- 您现在的位置：买卖IC网 > PDF目录293752 > 1R5JZ41 1.5 A, 600 V, SILICON, RECTIFIER DIODE PDF资料下载
参数资料
| 型号： | 1R5JZ41 |
| 元件分类： | 参考电压二极管 |
| 英文描述： | 1.5 A, 600 V, SILICON, RECTIFIER DIODE |
| 封装： | LEAD FREE, PLASTIC, 3-4B1A, 2 PIN |
| 文件页数： | 2/4页 |
| 文件大小： | 142K |
| 代理商： | 1R5JZ41 |
1R5JZ41,1R5NZ41
2006-11-06
2
Electrical Characteristics (Ta = 25°C)
Characteristics
Symbol
Test Condition
Min
Typ.
Max
Unit
Peak forward voltage
VFM
IFM = 1.5 A
1.0
V
Repetitive peak reverse current
IRRM
VRRM = Rated
10
μA
Thermal resistance
(junction to ambient)
Rth (j-a)
DC
(Note1)
90
°C/W
Note 1: Thermal resistance
Marking
Abbreviation Code
Part No.
1R5J
1R5JZ41
1R5N
1R5NZ41
Handling Precaution
The absolute maximum ratings denote the absolute maximum ratings, which are rated values and must not be
exceeded during operation, even for an instant. The following are the general derating methods that we recommend
when you design a circuit with a device.
VRRM: We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the
absolute maximum rating of VRRM for a DC circuit and be no greater than 50% of that of VRRM for
an AC circuit. VRRM has a temperature coefficient of 0.1%/°C. Take this temperature coefficient into
account designing a device at low temperature.
IF(AV): We recommend that the worst case current be no greater than 80% of the absolute maximum rating
of IF(AV). Carry out adequate heat design. If you can’t design a circuit with excellent heat radiation,
set the margin by using an allowable Tamax-IF(AV) curve.
This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180.
Therefore, this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.
We recommend that a device be used at a Tj of below 120°C under the worst load and heat radiation conditions.
Thermal resistance between junction and ambient fluctuates depending on the device’s mounting condition. When
using a device, design a circuit board and a soldering land size to match the appropriate thermal resistance value.
Please refer to the Rectifiers databook for further information.
15 mm
10 mm
5 mm
×
5 mm
10 mm
Lot No.
A line indicates
lead (Pb)-free package or
lead (Pb)-free finish.
1R 5J
Part No. (or abbreviation code)
相关PDF资料 |
PDF描述 |
|---|---|
| 1R5NH45 | 1.5 A, 1000 V, SILICON, RECTIFIER DIODE |
| 1S1888TPA1 | 1 A, 1000 V, SILICON, SIGNAL DIODE |
| 1S1887TPA1 | 1 A, 600 V, SILICON, SIGNAL DIODE |
| 1SMA5927 | 12 V, 1.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-214AC |
| 1SMA5916 | 4.3 V, 1.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-214AC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 1R5JZ41(Q) | 制造商:Toshiba America Electronic Components 功能描述:Diode 600V 1.5A 2-Pin DO-15L |
| 1R5NH41 | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:FAST RECOVERY RECTIFIER (SWITCHING TYPE POWER SUPPLY APPLICATIONS) |
| 1R5NH45 | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:FAST RECOVERY RECTIFIER (SWITCHING TYPE POWER SUPPLY APPLICATIONS) |
| 1R5NH45(Q) | 制造商:Toshiba America Electronic Components 功能描述:Diode Switching 100V 1.5A 2-Pin 3-4B1A |
| 1R5NU41 | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:SUPER FAST RECOVERY RECTIFIER (SWITCING TYPE POWER SUPPLY APPLICATIONS) |
发布紧急采购，3分钟左右您将得到回复。