- 您现在的位置：买卖IC网 > PDF目录369654 > CAT24C256LI-GT3 256-Kb I2C CMOS Serial EEPROM PDF资料下载
参数资料
| 型号： | CAT24C256LI-GT3 |
| 英文描述： | 256-Kb I2C CMOS Serial EEPROM |
| 中文描述： | 256 - KB的的I2C的CMOS串行EEPROM |
| 文件页数： | 6/14页 |
| 文件大小： | 526K |
| 代理商： | CAT24C256LI-GT3 |
CAT24C256
6
Doc. No. 04, Rev. D
2007 by Catalyst Semiconductor, Inc.
Characteristics subject to change without notice
WRITE OPERATIOnS
byte Write
In Byte Write mode the Master sends a START, followed
by Slave address, two byte address and data to be
written (Figure 5). The Slave acknowledges all 4 bytes,
and the Master then follows up with a STOP, which in
turn starts the internal Write operation (Figure 6). During
internal Write, the Slave will not acknowledge any Read
or Write request from the Master.
Page Write
The CAT24C256 contains 32,768 bytes of data, arranged
in 52 pages of 64 bytes each. A two byte address word,
following the Slave address, points to the first byte to be
written. The most significant bit of the address word is
‘don’t care’, the next 9 bits identify the page and the last
6 bits identify the byte within the page. Up to 64 bytes
can be written in one Write cycle (Figure 7).
The internal byte address counter is automatically in-
cremented after each data byte is loaded. If the Master
transmits more than 64 data bytes, then earlier bytes will
be overwritten by later bytes in a ‘wrap-around’ fashion
(within the selected page). The internal Write cycle starts
immediately following the STOP.
Acknowledge Polling
Acknowledge polling can be used to determine if the
CAT24C256 is busy writing or is ready to accept com-
mands. Polling is implemented by interrogating the
device with a ‘Selective Read’ command (see READ
OPERATIONS).
The CAT24C256 will not acknowledge the Slave address,
as long as internal Write is in progress.
Hardware Write Protection
With the WP pin held HIGH, the entire memory is pro-
tected against Write operations. If the WP pin is left
floating or is grounded, it has no impact on the operation
of the CAT24C256.
相关PDF资料 |
PDF描述 |
|---|---|
| CAT24C256LIT3 | 256-Kb I2C CMOS Serial EEPROM |
| CAT24C256WI-GT3 | 256-Kb I2C CMOS Serial EEPROM |
| CAT24C256XI-GT3 | 256-Kb I2C CMOS Serial EEPROM |
| CAT24C256XIT3 | 256-Kb I2C CMOS Serial EEPROM |
| CAT3200ZI-TE7 | Low Noise Regulated Charge Pump DC-DC Converter |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CAT24C256WE-GT3 | 制造商:ON Semiconductor 功能描述:256-KB I2C SERIAL CMOS EEPROM MEMORY SOIC-8 PKG, 3K/REEL - Tape and Reel |
| CAT24C256WGI | 制造商:Catalyst Semiconductor 功能描述: |
| CAT24C256WI-G | 功能描述:电可擦除可编程只读存储器 (32768x8) 256K RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| CAT24C256WI-G | 制造商:ON Semiconductor 功能描述:IC EEPROM 256KBIT SERIAL 400KHZ SOIC-8 制造商:ON Semiconductor 功能描述:IC, EEPROM, 256KBIT SERIAL 400KHZ SOIC-8 |
| CAT24C256WI-GT3 | 功能描述:电可擦除可编程只读存储器 256K-Bit I2C Serial CMOS 电可擦除可编程只读存储器 RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
发布紧急采购，3分钟左右您将得到回复。