- 您现在的位置：买卖IC网 > PDF目录30601 > 2SJ600-Z 25000 mA, 60 V, P-CHANNEL, Si, SMALL SIGNAL, MOSFET, TO-252AB PDF资料下载
参数资料
| 型号： | 2SJ600-Z |
| 元件分类： | 小信号晶体管 |
| 英文描述： | 25000 mA, 60 V, P-CHANNEL, Si, SMALL SIGNAL, MOSFET, TO-252AB |
| 封装： | TO-252, MP-3Z, 3 PIN |
| 文件页数： | 10/10页 |
| 文件大小： | 240K |
| 代理商： | 2SJ600-Z |
LA75695VA
No.7637-9/13
V19.V20.V21. Maximum, minimum AFT output voltage, AFT detection sensitivity [V13H, V13L, Sf]
(1) Internal AGC
(2) fp = 45.75MHz
±1.5MHz Sweep = 10mVrms (VIF input)
(3) Maximum voltage : V13H, minimum voltage : V13L.
(4) Measure the frequency deviation at which the voltage at test point B changes from V1 to V2.
f
V22.V23. VIF input resistance, Input capacitance [Ri, Ci]
(1) Referring to the Input Impedance Test Circuit, measure Ri and Ci with an impedance analyzer.
V24.V25. APC pull-in range [fpu, fpl]
(1) Internal AGC
(2) fp = 39MHz to 51MHz continuous wave; 10mVrms
(3) Adjust the SG signal frequency to be higher than fp = 45.75MHz to bring the PLL to unlocked state.
Note : The PLL is assumed to be in unlocked state when a beat signal appears at test point A.
(4) When the SG signal frequency is lowered, the PLL is brought to locked state again. f1
(5) Lower the SG signal frequency to bring the PLL to unlock state.
(6) When the SG signal frequency is raised, the PLL is brought to locked state again. f2
(7) Calculate as follows :
fpu = f1–45.75MHz
fpl = f2–45.75MHz
V26. AFT tolerance frequency 1 [dfa1]
(1) Internal AGC
(2) SG1 : 43.75MHz to 47.75MHz variable continuous wave 10mVrmns
(3) Adjust the SG1 signal frequency so that the AFT output DC voltage (test point B) becomes 2.5V;
that SG1 signal frequency is f1.
(4) External AGC (Adjust the V17.)
(5) Apply 5V to the IF AGC (pin 17) and then pick up the VCO oscillation frequency from GND, etc.;
and measure the frequency f2
(6) Calculate as follows :
AFT tolerance frequency : dfa1 = f2–f1 (kHz)
V27.V28. VCO maximum variable range (U, L) [dfu, dfl]
(1) Apply the VCC voltage to the external AGC, IF AGC (pin 17).
(2) Pick up the VCO oscillation frequency from the VIDEO output (A), GND, etc.
and adjust the VCO coil so that the frequency becomes 45.75MHz.
(3) fl is taken as the frequency when 1V is applied to the APC pin (pin 9).
In the same manner, fu is taken as the frequency when 5V is applied to the APC pin (pin 9).
dfu = fL–45.75MHz
dfl = fL–45.75MHz
相关PDF资料 |
PDF描述 |
|---|---|
| 2SJ600 | 25000 mA, 60 V, P-CHANNEL, Si, SMALL SIGNAL, MOSFET, TO-251 |
| 2SJ600-Z | 25000 mA, 60 V, P-CHANNEL, Si, SMALL SIGNAL, MOSFET, TO-252AB |
| 2SJ601-AZ | 36000 mA, 60 V, P-CHANNEL, Si, SMALL SIGNAL, MOSFET, TO-251 |
| 2SJ601-Z-AZ | 36000 mA, 60 V, P-CHANNEL, Si, SMALL SIGNAL, MOSFET, TO-252AB |
| 2SJ602-Z | 20 A, 60 V, 0.107 ohm, P-CHANNEL, Si, POWER, MOSFET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 2SJ600-Z-AZ | 制造商:Renesas Electronics 功能描述:Pch -60V -25A 50m@10V TO252 Bulk |
| 2SJ600-Z-E1-AZ | 制造商:Renesas Electronics Corporation 功能描述: |
| 2SJ601 | 制造商:Renesas Electronics Corporation 功能描述: |
| 2SJ601-AZ | 制造商:Renesas Electronics 功能描述:Pch -60V -36A 31m@10V TO251 制造商:Renesas Electronics 功能描述:Pch -60V -36A 31m@10V TO251 Cut Tape 制造商:Renesas Electronics 功能描述:Pch -60V -36A 31m@10V TO251 Bulk 制造商:Renesas Electronics Corporation 功能描述:Pch MOSFET,60V,36A,25m ohm,TO-251 制造商:Renesas 功能描述:Trans MOSFET P-CH 60V 36A 3-Pin(3+Tab) TO-251 |
| 2SJ601-Z | 制造商:NEC 制造商全称:NEC 功能描述:SWITCHING P-CHANNEL POWER MOS FET INDUSTRIAL USE |
发布紧急采购，3分钟左右您将得到回复。