参数资料
型号: 2300973
厂商: Phoenix Contact
文件页数: 7/20页
文件大小: 0K
描述: CONN 37POS D-SUB W/SCREW
标准包装: 1
系列: SUBCON
连接器类型: D-Sub
位置数: 37
行数: 2
外壳尺寸,连接器布局: 4(DC,C)
触点类型:: 信号
连接器类型: 插头,公引脚
安装类型: 自由悬挂
法兰特点: 线缆侧;公型起重螺钉(4-40)
端子: 端接块
特点: 缆线夹,屏蔽
工作温度: -20°C ~ 75°C
额定电压: 60V
额定电流: 1A
体座材料: 丙烯腈苯乙烯丁二烯共聚物(ABS),带金属镀层
其它名称: Q5062552
SUBCON37/M-SH
4
Cable Preparation
The SUBCON 37 can accept either one or two individual cables with an outside
diameter ranging from 4 mm to 12.5 mm. Wire and cable recommendations are
shown in Table 2. Figure 4 shows general stripping recommendations for cables
with one or a combination of shielding types.
1. Strip 80 mm (3.149 in.) from the cable jacket.
2. Cut back the braided shielding or foil wrap 70 mm (2.755 in.) so there is
10 mm (0.393 in.) remaining. If drain wire is used, do not cut.
3. Strip 4.5 mm (0.177 in.) from the end of each conductor.
80 mm (3.149 in.)
70 mm (2.755 in.)
10 mm (0.393 in.)
4.5 mm
(0.177 in.)
Foil Wrap
100% Coverage
Cable Jacket
1668A023
Figure 4.
Drain Wire
Strip-Length Requirements
360° Braided
Shielding
Cable Diameter
4 mm to 13.08 mm
(0.157 in. to 0.515 in.)
4. Fold back the braided shielding, foil wrap, or drain wire evenly over the cable
jacket.
80 mm (3.149 in.)
Fold Braided Shielding, Drain
Wire or Foil-Wrap Back Over
Cable Jacket
10 mm (0.393 in.)
Cable Jacket
1668A024
Figure 5.
Preparing the Cable Shielding
Drain
Wire
Braided
Shielding
Foil Wrap
1668_en_C
PHOENIX CONTACT
5
相关PDF资料
PDF描述
1130-681K-RC CHOKE RF HI CURR 680UH 10% RAD
VI-2NZ-CX-F2 CONVERTER MOD DC/DC 2V 30W
RCM08DTAN-S189 CONN EDGECARD 16POS R/A .156 SLD
VI-B1V-CV-F4 CONVERTER MOD DC/DC 5.8V 150W
1130-472K-RC CHOKE RF HI CURR 4700UH 10% RAD
相关代理商/技术参数
参数描述
2300986 功能描述:D-Sub标准连接器 SUBCON 37/F-SH RoHS:否 制造商:Omron Electronics 位置/触点数量:9 排数:2 型式:Female 安装风格:Through Hole 安装角:Right 端接类型:Solder 过滤:
230-09-AL-832 制造商:PROMPTUS 功能描述:
230-09-AL-832-B2 制造商:PROMPTUS 功能描述:
2300A 制造商:Marinco Electrical Group 功能描述:
2300-A 功能描述:旋钮和转盘 RoHS:否 制造商:Davies Molding 材料:Phenolic 设计:Set Screw 轴尺寸:0.25 in 直径:3/4 in 颜色:Black 指示器型式:Line