参数资料
型号: 24AA02H-I/P
厂商: Microchip Technology
文件页数: 10/30页
文件大小: 0K
描述: IC EEPROM 2KBIT 400KHZ 8DIP
标准包装: 60
格式 - 存储器: EEPROMs - 串行
存储器类型: EEPROM
存储容量: 2K (256 x 8)
速度: 100kHz,400kHz
接口: I²C,2 线串口
电源电压: 1.7 V ~ 5.5 V
工作温度: -40°C ~ 85°C
封装/外壳: 8-DIP(0.300",7.62mm)
供应商设备封装: 8-PDIP
包装: 管件
24AA02H/24LC02BH
8.0
READ OPERATION
8.3
Sequential Read
Read operations are initiated in the same way as write
operations, with the exception that the R/W bit of the
slave address is set to ‘ 1 ’. There are three basic types
of read operations: current address read, random read
and sequential read.
Sequential reads are initiated in the same way as a
random read, except that once the 24XX02H transmits
the first data byte, the master issues an acknowledge
as opposed to a Stop condition in a random read. This
directs the 24XX02H to transmit the next sequentially-
addressed 8-bit word (Figure 8-3).
8.1
Current Address Read
To provide sequential reads, the 24XX02H contains an
The 24XX02H contains an address counter that main-
tains the address of the last word accessed, internally
incremented by ‘ 1 ’. Therefore, if the previous access
(either a read or write operation) was to address n , the
internal Address Pointer that is incremented by one
upon completion of each operation. This Address
Pointer allows the entire memory contents to be serially
read during one operation.
next current address read operation would access data
from address n + 1 . Upon receipt of the slave address
8.4
Noise Protection
with R/W bit set to ‘ 1 ’, the 24XX02H issues an acknowl-
edge and transmits the 8-bit data word. The master will
not acknowledge the transfer, but does generate a Stop
condition, and the 24XX02H discontinues transmission
(Figure 8-1).
The 24XX02H employs a V CC threshold detector circuit
which disables the internal erase/write logic if the V CC
is below 1.5V at nominal conditions.
The SCL and SDA inputs have Schmitt Trigger and
filter circuits which suppress noise spikes to assure
8.2
Random Read
proper device operation, even on a noisy bus.
Random read operations allow the master to access
any memory location in a random manner. To perform
this type of read operation, the word address must first
be set. This is accomplished by sending the word
address to the 24XX02H as part of a write operation.
Once the word address is sent, the master generates
a Start condition following the acknowledge. This
terminates the write operation, but not before the
internal Address Pointer is set. The master then
issues the control byte again, but with the R/W bit set
to a ‘ 1 ’. The 24XX02H will then issue an acknowledge
and transmit the 8-bit data word. The master will not
acknowledge the transfer, but does generate a Stop
condition, and the 24XX02H will discontinue
transmission (Figure 8-2).
FIGURE 8-1:
CURRENT ADDRESS READ
S
Bus Activity
Master
T
A
R
Control
Byte
Data (n)
S
T
O
T
P
SDA Line
S 1
0
1
0
x x
x
1
P
Bus Activity
x = “don’t care”
DS22105A-page 10
Block
Select
Bits
A
C
K
N
o
A
C
K
? 2008 Microchip Technology Inc.
相关PDF资料
PDF描述
EP3SE110F1152C3N IC STRATIX III E 110K 1152-FBGA
24LC01BT-I/MC IC EEPROM 1KBIT 400KHZ 8DFN
EP1S60F1020C6 IC STRATIX FPGA 60K LE 1020-FBGA
EP4SGX110FF35C4 IC STRATIX IV FPGA 110K 1152FBGA
EP3SE110F780C3N IC STRATIX III E 110K 780-FBGA
相关代理商/技术参数
参数描述
24AA02HT 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/LT 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/MNY 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/MS 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/OT 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect