参数资料
型号: 20IMX7-24-24-9L
元件分类: 电源模块
英文描述: 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE
文件页数: 3/18页
文件大小: 299K
代理商: 20IMX7-24-24-9L
Board Mountable
DC-DC Converters
IMX 7 Series
Edition 6/5.2000
11/18
R
Vo+
Vo–
+
U
ext
4 k
Uref 2.5 V
control
circuit
Vi+
Vi–
R
ext1
R
ext 2
06029
Fig. 18
Output voltage control for single output units by means of
the R-input
Double output units:
The R input (Trim) input is referenced to the primary side.
The figure below shows the circuit topology. Adjustment of
the output voltage is possible by means of either an exter-
nal resistor in the range of 100...105% of
Uo nom, or an ex-
ternal voltage source in the range of 75...105% of
Uo nom.
R (Trim)
Vo1+
Vo2–
+
U
ext
Vi+
Vi–
R
ext
Vo1–
Vo2+
06030
Control
circuit
Uref 2.5 V
Fig. 19
Output voltage control for double output units by means of
the R input
a) Adjustment by means of an external resistor.
Programming of the output voltage by means of an exter-
nal resistor
Rext1 is possible within a limited range of
100...105% of
Uo nom. Rext1 should be connected between
the R-pin and Vi–. Connection of
Rext1 to Vi+ may dam-
age the converter. The following table indicates suitable
resistor values for typical output voltages under nominal
conditions (
Ui nom, Io = 0.5 Io nom), with either paralleled
outputs or equal load conditions on each output.
b) Adjustment by means of an external voltage source
Uext.
For external output voltage programming in the range
75...105% of
Uo nom a (0...20 V) source Uext is required,
connected to the R-pin and Vi–. The table below indi-
cates typical
Uo versus Uext values under nominal condi-
tions (
Ui nom, Io = 0.5 Io nom), with either paralleled outputs
or equal load conditions on each output. Applying a con-
trol voltage greater than 20 V will set the converter into a
hiccup mode. Direct paralleling of the R-pins of units con-
nected in parallel is feasible.
Table 7: Uext for Uo = 75...105% Uo nom;
typical values (Ui nom, Io1, 2 = 0.5 Io1/2 nom)
Uo [% Uo nom]
Uext [V]
≥105
0
102
1.6
95
4.5
85
9
75
13
b) Adjustment by means of an external voltage
Uext be-
tween Vo– and R pins.
The control voltage range is 1.87...2.62 V and allows for
an adjustment in the range of approximately 75...105%.
(85...105% for 3.3 V outputs)
Uo 2.5 V
Uext ≈ –––––––––
Uo nom
Attempting to adjust the output below this range will
cause the converter to shutdown (hiccup mode).
Note: Applying an external control voltage >2.75 V may
damage the converter.
Table 6: Rext1 for Uo > Uo nom;
approximate values (Ui nom, Io1, 2 = 0.5 Io1/2 nom)
Uo [% Uo nom]
Rext [k]
105...108 (107 typically)
0
105
1.5
104
5.6
103
12
102
27
101
68
100
相关PDF资料
PDF描述
28IWR1-05-05-T 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE
28IWR1-15-N 1-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE
20IMX7-03-8 1-OUTPUT 5 W DC-DC REG PWR SUPPLY MODULE
24IML10-12-12-3Z 2-OUTPUT 10 W DC-DC REG PWR SUPPLY MODULE
24IML10-15-15-3C 2-OUTPUT 10 W DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
20IMX7-24-9C 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 24V 0.13A 7W 9PIN - Bulk
20INCH-D1-BASIC 功能描述:板上安装压力/力传感器 0-20" H20 Differen 6V supp 2 ports same RoHS:否 制造商:Honeywell 工作压力:0 bar to 4 bar 压力类型:Gage 准确性:+ / - 0.25 % 输出类型:Digital 安装风格:Through Hole 工作电源电压:5 V 封装 / 箱体:SIP 端口类型:Dual Radial Barbed, Same sides
20INCH-D1-MV-MINI 功能描述:板上安装压力/力传感器 0-20" H2O Diff 20mV 16V supp 2 port same RoHS:否 制造商:Honeywell 工作压力:0 bar to 4 bar 压力类型:Gage 准确性:+ / - 0.25 % 输出类型:Digital 安装风格:Through Hole 工作电源电压:5 V 封装 / 箱体:SIP 端口类型:Dual Radial Barbed, Same sides
20INCH-D2-BASIC 功能描述:板上安装压力/力传感器 0-20" H20 Differen 6V supp 2 ports opp RoHS:否 制造商:Honeywell 工作压力:0 bar to 4 bar 压力类型:Gage 准确性:+ / - 0.25 % 输出类型:Digital 安装风格:Through Hole 工作电源电压:5 V 封装 / 箱体:SIP 端口类型:Dual Radial Barbed, Same sides
20INCH-D2-MV-MINI 功能描述:板上安装压力/力传感器 0-20" H2O Diff 20mV 16V supp 2 port opp RoHS:否 制造商:Honeywell 工作压力:0 bar to 4 bar 压力类型:Gage 准确性:+ / - 0.25 % 输出类型:Digital 安装风格:Through Hole 工作电源电压:5 V 封装 / 箱体:SIP 端口类型:Dual Radial Barbed, Same sides