- 您现在的位置：买卖IC网 > PDF目录44986 > LT3740EDHC (LINEAR TECHNOLOGY CORP) 0.14 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO16 PDF资料下载
参数资料
| 型号： | LT3740EDHC |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | 0.14 A SWITCHING CONTROLLER, 330 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封装： | 5 X 3 MM, PLASTIC, MO-229WJED-1, DFN-16 |
| 文件页数： | 5/20页 |
| 文件大小： | 234K |
| 代理商： | LT3740EDHC |
LT3740
13
3740fc
APPLICATIONS INFORMATION
Checking Transient Response
The regulator loop response can be checked by looking
at the load transient response. Switching regulators take
several cycles to respond to a step in load current. When
a load step occurs, VOUT immediately shifts by an amount
equal to
ΔILOAD*(ESR), where ESR is the effective series
resistance of COUT. ΔILOAD also begins to charge or
discharge COUT generating a feedback error signal used
by the regulator to return VOUT to its steady-state value.
During this recovery time, VOUT can be monitored for
overshoot or ringing that would indicate a stability problem.
The VC pin external components shown in Figure 2 will
provide adequate compensation for most applications. For
a detailed explanation of switching control loop theory see
Application Note 76.
Step-Up Converter Inductor Selection
The step-up converter in the LT3740 provides a BIAS voltage
about 7V higher than the input voltage VIN for the top
MOSFET drive and most of the internal controller circuitry.
The step-up converter has a current limit of 400mA.
An inductor ripple current from 100mA to 200mA is a
reasonable design for the converter. For this consideration,
a 22μH or 47μH inductor is recommended for most of the
LT3740 applications. Small size and high efciency are the
major concerns. Inductors with low core losses and small
DCR at 1MHz are good choices. Some inductors in this
category with small size are listed in Table 2.
Table 2. Recommended Inductors for Step-Up Converter
PART NUMBER
DCR (Ω)
CURRENT
RATING (MA) MANUFACTURER
LQH3C220
0.71
250
Murata
814-237-1431
www.murata.com
ELT5KT-220
0.9
420
Panasonic
714-373-7334
www.panasonic.com
CDRH3D16-220
CR32-470
0.43
0.97
400
330
Sumida
847-956-0666
www.Sumida.com
The step-up converter inductor current is the greatest
when the input voltage is the lowest. Larger Cgs of the
MOSFETs results in large inductor current. Connecting
the BGDP pin to the BIAS pin also greatly increases the
inductor current. The saturation current of the inductor
needs to cover the maximum input current.
The step-up inductor current decreases as the input voltage
increases. For high input voltages, the step-up converter
will begin skipping pulses. Although this will result in some
low frequency ripple, the BIAS voltage remains regulated
on an average basis, and the step-down controller opera-
tion is not affected.
For VIN higher than 10V step-up inductor saturation
current should be higher than 400mA. For VIN lower than
10V, a lower current rating inductor could be used. The
inductor RMS current should be higher than 250mA, and
the inductance should not be less than 10μH at 400mA.
Step-Up Converter Capacitor Selection
Thesmallsizeofceramiccapacitorsmakesthemidealforthe
output of the LT3740 step-up converter. X5R and X7R types
are recommended because they retain their capacitance
over wider voltage and temperature ranges than other types
such as Y5V or Z5U. A 1μF capacitor is recommended for
the output of the LT3740 step-up converter.
Table 3. Recommended Ceramic Capacitor Manufacturers
MANUFACTURER
PHONE
URL
Taiyo Yuden
408-573-4150
www.t-yuden.com
Murata
814-237-1431
www.murata.com
Kemet
408-986-0424
www.kemet.com
Design Example
As a design example, take a supply with the following
specications: VIN = 7V to 20V (15V nominal), VOUT = 2.5V
± 5%, IOUT(MAX) = 10A. First, choose the inductor for about
30% ripple current at nominal VIN:
L
=
2.5V
(300kHz) 0.3 10A
1–
2.5V
15V
= 2.3μH
相关PDF资料 |
PDF描述 |
|---|---|
| LT3741EFE#PBF | SWITCHING CONTROLLER, 1070 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT3741IFE#TRPBF | SWITCHING CONTROLLER, 1070 kHz SWITCHING FREQ-MAX, PDSO20 |
| LT3741EUF#PBF | SWITCHING CONTROLLER, 1070 kHz SWITCHING FREQ-MAX, PQCC20 |
| LT3741EUF#TRPBF | SWITCHING CONTROLLER, 1070 kHz SWITCHING FREQ-MAX, PQCC20 |
| LT3741IUF#PBF | SWITCHING CONTROLLER, 1070 kHz SWITCHING FREQ-MAX, PQCC20 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3740EDHC#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LT3740EDHC#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 16-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LT3740EDHC-PBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Wide Operating Range, Valley Mode, No RSENSE? Synchronous Step-Down Controller |
| LT3740EDHC-TR | 制造商:LINER 制造商全称:Linear Technology 功能描述:Wide Operating Range, Valley Mode, No RSENSE? Synchronous Step-Down Controller |
| LT3740EDHC-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Wide Operating Range, Valley Mode, No RSENSE? Synchronous Step-Down Controller |
发布紧急采购，3分钟左右您将得到回复。