参数资料
型号: 20IMX7-05-05-8Z
元件分类: 电源模块
英文描述: 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE
文件页数: 2/18页
文件大小: 299K
代理商: 20IMX7-05-05-8Z
Board Mountable
DC-DC Converters
IMX 7 Series
Edition 6/5.2000
10/18
70
100
Uo [%]
t [ms]
05041
8.5
60.5
overload short circuit condition
switch-off
40
50
60
70
80
90
h [%]
05052
25
50
75
100
Po
Po nom
[%]
U i nom
U i max
U i min
Fig. 15
Overload switch-off (hiccup mode). Typical values.
Frequency of pulses: 16.5 Hz, puls duration: 8.5 ms.
Fig. 16
Efficiency versus input voltage and load. Typical values
(40 IMX 7-12-12).
Adjustable Output Voltage (R input)
As a standard feature, the IMX 7 single and double output
units offer adjustable output voltage(s) by using the control
input R. If the R pin is left open circuit the output voltage is
set to
Uo nom. The output voltage is adjustable in the range
75...105 % of
Uo nom.The circuit works for single and double
output units in a different way. For output voltages
Uo >
Uo nom, the minimum input voltage Ui min (see: Electrical In-
put Data) increases proportionally to Uo/Uo nom.
Single output units:
The R input is referenced to the secondary side of the con-
verter. Adjustment of the output voltage is possible by
means of either an external resistor or a voltage source.
a) Adjustment by means of an external resistor
Rext1:
Depending upon the value of the required output voltage,
the resistor shall be connected
either: Between the R pin and Vo– to achieve an output
voltage adjustment range of approximately
Uo = 75...100 % Uo nom. (85...100% for 3.3 V outputs)
Uo
Rext1
≈ 4 k –––––––––
Uo nom – Uo
or: Between the R pin and Vo+ to achieve an output volt-
age range of approximately
Uo = 100...105 % Uo nom.
(
Uo – 2.5 V)
Rext2 ≈ 4 k –––––––––––––––––––
2.5 V (
Uo/Uo nom – 1)
Auxiliary Functions
Inhibit Function
The output(s) of the converter may be enabled or disabled
by means of a logic signal (TTL, CMOS, etc.) applied to the
inhibit pin. No output voltage overshoot will occur when the
unit is turned on. If the inhibit function is not required the
inhibit pin should be connected to Vi– to enable the output
(active low logic, fail safe).
Converter operating:
–10 V...0.8 V
Converter inhibited
or inhibit pin left open:
2.4 V...
Ui max
(<75 V for 70/110 IMX 7)
Fig. 17
If the inhibit is not used the inhibit pin should be con-
nected to Vi–
Vi+
Vi –
i
06070
相关PDF资料
PDF描述
20IMX7-24-24-9L 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE
28IWR1-05-05-T 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE
28IWR1-15-N 1-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE
20IMX7-03-8 1-OUTPUT 5 W DC-DC REG PWR SUPPLY MODULE
24IML10-12-12-3Z 2-OUTPUT 10 W DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
20IMX7-05-05-9 制造商:POWER-ONE 制造商全称:Power-One 功能描述:7 Watt DC-DC Converters
20IMX7-05-8 功能描述:DC/DC转换器 7W (5V) DC Input (8.4-36V) RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
20IMX7058G 制造商:Power-One 功能描述:
20IMX7-05-8G 功能描述:DC/DC转换器 RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
20IMX7-05-8M 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 5.1V 1.2A 6.1W 9PIN - Bulk