- 您现在的位置：买卖IC网 > PDF目录365666 > SN74V3650-6PEU (Texas Instruments, Inc.) 3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES PDF资料下载
参数资料
| 型号： | SN74V3650-6PEU |
| 厂商： | Texas Instruments, Inc. |
| 英文描述： | 3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES |
| 中文描述： | 的3.3V的CMOS先入先出存储器 |
| 文件页数： | 24/50页 |
| 文件大小： | 729K |
| 代理商： | SN74V3650-6PEU |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
SN74V3640, SN74V3650, SN74V3660, SN74V3670, SN74V3680, SN74V3690
1024
×
36, 2048
×
36, 4096
×
36, 8192
×
36, 16384
×
36, 32768
×
36
3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES
SCAS668A
–
NOVEMBER 2001
–
REVISED MARCH 2003
24
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
parallel programming mode (continued)
See Figures 3 and 17 for timing information.
It is permissible to interrupt the offset register read sequence with reads or writes to the FIFO. The interruption
is accomplished by deasserting REN, LD, or both together. When REN and LD are restored to a low level,
reading of the offset registers continues where it left off. It should be noted (and care should be taken from the
fact) that when a parallel read of the flag offsets is performed, the data word that was present on output lines
Qn is overwritten.
Parallel reading of the offset registers always is permitted, regardless of which timing mode (Standard or FWFT
modes) has been selected.
retransmit operation
The retransmit operation allows data that has been read to be accessed again. There are two modes of
retransmit operation: normal latency and zero latency. There are two stages to retransmit. The first stage is a
setup procedure that resets the read pointer to the first location of memory. The second stage is the actual
retransmit, which consists of reading out the memory contents, starting at the beginning of memory.
Retransmit setup is initiated by holding RT low during a rising RCLK edge. REN and WEN must be high before
bringing RT low. When zero latency is utilized, REN need not be high before bringing RT low. At least two words,
but no more than D
–
2 words should have been written into the FIFO, and read from the FIFO, between reset
(master or partial) and the time of retransmit setup, D = 1024 for the SN74V3640, D = 2048 for the SN74V3650,
D = 4096 for the SN74V3660, D = 8192 for the SN74V3670, D = 16384 for the SN74V3680, and D = 32768 for
the SN74V3690. In FWFT mode, D = 1025 for the SN74V3640, D = 2049 for the SN74V3650, D = 4097 for the
SN74V3660, D = 8193 for the SN74V3670, D = 16385 for the SN74V3680, and D = 32769 for the SN74V3690.
If standard mode is selected, the FIFO marks the beginning of the retransmit setup by setting EF low. The
change in level is noticeable only if EF was high before setup. During this period, the internal read pointer is
initialized to the first location of the RAM array.
When EF goes high, retransmit setup is complete and read operations can begin, starting with the first location
in memory. Because standard mode is selected, every word read, including the first word following retransmit
setup, requires a low on REN to enable the rising edge of RCLK.
See Figure 11 for timing information.
If FWFT mode is selected, the FIFO marks the beginning of the retransmit setup by setting OR high. During this
period, the internal read pointer is set to the first location of the RAM array.
When OR goes low, retransmit setup is complete. At the same time, the contents of the first location appear on
the outputs. Because FWFT mode is selected, the first word appears on the outputs and no low on REN is
necessary. Reading all subsequent words requires a low on REN to enable the rising edge of RCLK.
See Figure 12 for timing information.
For either standard mode or FWFT mode, updating of PAE, HF, and PAF begins with the rising edge of RCLK
that RT is set up on. PAE is synchronized to RCLK, thus, on the second rising edge of RCLK after RT is set up,
PAE is updated. HF is asynchronous, thus, the rising edge of RCLK that RT is set up on updates HF. PAF is
synchronized to WCLK, thus, the second rising edge of WCLK that occurs t
sk
after the rising edge of RCLK that
RT is set up on updates PAF. RT is synchronized to RCLK.
The retransmit function has the option of two modes of operation, either normal latency or zero latency.
Figures 11 and 12 show normal latency. Figures 13 and 14 show the zero-latency retransmit operation. Zero
latency means, basically, that the first data word to be retransmitted is placed in the output register, with respect
to the RCLK pulse that initiated the retransmit.
相关PDF资料 |
PDF描述 |
|---|---|
| SN74V3660-10PEU | 3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES |
| SN74V3660-15PEU | 3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES |
| SN74V3670-10PEU | 3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES |
| SN74V3670-15PEU | 3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES |
| SN74V3690-15PEU | 3.3-V CMOS FIRST-IN, FIRST-OUT MEMORIES |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SN74V3650-7PEU | 功能描述:先进先出 2048 x 36 Synch 先进先出 Memory RoHS:否 制造商:IDT 电路数量: 数据总线宽度:18 bit 总线定向:Unidirectional 存储容量:4 Mbit 定时类型:Synchronous 组织:256 K x 18 最大时钟频率:100 MHz 访问时间:10 ns 电源电压-最大:3.6 V 电源电压-最小:6 V 最大工作电流:35 mA 最大工作温度:+ 85 C 封装 / 箱体:TQFP-80 封装: |
| SN74V3660-10PEU | 功能描述:先进先出 4096 x 36 Synch 先进先出 Memory RoHS:否 制造商:IDT 电路数量: 数据总线宽度:18 bit 总线定向:Unidirectional 存储容量:4 Mbit 定时类型:Synchronous 组织:256 K x 18 最大时钟频率:100 MHz 访问时间:10 ns 电源电压-最大:3.6 V 电源电压-最小:6 V 最大工作电流:35 mA 最大工作温度:+ 85 C 封装 / 箱体:TQFP-80 封装: |
| SN74V3660-15PEU | 功能描述:先进先出 4096 x 36 Synch 先进先出 Memory RoHS:否 制造商:IDT 电路数量: 数据总线宽度:18 bit 总线定向:Unidirectional 存储容量:4 Mbit 定时类型:Synchronous 组织:256 K x 18 最大时钟频率:100 MHz 访问时间:10 ns 电源电压-最大:3.6 V 电源电压-最小:6 V 最大工作电流:35 mA 最大工作温度:+ 85 C 封装 / 箱体:TQFP-80 封装: |
| SN74V3660-6PEU | 功能描述:先进先出 4096 x 36 Synch 先进先出 Memory RoHS:否 制造商:IDT 电路数量: 数据总线宽度:18 bit 总线定向:Unidirectional 存储容量:4 Mbit 定时类型:Synchronous 组织:256 K x 18 最大时钟频率:100 MHz 访问时间:10 ns 电源电压-最大:3.6 V 电源电压-最小:6 V 最大工作电流:35 mA 最大工作温度:+ 85 C 封装 / 箱体:TQFP-80 封装: |
| SN74V3660-7PEU | 功能描述:先进先出 4096 x 36 Synch 先进先出 Memory RoHS:否 制造商:IDT 电路数量: 数据总线宽度:18 bit 总线定向:Unidirectional 存储容量:4 Mbit 定时类型:Synchronous 组织:256 K x 18 最大时钟频率:100 MHz 访问时间:10 ns 电源电压-最大:3.6 V 电源电压-最小:6 V 最大工作电流:35 mA 最大工作温度:+ 85 C 封装 / 箱体:TQFP-80 封装: |
发布紧急采购，3分钟左右您将得到回复。