参数资料
型号: LT1576IS8#TR
厂商: LINEAR TECHNOLOGY CORP
元件分类: 稳压器
英文描述: 3.5 A SWITCHING REGULATOR, 240 kHz SWITCHING FREQ-MAX, PDSO8
封装: 0.150 INCH, PLASTIC, SOP-8
文件页数: 10/28页
文件大小: 290K
代理商: LT1576IS8#TR
18
LT1576/LT1576-5
APPLICATIONS INFORMATION
WU
U
guarantee power sharing. The actual value of the capacitor
in microfarads is not particularly important because at
200kHz, any value above 15
F is essentially resistive.
RMS ripple current rating is the critical parameter. Actual
RMS current can be calculated from:
II
V
RIPPLE RMS
OUT
IN
OUT
IN
() =
()/ 2
The term inside the radical has a maximum value of 0.5
when input voltage is twice output, and stays near 0.5 for
a relatively wide range of input voltages. It is common
practice therefore to simply use the worst-case value and
assume that RMS ripple current is one half of load current.
At maximum output current of 1.5A for the LT1576, the
input bypass capacitor should be rated at 0.75A ripple
current. Note however, that there are many secondary
considerations in choosing the final ripple current rating.
These include ambient temperature, average versus peak
load current, equipment operating schedule, and required
product lifetime. For more details, see Application Notes
19 and 46, and Design Note 95.
Input Capacitor Type
Some caution must be used when selecting the type of
capacitor used at the input to regulators. Aluminum
electrolytics are lowest cost, but are physically large to
achieve adequate ripple current rating, and size con-
straints (especially height), may preclude their use.
Ceramic capacitors are now available in larger values, and
their high ripple current and voltage rating make them
ideal for input bypassing. Cost is fairly high and footprint
may also be somewhat large. Solid tantalum capacitors
would be a good choice, except that they have a history of
occasional spectacular failures when they are subjected to
large current surges during power-up. The capacitors can
short and then burn with a brilliant white light and lots of
nasty smoke. This phenomenon occurs in only a small
percentage of units, but it has led some OEM companies
to forbid their use in high surge applications. The input
bypass capacitor of regulators can see these high surges
when a battery or high capacitance source is connected.
Several manufacturers have developed a line of solid
tantalum capacitors specially tested for surge capability
(AVX TPS series for instance, see Table 3), but even these
units may fail if the input voltage surge approaches the
maximum voltage rating of the capacitor. AVX recom-
mends derating capacitor voltage by 2:1 for high surge
applications. The highest voltage rating is 50V, so 25V
may be a practical upper limit when using solid tantalum
capacitors for input bypassing.
Larger capacitors may be necessary when the input volt-
age is very close to the minimum specified on the data
sheet. Small voltage dips during switch on time are not
normally a problem, but at very low input voltage they may
cause erratic operation because the input voltage drops
below the minimum specification. Problems can also
occur if the input-to-output voltage differential is near
minimum. The amplitude of these dips is normally a
function of capacitor ESR and ESL because the capacitive
reactance is small compared to these terms. ESR tends to
be the dominate term and is inversely related to physical
capacitor size within a given capacitor type.
SYNCHRONIZING (Available as -SYNC Option)
The LT1576-SYNC has the SHDN pin replaced with a
SYNC pin, which is used to synchronize the internal
oscillator to an external signal. The SYNC input must pass
from a logic level low, through the maximum synchroni-
zation threshold with a duty cycle between 10% and 90%.
The input can be driven directly from a logic level output.
The synchronizing range is equal to
initial operating fre-
quency up to 400kHz. This means that
minimum practical
sync frequency is equal to the worst-case
high self-
oscillating frequency (250kHz), not the typical operating
frequency of 200kHz. Caution should be used when syn-
chronizing above 280kHz because at higher sync frequen-
cies the amplitude of the internal slope compensation
used to prevent subharmonic switching is reduced. This
type of subharmonic switching only occurs at input volt-
ages less than twice output voltage. Higher inductor
values will tend to eliminate this problem. See Frequency
Compensation section for a discussion of an entirely
different cause of subharmonic switching before assum-
ing that the cause is insufficient slope compensation.
Application Note 19 has more details on the theory of slope
compensation.
相关PDF资料
PDF描述
LT1634CMS8-2.5#PBF 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO8
LT1634CMS8-1.25#PBF 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.25 V, PDSO8
LT1634CMS8-1.25#TRPBF 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 1.25 V, PDSO8
LT1680ISW#TRPBF SWITCHING CONTROLLER, 200 kHz SWITCHING FREQ-MAX, PDSO16
LT1702-7FB1 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
LT1577 制造商:LINER 制造商全称:Linear Technology 功能描述:Ultrafast Transient Response, Low Dropout Regulators Adjustable and Fixed
LT1577CS-3.3/2.8 功能描述:IC REG CTRLR DUAL OUT 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性晶体管驱动器 系列:- 产品培训模块:More Information on LDOs 标准包装:2,500 系列:- 类型:正,固定式 输出数:2 输出电压:2.8V,3.3V 电流 - 电源:12mA 输入电压:5 V ~ 22 V 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC(0.154",3.90mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
LT1577CS-3.3/2.8#PBF 功能描述:IC REG CTRLR DUAL OUT 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性晶体管驱动器 系列:- 产品培训模块:More Information on LDOs 标准包装:2,500 系列:- 类型:正,固定式 输出数:2 输出电压:2.8V,3.3V 电流 - 电源:12mA 输入电压:5 V ~ 22 V 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC(0.154",3.90mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
LT1577CS-3.3/2.8#TR 功能描述:IC REG CTRLR DUAL OUT 16SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性晶体管驱动器 系列:- 产品培训模块:More Information on LDOs 标准包装:2,500 系列:- 类型:正,固定式 输出数:2 输出电压:2.8V,3.3V 电流 - 电源:12mA 输入电压:5 V ~ 22 V 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC(0.154",3.90mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
LT1577CS-3.3/2.8#TRPBF 功能描述:IC REG CTRLR DUAL OUT 16SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性晶体管驱动器 系列:- 产品培训模块:More Information on LDOs 标准包装:2,500 系列:- 类型:正,固定式 输出数:2 输出电压:2.8V,3.3V 电流 - 电源:12mA 输入电压:5 V ~ 22 V 工作温度:0°C ~ 70°C 封装/外壳:16-SOIC(0.154",3.90mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)