参数资料
型号: 24LC04BT-I/SN
厂商: Microchip Technology
文件页数: 8/34页
文件大小: 0K
描述: IC EEPROM 4KBIT 400KHZ 8SOIC
产品培训模块: I2C Serial EEPROM
标准包装: 3,300
格式 - 存储器: EEPROMs - 串行
存储器类型: EEPROM
存储容量: 4K (2 x 256 x 8)
速度: 400kHz
接口: I²C,2 线串口
电源电压: 2.5 V ~ 5.5 V
工作温度: -40°C ~ 85°C
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOICN
包装: 带卷 (TR)
24AA04/24LC04B
6.0
WRITE OPERATION
6.2
Page Write
6.1
Byte Write
The write control byte, word address and the first data
byte are transmitted to the 24XX04 in the same way as
Following the Start condition from the master, the
device code (4 bits), the block address (3 bits) and the
R/W bit, which is a logic-low, is placed onto the bus by
the master transmitter. This indicates to the addressed
slave receiver that a byte with a word address will
follow once it has generated an Acknowledge bit during
the ninth clock cycle. Therefore, the next byte transmit-
ted by the master is the word address and will be
written into the Address Pointer of the 24XX04. After
receiving another Acknowledge signal from the
24XX04, the master device will transmit the data word
to be written into the addressed memory location. The
24XX04 acknowledges again and the master
in a byte write. But instead of generating a Stop condi-
tion the master transmits up to 16 data bytes to the
24XX04, which are temporarily stored in the on-chip
page buffer and will be written into memory once the
master has transmitted a Stop condition. Upon receipt
of each word, the four lower-order Address Pointer bits
are internally incremented by ‘ 1 ’. The higher-order 7
bits of the word address remain constant. If the master
should transmit more than 16 words prior to generating
the Stop condition, the address counter will roll over
and the previously received data will be overwritten. As
with the byte write operation, once the Stop condition is
received an internal write cycle will begin (Figure 6-2).
generates a Stop condition. This initiates the internal
write cycle and, during this time, the 24XX04 will not
generate Acknowledge signals (Figure 6-1).
Note:
6.3
Page write operations are limited to writing
bytes within a single physical page
regardless of the number of bytes
actually being written. Physical page
boundaries start at addresses that are
integer multiples of the page buffer size (or
‘page size’) and end at addresses that are
integer multiples of [page size – 1]. If a
page write command attempts to write
across a physical page boundary, the
result is that the data wraps around to the
beginning of the current page (overwriting
data previously stored there), instead of
being written to the next page as might be
expected. It is therefore necessary for the
application software to prevent page write
operations that would attempt to cross a
page boundary.
Write Protection
The WP pin allows the user to write-protect the entire
array (000-1FF) when the pin is tied to V CC . If tied to
V SS the write protection is disabled.
The Chip Scale package does not suport the write-
protect feature.
FIGURE 6-1:
BYTE WRITE
Bus Activity
Master
S
T
A
R
T
Control
Byte
Word
Address
Data
S
T
O
P
SDA Line
S 1
0
1
0
x
x B0 0
P
A
A
A
Bus Activity
x = “don’t care”
Block
Select
C
K
C
K
C
K
Bits
DS21708K-page 8
? 2009 Microchip Technology Inc.
相关PDF资料
PDF描述
APA1000-BG456 IC FPGA PROASIC+ 1M 456-PBGA
24LC01BT-I/ST IC EEPROM 1KBIT 400KHZ 8TSSOP
24LC00/ST IC EEPROM 128BIT 400KHZ 8TSSOP
EP2AGX190EF29C6N IC ARRIA II GX FPGA 190K 780FBGA
24LC00T/ST IC EEPROM 128BIT 400KHZ 8TSSOP
相关代理商/技术参数
参数描述
24LC04BT-I-SNG 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:4K I2Ca?¢ Serial EEPROM
24LC04-I/SL 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Microchip Technology Inc 功能描述:
24LC04T-I/SL100 制造商:Rochester Electronics LLC 功能描述:- Bulk
24LC08 制造商:CERAMATE 制造商全称:CERAMATE 功能描述:8K-Bit Serial EEPROM
24LC080-IP 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:8K/16K 2.5V SPI O Bus Serial EEPROM