Products 产品 | Cement type resistors (SQZ)水泥电阻SQZ型 |
Features 特点 | 1.Good heat-durability, low temperature coefficient, low noise, high load power, high insulating capacity. 耐热性好、温度系数小、噪声低、负荷功率大、绝缘性高。 2.Operating ambient temperature 使用环境温度 :-55℃~+275℃ 3.Resistance tolerance阻值误差: ±1%,±2%,±5%,±10%. |
Power rated 额定功率 Item 项目 | 2W | 3W | 5W | 7W | 10W | 15W | 20W~25W |
Max. working voltage 最大工作电压 | 150V | 350V | 350V | 500V | 750V | 1000V | 100V |
Dielectric withstanding voltage 耐电压 | 1000V (AC) | 1000V (AC) | 1000V (AC) | 1000V (AC) | 1000V (AC) | 1000V (AC) | 1000V (AC) |
Resistance tolerance 阻值精度 | J±5% | J±5% | J±5% | J±5% | J±5% | J±5% | J±5% |
Products (1 lead wire) 品名(单脚) | Dimensions(mm) 尺寸 | Resistance Range(Ω) 阻值范围 (Ω) | |
L±1.5 | W±1 | H±1.5 | P±1.5 | P1±0.2 | P2±0.2 | H1±2 | H2±1 | KN | MO | |
5W z-01 | 28 | 10 | 10 | 15 | 7 | 1.5 | 25 | 10.5 | 0.1-130 | 131-68K | |
7W z-01 | 36 | 10 | 10 | 20 | 7 | 1.5 | 25 | 10.5 | 0.1-600 | 601-68K | |
10W z-01 | 48 | 10 | 10 | 35 | 7 | 1.5 | 25 | 10.5 | 0.2-1K | 1K1-100K | |
10W z-03 | 48 | 10 | 10 | 35 | 7 | 1.5 | 40 | 25 | 0.2-1K | 1K1-100K | |
15W z-05 | 50 | 12.5 | 12 | 35 | 10 | 3 | 35 | 15.0 | 1-1K | 1K1-150K | |
20W~25w z-05 | 65 | 14 | 13 | 42 | 10 | 3 | 36 | 15.0 | 1-1K | 1K1-150K | |
Products(2 lead wires) 品名(双脚) | Dimensions(mm) 尺寸 | Resistance Range(Ω) 阻值范围 (Ω) | |
L±1.5 | W±1 | H±1.5 | P±1.5 | H1±0.5 | H2±0.5 | A±0.1 | B±0.1 | C±0.2 | KN | MO | |
5W z-02 | 28 | 10 | 10 | 15 | 10.5 | 4.5 | 1.5 | 3.5 | 7.5 | 0.1-130 | 131-68K | |
7W z-02 | 36 | 10 | 10 | 20 | 10.5 | 4.5 | 1.5 | 3.5 | 7.5 | 0.1-600 | 60Ω-68K | |
10W z-04 | 48 | 10 | 10 | 20 | 25 | 4.5 | 1.5 | 3.5 | 7.5 | 0.2-1K | 60Ω-68K | |
10W z-04 | 48 | 10 | 10 | 35 | 25 | 4.5 | 1.5 | 3.5 | 7.5 | 0.2-1K | 1K1-100K | |
15W z-06 | 50 | 12.5 | 12 | 35 | 28 | 4.5 | 2 | 5 | 10 | 1-1K | 1K1-150K | |
20W z-06 | 65 | 14 | 14 | 42 | 28 | 4.5 | 2 | 5 | 10 | 1-1K | 1K1-150K | |
25W z-06 | 65 | 14 | 14 | 42 | 28 | 4.5 | 2 | 5 | 10 | 1-1K | 1K1-150K | |
20W z-07 | 65 | 14 | 14 | 42 | 10 | 4.5 | 2 | 5 | 10 | 1-1K | 1K1-150K | |
25W z-07 | 65 | 14 | 14 | 42 | 10 | 4.5 | 2 | 5 | 10 | 1-1K | 1K1-150K | |
Cement Type Resistor (wire wound)水泥电阻器(绕线) |
Characteristics 特性 | Specifications 规格 | Test Method 测试方法 |
DC Resistance直流阻抗值 JIS-C-5202 5.1 | J ± 5% | AT 25℃ |
Dielectric withstanding voltage 耐电压 JIS-C-5202 5.7 | No evidence of flashover mechanical amage, arcing or insulation breakdown. 涂装不可烧毁,绝缘不可破坏 | Resistance shall be clamped with a conductive material which conforms to resistors surface so that 90o of the outer periphery is contacted a potential of 1000V AC shall be applied for 60 seconds. 电阻两端导线置于金属V型槽上依电性表之电压规格印加60秒。 |
Insulation Resistance 绝缘阻抗 JIS-C-5202 5.6 | 1000MΩ MIN | Withstanding test and shall be measured at DC 500V. Resistor shall be prepared AC same method of dielectric. 以DC500V测试待测体于V形槽之上导线及其表面涂装印加60秒。 |
Thermal Shock 热冲击 | ΔR≤±(2%R0+0.1Ω) | After application of rated power for 30 minutes, 30 minutes exposure to -30±5℃ ambient temperature. 额定电压印加30分钟后,于8到12秒以内置于30°C中30分钟。 |
Humidity 耐湿性 JIS-C-5202 7.5 | ΔR≤±(2%R0+0.1Ω) | Temperature resistance change after 1000 hours exposure in a humidity test chamber controlled at 40±2℃ and 90~95% relative humidity. 在温度为40±2°C,相对湿度为90~95%时置于恒温箱中不加电压,连续放置1000小时。 |
Cement Type Resistor (metal oxide film)水泥电阻器(金属氧化皮膜) |
Short time overload 短时间过负荷 | ΔR≤±(2%R0+0.05Ω) | Temperature resistance change after the application of a potential of 2.5 times RCVW for 5 seconds. 2.5倍额定电压测试5秒。 |
Load Life 室温寿命 JIS-C-5202 7.10 | ΔR≤±(5%R0+0.1Ω) | Permanent resistance change after 1000 hours operating at RCWV, with duty cycle of 1.5 hours on and 0.5 hours off at 25℃±2℃.在温度为25℃±2℃下以额定电压测试1000小时,其中以通电1.5小时,断电0.5小时进行。 |
Load Life in Humidity 湿度寿命 JIS-C-5202 7.9 | ΔR≤±(5%R0+0.1Ω) | Temperature resistance change after 1000 hours(1.5hours on and 0.5 hours off) at RCVW in a humidity chamber controlled at 40±2℃ and 90~95% relative humidity. 在温度为25℃±2℃,相对湿度为90~95%时下以额定电压测试1000小时,其中以通电1.5小时,断电0.5小时进行。 |
Solderability 可焊性 JIS-C-5202 6.5 | 95% coverage MIN | Test temperature of solder:230±5℃ 锡炉温度:230±5℃ Dwell time in solder:3±0.5 seconds 浸炉时间:3±0.5 seconds |
Humidity 耐湿性 JIS-C-5202 7.5 | ΔR≤±(5%R0+0.1Ω) | Temperature resistance change after 1000 hours exposure in a humidity test chamber controlled at 40±2℃ and 90~95% relative humidity. 在温度为40±2°C,相对湿度为90~95%时置于恒温箱中不加电压,连续放置1000小时。 |
Resistance to Soldering Heat 耐热性 | ΔR≤±(1%R0+0.05Ω) | Immerge into the 350±10°C tin stove by3.2~4.8 mm length as the follow form. 浸入锡炉中3.2mm~4.8mm,如下表规定所示:Temperature温度 | Dip Time浸入时间 | 350°C±10°C | 3.0±0.5 seconds | 260°C±5°C | 10±1seconds |
|
Nonflammability 不燃性 | Nonflammable 不可燃烧 | Load 5 min according to 5times, 10 times, 16 times rated power and A.C. respectively. 分别施以5,10,16倍额定功率加交流负荷5分钟。 |
Notes备注 | More details, please feel free to contact us.更多信息,请联系我们。 |