- 您现在的位置：买卖IC网 > PDF目录91041 > 1SMB3EZ7.5T/R7 7.5 V, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-214AA PDF资料下载
参数资料
| 型号： | 1SMB3EZ7.5T/R7 |
| 元件分类： | 齐纳二极管 |
| 英文描述： | 7.5 V, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-214AA |
| 封装： | ROHS COMPLIANT, PLASTIC, SMB, 2 PIN |
| 文件页数： | 3/5页 |
| 文件大小： | 341K |
| 代理商： | 1SMB3EZ7.5T/R7 |
PAGE . 3
STAD-MAR.25.2009
1
1SMB3EZ6.8~1SMB3EZ51
APPLICATION NOTE:
Since the actual voltage available from a given zener diode is temperature dependent, it is necessary to determinejunction
temperature under any set of operating conditions in order to calculate its value. The following procedure is recommended:
Lead Temperature, T , should be determined from:
T= LA P + T
L is the lead-to-ambient thermal resistance ( C/W) and Pd is the power dissipation. The value for L will vary and depends
on the device mounting method.
L is generally 30-40 C/W for the various clips and tie points in common use and for printed
circuit board wiring.
The temperature of the lead can also be measured using a thermocouple placed on the lead as close as possible to the tie point.
The thermal mass connected to the tie point is normally large enough so that it will not significantly respond to heat surges
generated in the diode as a result of pulsed operation once steady-state conditions are achieved. Using the measured value of
TL, the junction temperature may be determined by:
T= T + T
T
is the increase in junction temperature above the lead temperature and may be found from Figure 2 for a train of power pulses
or from Figure 10 for dc power.
T= J P
For worst-case design, using expected limits of I , limits of P and the extremes of T ( T ) may be estimated. Changes in voltage,
V , can then be found from:
V= V
T
V , the zener voltage temperature coefficient, is found from Figures 5 and 6.
Under high power-pulse operation, the zener voltage will vary with time and may also be affected significantly by the zener resistance.
For best regulation, keep current excursions as low as possible.
Data of Figure 2 should not be used to compute surge capa-bility. Surge limitations are given in Figure 3. They are lower than would
be expected by considering only junction temperature, as current crowding effects cause temperatures to be extremely high in small
spots resulting in device degradation should the limits of Figure 3 be exceeded.
L
LD
A
JL
Z
q
D
Dq
D
Dq
D
q
O
JL
L
D
ZD
J
Z
ZJ
1
2
3
1000
500
300
200
100
50
30
20
10
相关PDF资料 |
PDF描述 |
|---|---|
| 1SMB3EZ8.7T/R7 | 8.7 V, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-214AA |
| 1SMB3EZ9.1T/R7 | 9.1 V, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-214AA |
| 1SMB48CA | 600 W, UNIDIRECTIONAL, SILICON, TVS DIODE |
| 1SMB75CA | 600 W, UNIDIRECTIONAL, SILICON, TVS DIODE |
| 1SMB12CA | 600 W, UNIDIRECTIONAL, SILICON, TVS DIODE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 1SMB3EZ8.2 | 制造商:PANJIT 制造商全称:Pan Jit International Inc. 功能描述:GLASS PASSIVATED JUNCTION SILICON ZENER DIODES |
| 1SMB3EZ8.2_R1_00001 | 制造商:PanJit Touch Screens 功能描述: |
| 1SMB3EZ8.2_R2_00001 | 制造商:PanJit Touch Screens 功能描述: |
| 1SMB3EZ8.2-AU_R1_000A1 | 制造商:PanJit Touch Screens 功能描述: |
| 1SMB3EZ8.2-AU_R2_000A1 | 制造商:PanJit Touch Screens 功能描述: |
发布紧急采购，3分钟左右您将得到回复。