参数资料
| 型号： | MIC2555-0BML TR |
| 厂商： | Micrel Inc |
| 文件页数： | 3/29页 |
| 文件大小： | 0K |
| 描述： | IC TXRX UTG USB BUS UNIV 24MLF |
| 标准包装： | 1,000 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 1/0 |
| 规程： | USB 2.0 |
| 电源电压： | 3 V ~ 4.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-VFQFN 裸露焊盘，24-MLF? |
| 供应商设备封装： | 24-MLF?（4x4） |
| 包装： | 带卷 (TR) |
| 其它名称： | MIC2555-0BMLTR |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
Micrel, Inc.
MIC2555
December 2006
11
M9999-121406
UART mode
There are two UART modes of operation:
Direct UART:
-
UART TX
SE0_VM_TX pin, data is output on D-
-
UART RX
DAT_VP_RX pin receives UART data from
D+.
Secondary UART:
-
UART TX
GPIO_1_TX pin, data is output on D-
-
UART RX
GPOI_0_RX pin, received from D+.
Conditions for UART mode:
uart_en = 1
speed = 1
uart_io = Direct UART = 0
Secondary UART inputs (GPIO) = 1
Note:
It is not necessary to reset uart_io when switching from
UART to USB mode; uart_io is deactivated when
uart_en = 0, so its setting will not effect DAT_VP_RX or
SE0_VM_TX’s operation in USB mode.
Audio Mode
There is one mode of Audio operation. In audio mode,
the MIC2555’s D+ and D- outputs are Tri-Stated (high
impedance) and the OTG controller or system
components can send and receive audio signals via the
D+, D- lines. The MIC2555 will monitor the D+ line for
voltages crossing one of two levels, as a means of
detecting a car kit interrupt signal. These interrupt events
are captured and flagged by the Serial Controller.
Conditions:
uart_en = 0
OE_INT/ = 1
cr_int_sel = detect @ 3.0V = 1
detect @ 0.5V = 0
Note:
The MIC2555 has no provision to connect or disconnect
audio devices from the D+, D- lines, so the designer is
cautioned to be sure that when the MIC2555 is operating
as a data transceiver, no damage will ensue if the
system’s audio components are exposed to USB or
UART digital signal levels.
Power Management
The transceiver’s power modes are:
Active power
:
All functions active, transceiver fully powered.
Conditions:
suspend = 0
pwr_dn = 0
Suspend power
:
The differential transmitter and receiver are turned off to
conserve power but the USB interface is still active (i.e.,
pull-ups and pull-downs still active, VBUS generation on,
etc.).
Conditions:
suspend = 1
pwr_dn = 0
Power Down:
Only the serial interface is still active and the transceiver
is able to detect SRP. The ID pin sensing may be turned
on or off with a control bit in the control registers.
Conditions:
suspend = 1
pwr_dn = 1
Control Bit
Functions Powered Down
By Control Bit
suspend
pwr_dn
cp_off
Differential Driver
●
Differential Receiver
●
UART TXD
●
D+ interrupt comparators
●
VBUS Comparators
●
VTRM LDO
●
VBUS output
●
Internal biasing circuits and
band gap reference
●
Charge Pump off
●
Power Management Table
Note:
Suspend
and
Power-Down
bits
operate
independently of each other. Activating Power-Down
does not automatically invoke Suspend.
For lowest power operation Suspend, Power-Down and
Charge Pump OFF modes must be activated:
Conditions:
suspend = 1
pwr_dn = 1
cp_off = 1
Circuits still operating:
ID detect and D- receiver continue to function.
This includes the ID comparators, ID pull-up
circuits, and D- data receiver.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-20T-MX-F4 | CONVERTER MOD DC/DC 6.5V 75W |
| D38999/26FH53PA | CONN PLUG 53POS STRAIGHT W/PINS |
| VI-J71-MX-F4 | CONVERTER MOD DC/DC 12V 75W |
| VE-20R-MX-F1 | CONVERTER MOD DC/DC 7.5V 75W |
| CS3106A-36-58P | CONN PLUG 35POS STRAIGHT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC2555-0YML TR | 功能描述:USB 接口集成电路 USB Transceiver - Lead Free RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
| MIC2555-0YML-TR | 功能描述:1/1 Transceiver Half USB 2.0 24-MLF? (4x4) 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:停产 类型:收发器 协议:USB 2.0 驱动器/接收器数:1/1 双工:半 接收器滞后:200mV 数据速率:400kbps 电压 - 电源:3 V ~ 4.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘，24-MLF? 供应商器件封装:24-MLF?（4x4） 标准包装:1 |
| MIC2555-1BML TR | 功能描述:IC TXRX UTG USB BUS UNIV 24MLF RoHS:否 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 标准包装:1,140 系列:AU 类型:收发器 驱动器/接收器数:1/1 规程:CAN 电源电压:5.3 V ~ 27 V 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SO 包装:管件 其它名称:935267940512AU5790D14AU5790D14-ND |
| MIC2555-1YML | 制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述: |
| MIC2555-1YML TR | 功能描述:USB 接口集成电路 USB Transceiver - Lead Free RoHS:否 制造商:Cypress Semiconductor 产品:USB 2.0 数据速率: 接口类型:SPI 工作电源电压:3.15 V to 3.45 V 工作电源电流: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:WLCSP-20 |
发布紧急采购，3分钟左右您将得到回复。