参数资料
| 型号： | LT6211IMS#TR |
| 厂商： | Linear Technology |
| 文件页数： | 5/18页 |
| 文件大小： | 0K |
| 描述： | IC AMP CURR FDBK DUAL R-R 10MSOP |
| 标准包装： | 2,500 |
| 放大器类型： | 电流反馈 |
| 电路数： | 2 |
| 输出类型： | 满摆幅 |
| 转换速率： | 700 V/µs |
| -3db带宽： | 200MHz |
| 电流 - 输入偏压： | 13.5µA |
| 电压 - 输入偏移： | 1000µV |
| 电流 - 电源： | 6mA |
| 电流 - 输出 / 通道： | 75mA |
| 电压 - 电源，单路/双路(±)： | 3 V ~ 12 V，±1.5 V ~ 6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-MSOP |
| 包装： | 带卷 (TR) |
LT6210/LT6211
13
62101fc
applicaTions inForMaTion
Capacitive Loads
The LT6210/LT6211 are stable with any capacitive load.
Although peaking and overshoot may result in the AC
transientresponse,theamplifier’scompensationdecreases
bandwidthwithincreasingoutputcapacitiveloadtoensure
stability. To maintain a response with minimal peaking, the
feedbackresistorcanbeincreasedatthecostofbandwidth
as shown in the Typical Performance Characteristics.
Alternatively, a small resistor (5Ω to 35Ω) can be put in
series with the output to isolate the capacitive load from
theamplifieroutput.Thishastheadvantagethattheampli-
fier bandwidth is only reduced when the capacitive load
is present. The disadvantage of this technique is that the
gain is a function of the load resistance.
Power Supplies
The LT6210/LT6211 will operate on single supplies from
3V to 12V and on split supplies from ±1.5V to ±6V. If split
supplies of unequal absolute value are used, input offset
voltageandinvertinginputcurrentwillshiftfromthevalues
specifiedintheElectricalCharacteristicstable.Inputoffset
voltage will shift 2mV and inverting input current will shift
0.5A for each volt of supply mismatch.
Slew Rate
Unlike a traditional voltage feedback op amp, the slew rate
of a current feedback amplifier is not independent of the
amplifier gain configuration. In a current feedback ampli-
fier, both the input stage and the output stage have slew
rate limitations. In the inverting mode, and for gains of 2
or more in the noninverting mode, the signal amplitude
between the input pins is small and the overall slew rate
is that of the output stage. For gains less than 2 in the
noninverting mode, the overall slew rate is limited by the
input stage. The input slew rate of the LT6210/LT6211 on
±5V supplies with an RSET resistor of 20k (IS = 6mA) is
approximately 600V/s and is set by internal currents and
capacitances. The output slew rate is additionally con-
strained by the value of the feedback resistor and internal
capacitance. At a gain of 2 with 887Ω feedback and gain
resistors, ±5V supplies and the same biasing as above,
the output slew rate is typically 700V/s. Larger feedback
resistors, lower supply voltages and lower supply current
levelswillallreduceslewrate.Inputslewratessignificantly
exceeding the output slew capability can actually decrease
slew performance in a positive gain configuration; the
cleanest transient response will be obtained from input
signals with slew rates slower than 1000V/s.
Output Swing and Drive
The output stage of the LT6210/LT6211 consists of a pair
ofclass-ABbiasedcommonemittersthatenabletheoutput
to swing rail-to-rail. Since the amplifiers can potentially
deliveroutputcurrentswellbeyondthespecifiedminimum
short-circuit current, care should be taken not to short the
output of the device indefinitely. Attention must be paid to
keep the junction temperature of the IC below the absolute
maximum rating of 150°C if the output is used to drive
low impedance loads. See Note 5 for details. Additionally,
the output of the amplifier has reverse-biased ESD diodes
connected to each supply. If the output is forced beyond
eithersupply,largecurrentswillflowthroughthesediodes.
If the current is limited to 80mA or less, no damage to
the part will occur.
相关PDF资料 |
PDF描述 |
|---|---|
| EL5260IY-T7 | IC AMP CFA DUAL 200MHZ 10-MSOP |
| TA45-A144H100C0 | CIRCUIT BRKR ROCKR ILL 10A 2P QC |
| TA45-ABDBP160C0 | CIRCUIT BRKR ROCKER 16A 2POLE QC |
| PPTC341LGBN-RC | CONN FEMALE 34POS .100" R/A TIN |
| 950406-5002-AR | CONN SOCKET 6POS RT/A 2MM T/H |
相关代理商/技术参数 |
参数描述 |
|---|---|
| EP9307-IRR | 功能描述:微处理器 - MPU IC Universal Platfrm ARM9 SOC Prcessor RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324 |
| EP9307-IRZ | 功能描述:微处理器 - MPU IC Universal Platfrm ARM9 SOC Prcessor RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324 |
| EP9307-IRZR | 功能描述:微处理器 - MPU IC Universal Platfrm ARM9 SOC Prcessor RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324 |
| EP9308 | 制造商:PCA 制造商全称:PCA ELECTRONICS INC. 功能描述:14 Pin DIP 5 Tap Low-Profile TTL Compatible Active Delay Lines |
| EP9309 | 制造商:PCA 制造商全称:PCA ELECTRONICS INC. 功能描述:14 Pin DIP 5 Tap Low-Profile TTL Compatible Active Delay Lines |
发布紧急采购，3分钟左右您将得到回复。