参数资料
型号: 24AA02H-I/ST
厂商: Microchip Technology
文件页数: 8/30页
文件大小: 0K
描述: IC EEPROM 2KBIT 400KHZ 8TSSOP
标准包装: 100
格式 - 存储器: EEPROMs - 串行
存储器类型: EEPROM
存储容量: 2K (256 x 8)
速度: 100kHz,400kHz
接口: I²C,2 线串口
电源电压: 1.7 V ~ 5.5 V
工作温度: -40°C ~ 85°C
封装/外壳: 8-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 8-TSSOP
包装: 管件
24AA02H/24LC02BH
5.0
WRITE OPERATION
5.2
Page Write
5.1
Byte Write
The write-control byte, word address and the first data
byte are transmitted to the 24XX02H in the same way
Following the Start condition from the master, the
device code (4 bits), the block address (3 bits, “don’t
cares”) and the R/W bit which is a logic low, is placed
onto the bus by the master transmitter. This indicates to
the addressed slave receiver that a byte with a word
address will follow once it has generated an Acknowl-
edge bit during the ninth clock cycle. Therefore, the
next byte transmitted by the master is the word address
and will be written into the Address Pointer of the
24XX02H. After receiving another Acknowledge signal
from the 24XX02H, the master device will transmit the
data word to be written into the addressed memory
location. The 24XX02H acknowledges again and the
as in a byte write. However, instead of generating a Stop
condition, the master transmits up to 8 data bytes to the
24XX02H, which are temporarily stored in the on-chip
page buffer and will be written into memory once the
master has transmitted a Stop condition. Upon receipt
of each word, the four lower-order Address Pointer bits
are internally incremented by ‘ 1 ’. The higher-order 7
bits of the word address remain constant. If the master
should transmit more than 8 words prior to generating
the Stop condition, the address counter will roll over and
the previously received data will be overwritten. As with
the byte write operation, once the Stop condition is
received an internal write cycle will begin (Figure 5-2).
master generates a Stop condition. This initiates the
internal write cycle and, during this time, the 24XX02H
will not generate Acknowledge signals (Figure 5-1).
FIGURE 5-1:
BYTE WRITE
Note:
Page write operations are limited to writing
bytes within a single physical page
regardless of the number of bytes
actually being written. Physical page
boundaries start at addresses that are
integer multiples of the page buffer size (or
‘page size’) and end at addresses that are
integer multiples of [page size – 1]. If a
Page Write command attempts to write
across a physical page boundary, the
result is that the data wraps around to the
beginning of the current page (overwriting
data previously stored there), instead of
being written to the next page, as might be
expected. It is therefore necessary for the
application software to prevent page write
operations that would attempt to cross a
page boundary.
Bus Activity
Master
S
T
A
R
T
Control
Byte
Word
Address
Data
S
T
O
P
SDA Line
S
1
0
1
0
x
x x
0
P
A
A
A
Bus Activity
Block
Select
C
K
C
K
C
K
x = “don’t care”
FIGURE 5-2:
Bits
PAGE WRITE
Bus Activity
Master
S
T
A
R
T
Control
Byte
Word
Address (n)
Data (n)
Data (n + 1)
Data (n + 7)
S
T
O
P
SDA Line
S 10 10 xx x0
P
A
A
A
A
A
Bus Activity
x = don’t care
Block
Select
Bits
C
K
C
K
C
K
C
K
C
K
DS22105A-page 8
? 2008 Microchip Technology Inc.
相关PDF资料
PDF描述
34AA02T-I/MS IC EEPROM 2KBIT 400KHZ 8MSOP
34LC02T-I/ST IC EEPROM 2KBIT 1MHZ 8TSSOP
34AA02T-I/ST IC EEPROM 2KBIT 400KHZ 8TSSOP
24AA02HT-I/MS IC EEPROM 2KBIT 400KHZ 8MSOP
EP1S40F780C5N IC STRATIX FPGA 40K LE 780-FBGA
相关代理商/技术参数
参数描述
24AA02HT 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/LT 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/MNY 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/MS 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect
24AA02HT-E/OT 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:2K I2C? Serial EEPROM with Half-Array Write-Protect