参数资料
型号: 1N958CTA
厂商: MOTOROLA INC
元件分类: 参考电压二极管
英文描述: 7.5 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
封装: GLASS, CASE 299, DO-35, 2 PIN
文件页数: 3/8页
文件大小: 69K
代理商: 1N958CTA
GENERAL DATA — 500 mW DO-35 GLASS
Motorola TVS/Zener Device Data
6-3
500 mW DO-35 Glass Data Sheet
APPLICATION NOTE — ZENER VOLTAGE
Since the actual voltage available from a given zener diode
is temperature dependent, it is necessary to determine junc-
tion temperature under any set of operating conditions in order
to calculate its value. The following procedure is recom-
mended:
Lead Temperature, TL, should be determined from:
TL = θLAPD + TA.
θLAisthelead-to-ambientthermalresistance(°C/W)andPDis
the power dissipation. The value for
θLA will vary and depends
on the device mounting method.
θLA is generally 30 to 40°C/W
for the various clips and tie points in common use and for
printed circuit board wiring.
The temperature of the lead can also be measured using a
thermocouple placed on the lead as close as possible to the tie
point. The thermal mass connected to the tie point is normally
large enough so that it will not significantly respond to heat
surges generated in the diode as a result of pulsed operation
once steady-state conditions are achieved. Using the mea-
sured value of TL, the junction temperature may be deter-
mined by:
TJ = TL + TJL.
TJL is the increase in junction temperature above the lead
temperature and may be found from Figure 2 for dc power:
TJL = θJLPD.
For worst-case design, using expected limits of IZ, limits of
PD and the extremes of TJ(TJ) may be estimated. Changes in
voltage, VZ, can then be found from:
V = θVZTJ.
θVZ, the zener voltage temperature coefficient, is found from
Figures 4 and 5.
Under high power-pulse operation, the zener voltage will
vary with time and may also be affected significantly by the
zener resistance. For best regulation, keep current excursions
as low as possible.
Surge limitations are given in Figure 7. They are lower than
would be expected by considering only junction temperature,
as current crowding effects cause temperatures to be ex-
tremely high in small spots, resulting in device degradation
should the limits of Figure 7 be exceeded.
LL
500
400
300
200
100
0
0.2
0.4
0.6
0.8
1
2.4–60 V
62–200 V
L, LEAD LENGTH TO HEAT SINK (INCH)
JL
,JUNCTION-T
O-LEAD
THERMAL
RESIST
ANCE
(
C/W)
θ
°
Figure 2. Typical Thermal Resistance
TYPICAL LEAKAGE CURRENT
AT 80% OF NOMINAL
BREAKDOWN VOLTAGE
+25
°C
+125
°C
1000
7000
5000
2000
1000
700
500
200
100
70
50
20
10
7
5
2
1
0.7
0.5
0.2
0.1
0.07
0.05
0.02
0.01
0.007
0.005
0.002
0.001
34
5
6
7
8
9
10
11
12
13
14
15
VZ, NOMINAL ZENER VOLTAGE (VOLTS)
I
,LEAKAGE
CURRENT
(
A
)
R
Figure 3. Typical Leakage Current
相关PDF资料
PDF描述
1N961CRL2 10 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N965DRL 15 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N966BTA 16 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N967CRL2 18 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
1N968DRL 20 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-204AH
相关代理商/技术参数
参数描述
1N958D 制造商:LRC 制造商全称:Leshan Radio Company 功能描述:1N9 SERIES ZENER DIODES
1N959 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Silicon 500 mW Zener Diodes
1N959A 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:Silicon 500 mW Zener Diodes
1N959B 功能描述:稳压二极管 8.2V 0.5W Zener RoHS:否 制造商:Vishay Semiconductors 齐纳电压:12 V 电压容差:5 % 电压温度系数:0.075 % / K 齐纳电流: 功率耗散:3 W 最大反向漏泄电流:3 uA 最大齐纳阻抗:7 Ohms 最大工作温度:+ 150 C 安装风格:SMD/SMT 封装 / 箱体:DO-214AC 封装:Reel
1N959B BK 功能描述:DIODE ZENER 8.2V 500MW DO35 制造商:central semiconductor corp 系列:- 包装:散装 零件状态:在售 电压 - 齐纳(标称值)(Vz):8.2V 容差:±5% 功率 - 最大值:500mW 阻抗(最大值)(Zzt):6.5 Ohms 不同?Vr 时的电流 - 反向漏电流:50μA @ 6.2V 不同 If 时的电压 - 正向(Vf:1.5V @ 200mA 工作温度:-65°C ~ 200°C(TJ) 安装类型:通孔 封装/外壳:DO-204AH,DO-35,轴向 供应商器件封装:DO-35 标准包装:2,500