参数资料
型号: 24LC04BT-I/ST
厂商: Microchip Technology
文件页数: 11/34页
文件大小: 0K
描述: IC EEPROM 4KBIT 400KHZ 8TSSOP
产品培训模块: I2C Serial EEPROM
标准包装: 2,500
格式 - 存储器: EEPROMs - 串行
存储器类型: EEPROM
存储容量: 4K (2 x 256 x 8)
速度: 400kHz
接口: I²C,2 线串口
电源电压: 2.5 V ~ 5.5 V
工作温度: -40°C ~ 85°C
封装/外壳: 8-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 8-TSSOP
包装: 带卷 (TR)
24AA04/24LC04B
8.0
READ OPERATION
8.3
Sequential Read
Read operations are initiated in the same way as write
operations, with the exception that the R/W bit of the
slave address is set to ‘ 1 ’. There are three basic types
of read operations: current address read, random read
and sequential read.
Sequential reads are initiated in the same way as a
random read, except that once the 24XX04 transmits
the first data byte, the master issues an acknowledge
as opposed to a Stop condition in a random read. This
directs the 24XX04 to transmit the next sequentially-
addressed 8-bit word (Figure 8-3).
8.1
Current Address Read
To provide sequential reads, the 24XX04 contains an
The 24XX04 contains an address counter that main-
tains the address of the last word accessed, internally
incremented by ‘ 1 ’. Therefore, if the previous access
(either a read or write operation) was to address n , the
internal Address Pointer that is incremented by one
upon completion of each operation. This Address
Pointer allows the entire memory contents to be serially
read during one operation.
next current address read operation would access data
from address n + 1 . Upon receipt of the slave address
8.4
Noise Protection
with R/W bit set to ‘ 1 ’, the 24XX04 issues an acknowl-
edge and transmits the 8-bit data word. The master will
not acknowledge the transfer, but does generate a Stop
condition and the 24XX04 discontinues transmission
(Figure 8-1).
The 24XX04 employs a V CC threshold detector circuit
which disables the internal erase/write logic if the V CC
is below 1.5V at nominal conditions.
The SCL and SDA inputs have Schmitt Trigger and
filter circuits which suppress noise spikes to assure
8.2
Random Read
proper device operation, even on a noisy bus.
Random read operations allow the master to access
any memory location in a random manner. To perform
this type of read operation, the word address must first
be set. This is accomplished by sending the word
address to the 24XX04 as part of a write operation.
Once the word address is sent, the master generates a
Start condition following the acknowledge. This termi-
nates the write operation, but not before the internal
Address Pointer is set. The master then issues the
control byte again, but with the R/W bit set to a ‘ 1 ’. The
24XX04 will then issue an acknowledge and transmit
the 8-bit data word. The master will not acknowledge
the transfer, but does generate a Stop condition and the
24XX04, will discontinue transmission (Figure 8-2).
FIGURE 8-1:
CURRENT ADDRESS READ
S
Bus Activity
Master
T
A
R
Control
Byte
Data (n)
S
T
O
T
P
SDA Line
S 1
0
1
0
x x B0 1
P
Bus Activity
x = “don’t care”
? 2009 Microchip Technology Inc.
Block
Select
Bits
A
C
K
N
o
A
C
K
DS21708K-page 11
相关PDF资料
PDF描述
24AA04T-I/ST IC EEPROM 4KBIT 400KHZ 8TSSOP
24AA04-I/ST IC EEPROM 4KBIT 400KHZ 8TSSOP
93LC56B/ST IC EEPROM 2KBIT 3MHZ 8TSSOP
24LC08BT-I/SN IC EEPROM 8KBIT 400KHZ 8SOIC
93LC56BT/ST IC EEPROM 2KBIT 3MHZ 8TSSOP
相关代理商/技术参数
参数描述
24LC04-I/SL 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Microchip Technology Inc 功能描述:
24LC04T-I/SL100 制造商:Rochester Electronics LLC 功能描述:- Bulk
24LC08 制造商:CERAMATE 制造商全称:CERAMATE 功能描述:8K-Bit Serial EEPROM
24LC080-IP 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:8K/16K 2.5V SPI O Bus Serial EEPROM
24LC080-ISN 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:8K/16K 2.5V SPI O Bus Serial EEPROM