参数资料
型号: 1N4701RR1
厂商: ON SEMICONDUCTOR
元件分类: 齐纳二极管
英文描述: 14 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
封装: HERMETIC SEALED, GLASS, DO-35, 2 PIN
文件页数: 8/12页
文件大小: 75K
代理商: 1N4701RR1
1N4678 Series
http://onsemi.com
5
APPLICATION NOTE — ZENER VOLTAGE
Since the actual voltage available from a given zener
diode is temperature dependent, it is necessary to determine
junction temperature under any set of operating conditions
in order to calculate its value. The following procedure is
recommended:
Lead Temperature, TL, should be determined from:
TL = θLAPD + TA.
θLA is the lead-to-ambient thermal resistance (°C/W) and PD
is the power dissipation. The value for
θLA will vary and
depends on the device mounting method.
θLA is generally 30
to 40
°C/W for the various clips and tie points in common use
and for printed circuit board wiring.
The temperature of the lead can also be measured using a
thermocouple placed on the lead as close as possible to the
tie point. The thermal mass connected to the tie point is
normally large enough so that it will not significantly
respond to heat surges generated in the diode as a result of
pulsed operation once steady-state conditions are achieved.
Using the measured value of TL, the junction temperature
may be determined by:
TJ = TL + TJL.
TJL is the increase in junction temperature above the lead
temperature and may be found from Figure 2 for dc power:
TJL = θJLPD.
For worst-case design, using expected limits of IZ, limits
of PD and the extremes of TJ(TJ) may be estimated.
Changes in voltage, VZ, can then be found from:
V = θVZTJ.
θVZ, the zener voltage temperature coefficient, is found
from Figures 4 and 5.
Under high power-pulse operation, the zener voltage will
vary with time and may also be affected significantly by the
zener resistance. For best regulation, keep current
excursions as low as possible.
Surge limitations are given in Figure 7. They are lower
than would be expected by considering only junction
temperature, as current crowding effects cause temperatures
to be extremely high in small spots, resulting in device
degradation should the limits of Figure 7 be exceeded.
LL
500
400
300
200
100
0
0.2
0.4
0.6
0.8
1
2.4-60V
62-200V
L, LEAD LENGTH TO HEAT SINK (INCH)
JL
,JUNCTIONT
OLEAD
THERMAL
RESIST
ANCE
(
C/W)
θ
°
Figure 2. Typical Thermal Resistance
TYPICAL LEAKAGE CURRENT
AT 80% OF NOMINAL
BREAKDOWN VOLTAGE
+25°C
+125°C
1000
7000
5000
2000
1000
700
500
200
100
70
50
20
10
7
5
2
1
0.7
0.5
0.2
0.1
0.07
0.05
0.02
0.01
0.007
0.005
0.002
0.001
3
4
5
6
7
8
9 10
11 121314 15
VZ, NOMINAL ZENER VOLTAGE (VOLTS)
I
,LEAKAGE
CURRENT
(
A)
R
Figure 3. Typical Leakage Current
相关PDF资料
PDF描述
1N4695CTA2 8.7 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N4678DRL2 1.8 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N4681C 2.4 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N4684D 3.3 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N4687D 4.3 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
相关代理商/技术参数
参数描述
1N4701-TP 制造商:Micro Commercial Components (MCC) 功能描述:Diode Zener Single 14V 5% 500mW 2-Pin DO-35 T/R
1N4701UR-1 制造商:Aeroflex 功能描述:COMMERCIAL ZENER VOLTAGE REGUL 制造商:Aeroflex / Metelics 功能描述:COMMERCIAL ZENER VOLTAGE REGULATOR DIODE - Bulk 制造商:Microsemi Corporation 功能描述:ZENER SGL 14V 5% 500MW 2PIN DO-213AA - Bulk
1N4702 功能描述:稳压二极管 RoHS:否 制造商:Vishay Semiconductors 齐纳电压:12 V 电压容差:5 % 电压温度系数:0.075 % / K 齐纳电流: 功率耗散:3 W 最大反向漏泄电流:3 uA 最大齐纳阻抗:7 Ohms 最大工作温度:+ 150 C 安装风格:SMD/SMT 封装 / 箱体:DO-214AC 封装:Reel
1N4702 (DO35) 制造商:Aeroflex 功能描述:COMMERCIAL ZENER VOLTAGE REGUL 制造商:Microsemi Corporation 功能描述:Diode Zener Single 15V 5% 417mW 2-Pin DO-7 制造商:Aeroflex / Metelics 功能描述:COMMERCIAL ZENER VOLTAGE REGULATOR DIODE - Bulk 制造商:Microsemi Corporation 功能描述:ZENER VOLTAGE REGULATOR DIODE DO-35 SD - Bulk
1N4702 BK 功能描述:DIODE ZENER 15V 500MW DO35 制造商:central semiconductor corp 系列:- 包装:散装 零件状态:在售 电压 - 齐纳(标称值)(Vz):15V 容差:±5% 功率 - 最大值:500mW 不同?Vr 时的电流 - 反向漏电流:50nA @ 11.4V 不同 If 时的电压 - 正向(Vf:1.5V @ 100mA 工作温度:-65°C ~ 200°C(TJ) 安装类型:通孔 封装/外壳:DO-204AH,DO-35,轴向 供应商器件封装:DO-35 标准包装:2,500