参数资料
| 型号： | 34LC02-E/ST |
| 厂商： | Microchip Technology |
| 文件页数： | 10/36页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 2KBIT 1MHZ 8TSSOP |
| 产品培训模块： | I2C Serial EEPROM |
| 标准包装： | 100 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 2K (256 x 8) |
| 速度： | 1MHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 2.2 V ~ 5.5 V |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
34AA02/34LC02
6.0
READ OPERATION
6.3
Sequential Read
Read operations are initiated in the same way as write
operations, with the exception that the R/W bit of the
slave address is set to ‘ 1 ’. There are three basic types
of read operations: current address read, random read
and sequential read.
Sequential reads are initiated in the same way as a
random read, with the exception that after the 34XX02
transmits the first data byte, the master issues acknowl-
edge, as opposed to a Stop condition in a random read.
This directs the 34XX02 to transmit the next sequen-
tially addressed 8-bit word ( Figure 6-3 ).
6.1
Current Address Read
To provide sequential reads, the 34XX02 contains an
The 34XX02 contains an address counter that
maintains the address of the last word accessed, inter-
nally incremented by ‘ 1 ’. Therefore, if the previous
access (either a read or write operation) was to
internal Address Pointer, which is incremented by one
at the completion of each operation. This Address
Pointer allows the entire memory contents to be serially
read during one operation.
address n , the next current address read operation
would access data from address n+1 . Upon receipt of
the slave address with R/W bit set to ‘ 1 ’, the 34XX02
6.4
Contiguous Addressing Across
Multiple Devices
issues an acknowledge and transmits the 8-bit data
word. The master will not acknowledge the transfer, but
does generate a Stop condition and the 34XX02
discontinues transmission ( Figure 6-1 ).
The Chip Select bits (A2, A1, A0) can be used to
expand the contiguous address space for up to 16K bits
by adding up to eight 34XX02 devices on the same
bus. In this case, software can use A0 of the control
6.2
Random Read
byte as address bit A8; A1 as address bit A9, and A2
as address bit A10. It is not possible to sequentially
Random read operations allow the master to access
read across device boundaries.
any memory location in a random manner. To perform
this type of read operation, the word address must first
6.5
Noise Protection and Brown-Out
be set. This is done by sending the word address to the
34XX02 as part of a write operation. Once the word
address is sent, the master generates a Start condition
following the acknowledge. This terminates the write
operation, but not before the internal Address Pointer is
set. The master then issues the control byte again, but
with the R/W bit set to a ‘ 1 ’. The 34XX02 then issues
an acknowledge and transmits the 8-bit data word. The
master will not acknowledge the transfer, but does
generate a Stop condition and the 34XX02
discontinues transmission ( Figure 6-2 ).
The 34XX02 employs a V CC threshold detector circuit
which disables the internal erase/write logic if the V CC
is below 1.35V at nominal conditions.
The SCL and SDA inputs have Schmitt Trigger and
filter circuits which suppress noise spikes to assure
proper device operation, even on a noisy bus.
FIGURE 6-1:
CURRENT ADDRESS READ
Bus Activity
Master
S
T
A
R
Control
Byte
Data (n)
S
T
O
T
P
SDA Line
Bus Activity
S
A
C
N
O
P
K
A
C
K
DS22029F-page 10
? 2011 Microchip Technology Inc.
相关PDF资料 |
PDF描述 |
|---|---|
| 24LC08BHT-E/SN | IC EEPROM 8KBIT 400KHZ 8SOIC |
| 24LC08BH-I/P | IC EEPROM 8KBIT 400KHZ 8DIP |
| 24LC08BH-E/SN | IC EEPROM 8KBIT 400KHZ 8SOIC |
| 24LC02BHT-E/ST | IC EEPROM 2KBIT 400KHZ 8TSSOP |
| 24LC02BHT-E/MS | IC EEPROM 2KBIT 400KHZ 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 34LC02-I/MNY | 功能描述:电可擦除可编程只读存储器 2K 256 X 8 2.5V SERIAL EE IND RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| 34LC02-I/MS | 功能描述:电可擦除可编程只读存储器 2K 256 X 8 25V SERIAL EE IND RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| 34LC02-I/P | 功能描述:电可擦除可编程只读存储器 2K 256 X 8 25V SERIAL EE IND RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| 34LC02-I/SN | 功能描述:电可擦除可编程只读存储器 2K 256 X 8 25V SERIAL EE IND RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| 34LC02-I/ST | 功能描述:电可擦除可编程只读存储器 2K 256 X 8 25V SERIAL EE IND RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
发布紧急采购，3分钟左右您将得到回复。