参数资料
型号: MAX4286EUT-T
厂商: Maxim Integrated Products
文件页数: 4/16页
文件大小: 0K
描述: IC BUFF/AMP ADC 250MHZ SOT23-6
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 2,500
放大器类型: 缓冲器
电路数: 1
转换速率: 385 V/µs
-3db带宽: 130MHz
电流 - 输入偏压: 13µA
电压 - 输入偏移: 1500µV
电流 - 电源: 23mA
电流 - 输出 / 通道: 106mA
电压 - 电源,单路/双路(±): 2.85 V ~ 6.5 V,±1.425 V ~ 3.25 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: SOT-23-6
供应商设备封装: SOT-6
包装: 带卷 (TR)
MAX4285–MAX4288/MAX4387
/MAX4388
+3V/+5V, 250MHz, SOT23 ADC Buffer Amplifiers
with High-Speed Disable
12
______________________________________________________________________________________
RG
RF
RS
CI
MAX4285
MAX4286
MAX4287
MAX4288
MAX4387
MAX4388
Figure 1. Using an Isolation Resistor (RS ) for High Capacitive
Loads
For example, a noninverting gain-of-two configuration
(RF = RG) using 1k
resistors, combined with 2pF typi-
cal amplifier input capacitance, generates a pole at
159MHz. Since this pole is within the amplifier band-
width, it jeopardizes stability. Reducing these 1k
resistors to 100
extends the pole frequency to
1.59GHz, but affects output swing by adding 200
in
parallel with the amplifier’s load resistor. The typical
value for RF is 300
.
Layout and Power-Supply Bypassing
These amplifiers operate from a single +2.85V to +6.5V
power supply or from ±1.425V to ±3.25V dual supplies.
For single-supply operation, bypass VCC to ground with
a 0.1nF capacitor as close to the pin as possible, with a
0.1F capacitor in parallel. If operating with dual sup-
plies, bypass each supply with capacitors to ground.
Observe the following guidelines:
A solid ground plane is essential for good high-fre-
quency behavior.
Where possible, use multiple ground vias.
Use a PC board with at least two layers. Avoid
areas of unreferenced copper-clad.
Keep signal traces as short and as straight as pos-
sible. Do not make sharp turns; round all trace
corners.
Use a constant-impedance board design if possi-
ble.
High-Speed Disable
The MAX4285/MAX4286/MAX4288 and MAX4388 fea-
ture a disable (DISABLE_) input that places the amplifi-
er in a low-power, high-output-impedance state. When
DISABLE_ is asserted, the amplifier’s output impedance
is typically 35k
. This high output impedance, com-
bined with the low 2pF output capacitance, make these
devices ideal for ADC input multiplexing applications or
switch applications. Typical enable/disable times are
40ns/50ns.
Output Capacitive Loading and Stability
These op amps are optimized for AC performance.
They are not designed to drive highly reactive loads,
which decrease phase margin and may produce
excessive ringing and oscillation. A small isolation
resistor (usually 20
to 30) placed before the reactive
load reduces possible ringing and oscillation (Figure
1). At higher capacitive loads, AC performance is
dependent on the interaction of the load capacitance,
the isolation resistor, and on-board layout.
Output Drive Capability
The MAX4285–MAX4288 and MAX4387/MAX4388 have
an output sink capability of 106mA and a source capa-
bility of 77mA. This high current ability allows them to
drive low-impedance and dynamic-impedance ADC
inputs. The linear output range of these devices is (VEE
+ 0.4V) to (VCC - 0.4V). Operation beyond this range is
not recommended due to reduced gain and phase
margin.
相关PDF资料
PDF描述
CRCW08052R00FKEA RES 2.00 OHM 1/8W 1% 0805 SMD
6450330-1 MBXL R/A HDR 1P+24S+1P
160923-3 CONN UNINS TAB 20-24AWG 0.110
MAX4285EUT-T IC BUFF/AMP ADC 250MHZ SOT23-6
160887-2 CONN UNINS TAB 17-20AWG 0.110
相关代理商/技术参数
参数描述
MC7448VS667N 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:MPC7448 Hardware Specifications
MC7448VS667NC 功能描述:IC MPU RISC 667MHZ 360-FCCLGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:MPC74xx 标准包装:1 系列:MPC85xx 处理器类型:32-位 MPC85xx PowerQUICC III 特点:- 速度:1.2GHz 电压:1.1V 安装类型:表面贴装 封装/外壳:783-BBGA,FCBGA 供应商设备封装:783-FCPBGA(29x29) 包装:托盘
MC7448VS667ND 功能描述:微处理器 - MPU APL8 RV2.2.1 1.0V 105C RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324
MC7448VS800N 制造商:FREESCALE 制造商全称:Freescale Semiconductor, Inc 功能描述:MPC7448 Hardware Specifications
MC7448VS800ND 制造商:Freescale Semiconductor 功能描述:MPU MPC74XX RISC 64BIT 90NM 800MHZ 360PIN FCCLGA - Tape and Reel