sallen-Key Filter
LAYOUT CONSIDERATIONS
As is the case with all high speed amplifiers, careful attention to
printed circuit board layout details prevent associated board
parasitics from becoming problematic. Proper RF design
technique is mandatory. The PCB should have a ground plane
covering all unused portions of the component side of the
board to provide a low impedance return path. Removing the
ground plane from the area near the input signal lines reduces
stray capacitance. Chip capacitors should be used for supply
bypassing. One end of the capacitor should be connected to the
ground plane, and the other should be connected no more than
1/8 inch away from each supply pin. An additional large
(0.47 μF to 10 μF) tantalum capacitor should be connected in
parallel, although not necessarily as close, in order to supply
current for fast, large signal changes at the AD8022 output.
Signal lines connecting the feedback and gain resistors should
be as short as possible, minimizing the inductance and stray
capacitance associated with these traces. Locate termination
resistors and loads as close as possible to the input(s) and
output, respectively. Adhere to stripline design techniques for
long signal traces (greater than about 1 inch). Following these
generic guidelines improves the performance of the AD8022 in
all applications.
相关PDF资料
PDF描述
EHF-125-01-L-D-RA CONN HEADER .05" 50POS DUAL R/A
TFM-120-01-S-D-WT CONN HEADER 40POS 1.27MM GLD PCB
TMM-110-01-T-S CONN HEADER 10POS SNGL 2MM T/H
TSW-104-14-L-D CONN HEADER 8POS .100" DUAL GOLD
TSW-104-08-S-S-RA CONN HEADER 4POS .100 SGL R/A AU
相关代理商/技术参数
参数描述
AD8022AR-REEL 制造商:Analog Devices 功能描述:ADSL Receiver Dual 8-Pin SOIC N T/R 制造商:Rochester Electronics LLC 功能描述:SOIC DUAL HIGH SPEED LOW NOISE OP AMP - Tape and Reel
AD8022AR-REEL7 制造商:Analog Devices 功能描述:ADSL Receiver Dual 8-Pin SOIC N T/R
AD8022ARZ 功能描述:IC OPAMP VF DUAL LN LP 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源,单路/双路(±):3 V ~ 32 V,±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP(0.173",4.40mm 宽) 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR
AD8022ARZ-REEL 功能描述:IC OPAMP VF DUAL LN LP 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- 放大器类型:电流检测 电路数:1 输出类型:- 转换速率:- 增益带宽积:125kHz -3db带宽:- 电流 - 输入偏压:- 电压 - 输入偏移:100µV 电流 - 电源:1.1µA 电流 - 输出 / 通道:- 电压 - 电源,单路/双路(±):- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:4-WFBGA,CSPBGA 供应商设备封装:4-UCSP(2x2) 包装:剪切带 (CT) 其它名称:MAX9634WERS+TCT
AD8022ARZ-REEL7 功能描述:IC OPAMP VF DUAL LN LP 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:100 系列:- 放大器类型:通用 电路数:1 输出类型:- 转换速率:0.2 V/µs 增益带宽积:- -3db带宽:- 电流 - 输入偏压:100pA 电压 - 输入偏移:30µV 电流 - 电源:380µA 电流 - 输出 / 通道:- 电压 - 电源,单路/双路(±):±2 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-SOIC(0.154",3.90mm 宽) 供应商设备封装:8-SO 包装:管件