80V1000uf电容_电动车_电动车充电器_LED_1000uf80V_80V电容

批发数量
梯度价格
型号
80V1000 18*30 1000UF80V
品牌
其他
介质材料
铝电解
应用范围
滤波
外形
圆柱形
功率特性
大功率
频率特性
高频
调节方式
固定
引线类型
轴向引出线
允许偏差
±10(%)
耐压值
100(V)
损耗
5%
额定电压
80(V)
温度系数
105℃
标称容量
1000
特性
耐低温-40℃ 专为LED电源设计

热销宝贝




  • 80V1000uf电容|电动车|电动车充电器|LED|1000uf80V|80V电容

    ¥立即咨询立即购买





  • 450V68uf电容|电动车|电动车充电器|LED|68uf450V|450V电容

    ¥立即咨询立即购买





  • 400V1000电容|1000UF400V电容|UPS|牛角型电容|大电容|电焊机

    ¥立即咨询立即购买





  • 450V10uf电容|电容器|LED电容|LED电|10uf450V|450V电容

    ¥立即咨询立即购买





  • 50V1000uf电容|电容器|LED电容|LED|1000uf50V|50V电容

    ¥立即咨询立即购买





  • 120V680uf电容|电容器|LED电容|LED电|680uf120V|120V电容

    ¥立即咨询立即购买


此模板由精准推广王提供,我也要免费出现在这里


 

 


产品介绍
    • 产品信息
    • 名称:  大容量电解电容
    • 品牌: Haicap 
    • 型号: 80V1000   18*30   1000UF80V
    • 颜色:  PET黑色套管白色印字 
    • 产品特点
    • KM系列Series

    • ◎宽温度产品,105℃, 2000小时寿命, 体积小, 容量大
        Wide temperature range,105℃,Load life:2000hours, small size, large capacity
      ◎适用于DVD, 背投彩电, 空调等线路中Used in DVD, color-TV, air condition circuits etc.

    •  



产品包装图



  •  内包装采用环保PE袋。


  •  外包装采用硬纸皮。

 






  •  


  •  

 

 


产品特性

   所有产品都按JIS-C-5101标准和内部检测标准严格执行生产。

   CAP容量,DF损耗,LC漏电流,ESR阻抗,RC纹波电流,RV耐压等性能全部通过检测合格,并且有相关数 

  据记录可提供测试报告。

 



产品可靠性验证



  •  产品都有通过105℃高温负荷寿命验证,可放心使用。


  •  针对LED电源系列电容,可全部通过低温测试,CAP在零下-40℃还可保持在±20%以内,完全保障了LED电源的低温使用。

 

 
  •  


定制说明


1.起拍数量:最小包装
2.如需样品: 新客户提供10PCS免费样品,老客户提供50PCS免费样品,超出数量收费,样品价格双方协商解决。
3.交货时间:常用规格,正常有现货随时订随时发。缺货或者数量大时可接受预订,交期为5~7个工作日。
4.关于发货:小件快递,大件送货上门。



产品使用注意事项

  
直流铝电解电容只能使用在直流电路上,其极性必须标明.
DC aluminum electrolytic capacitors can only be used in DC on the road, its polarity must be marked.
 
在电路回路中如不清楚或不明确线路的极性时,则建议使用无极性铝电解电容.
In the circuit loop, such as clear or not clear when the polarity of the line, it is recommended to use non-polarized electrolytic capacitors.
 
铝电解电容器的工作环境温度不能超过规定的使用温度范围.
Electrolytic capacitors is the operating temperature can not exceed the specified temperature range.
 
铝电解电容器应该储存于低温及干燥场所,如储存期较长,则使用前应用额定电压对其重新老练.
Electrolytic capacitors should be stored in low temperature and dry place, such as the storage period is longer, the rated voltage is applied before using them to re-experienced.
 
通过铝电解电容器的纹波电流不应超过其允许范围,如果超过了规定值,需选用耐大纹波的铝电解电容器.
The ripple current through the electrolytic capacitor should not exceed the allowable range, if more than the specified value, the need to use a large ripple-resistant aluminum electrolytic capacitors.
 
使用时铝电解电容器的工作电压不应超过其额定工作电压.
Use the operating voltage aluminum electrolytic capacitors should not exceed its rated voltage.
 
电烙铁等高温发热装置应与铝电解电容器之塑料外壳保持适当的距离,以防止过热造成塑料管破裂.
Electric iron and other high-temperature heating with aluminum electrolytic capacitors of the device should maintain an appropriate distance from the plastic housing to prevent overheating caused by plastic pipe rupture.
 
在焊接铝电解电容器时,其焊接时间及焊接温度不应超过10秒钟及260摄氏度.
In welding aluminum electrolytic capacitor, the welding time and weld temperature should not exceed 10 seconds and 260 degrees Celsius.
 
对引线、端子,如施加超过规定的力,将会破坏铝电解电容器的内部结构.
Of lead, terminal, such as applied exceeds the force will destroy the internal structure of aluminum electrolytic capacitors.

主要技术参数


  • 1、使用电压范围Rated voltage range
          6.3~450V.DC

  • 2、标称电容量范围Nominal capacitance range
         1~6800μF   ±20%(120Hz,+20℃) 

  • 3、漏电流Leakage current (MAX)
     


     I≤0.01CV or 3(uA) 2分钟 取较大者(at 20℃, after 2 minutes) (whichever is greater)           6.3~100V适用
 
        I≤0.03CV + 40(uA) 2分钟(at 20℃, after 2 minutes)               160~450V适用

  • 4、损耗角正切值tgδ(+20℃,120Hz)Dissipation factor(MAX)
  •         

    UR(V)

    6.3

    10

    16

    25

    35

    50

    63

    100

    ~250

    350~

    tgδ

    0.22

    0.19

    0.16

    0.14

    0.12

    0.10

    0.09

    0.08

    0.20

    0.24

  • 5、耐久性Load life
     

  • ΦD

    5~6.3

    8

    10~18

    Load life

    3000h

    4000h

    5000h

  •  
    +105℃加额定电压2000~5000小时,恢复16小时后:
    After applying rated voltage for 2000 hours at +105℃ and then resumed for16 hours:
    电容量变化率Capacitance change: ±20%初始测量值以内 ±20%of the initial measured value
    漏电流 Leakage current: ≤初始规定值≤the initial specified value
    损耗角正切值 Dissipation factor: ≤2倍初始规定值≤2times of the Initial specified value

  • 6、外形图及尺寸表Case size table
     
  •   
  •   

    ΦD

    5

    6.3

    8

    10

    13

    16

    18

    F

    2.0

    2.5

    3.5

    5.0

    5.0

    7.5

    7.5

    Φd

    0.5

    0.6

    0.8

    ɑ

    L≤16:ɑ=1.5   L≥20:ɑ=2.0

 
 
 
 
 
 
 
 
 
 好品牌源于好品质,我们的品质成就你的品牌。
 
 
Haicap品牌铝电解电容
 
 
品牌成就你我梦想!
 
 
 
 

  •