- 您现在的位置：买卖IC网 > Datasheet目录933 > 363884-000 (TE Connectivity)FL2500-NO.3-J1-0-STK Datasheet资料下载
参数资料
| 型号： | 363884-000 |
| 厂商： | TE Connectivity |
| 文件页数： | 2/3页 |
| 文件大小： | 0K |
| 描述： | FL2500-NO.3-J1-0-STK |
| 标准包装： | 200 |
| 系列： | FL2500 |
| 类型： | 套管，弹性 |
| 收缩比率： | 4 至 1 |
| 长度： | 4.00'（1.22m） |
| 内径 - 提供： | 0.455"（11.6mm） |
| 内径 - 恢复： | 0.100"（2.5mm） |
| 已恢复的墙壁厚度： | 0.090"（2.29mm） |
| 材质： | 聚烯烃 |
| 特点： | 粘性内衬，阻燃 |
| 颜色： | 黑 |
| 其它名称： | A105278 FL2500-NO.3-J1-0-STK |
SPECIFICATION CONTROL DRAWING
Properties: (continued)
Property
Heat Shock
4 hrs. at 250°C
Thermal Aging
Unit
--
micro-amps
Requirement
No dripping, flowing, or
cracking of jacket
0.25 maximum
Test Method
ASTM D 2671
Note 4
168 hrs. at 130°C
followed by Immersion
Leak Resistance, Note 2
Flame Test
--
Self-extinguishing within
SAE J1128, Note 5
30 seconds
Fluid Resistance
micro-amps
0.25 maximum
Note 6
24 hrs. at 25°C ± 3°C
ASTM Reference Fuel C
VV-F-800 Diesel Fuel
1hr. at 100°C ± 3°C
ASTM #3 Oil
Qualification Sizes :
FL2500-2 qualifies FL2500-0, -1, -2, -3 and -4.
Note 1:
Note 2:
Note 3:
Note 4:
Tensile Strength & Secant Modulus
Calculate Tensile Strength and Secant Modulus based on wall thickness of jacket only.
Immersion Leak Resistance
Prepare 3 test assemblies insulated with FL2500-2 as follows: Construct a 3-wire to
3-wire inline splice in any suitable manner (crimped, soldered, twisted or welded).
Splice an AWG 14 and two AWG 12 wires to an AWG 14 and two AWG 12 wires.
Each wire shall be approximately 12 inches long. The wire insulation shall be
crosslinked polyolefin (TXL) and the conductor shall be bare copper. Shrink a 2.5-inch
length of FL2500-2 over the splice area using a forced air oven set at 150 ± 3°C
(302 ± 5 ° F) for 5 minutes. Allow the test assemblies to cool to room temperature and
immerse them, except for the ends, in a 5% salt solution for 24 hours at room
temperature. Apply 50 volts d-c to the immersed specimens and measure the leakage
current.
Thermal Cycling
Prepare 3 splice assemblies in accordance with Note 2 and subject them to 5 thermal
cycles. One cycle consists of 30 minutes in a 5% saline solution at 5 ± 5°C and 30
minutes at 130 ± 5°C with a maximum of 2 minutes between temperatures. Specimens
shall then be allowed to cool to room temperature for one hour minimum and shall be
measured for leakage current in accordance with Note 2.
Thermal Aging
Prepare 3 splice assemblies in accordance with Note 2 and hold for 168 hours at 130 ±
5°C. The specimens shall then be allowed to cool to room temperature for one hour
minimum and shall be measured for leakage current in accordance with Note 2.
Rev. Date:
July 14, 2006
Rev.:
G
Document No.
FL2500
Sheet:
2 of 3
@2005-2006 Tyco Electronics Corporation. All right reserved
If this document is printed it becomes uncontrolled. Check for the latest revision.
相关PDF资料 |
PDF描述 |
|---|---|
| 364002-D01 | CORD 3COND M/F EURO UNSHLD 2.5M |
| 3644B/100 100SF | CABLE 100 COND 50FT SHLD TWST PR |
| 3647B/36 300 | CABLE SHIELDED 28AWG 18PR 300' |
| 365003-D01 | CORD EURO C-13 H05VV-F 2.5M R/A |
| 3659/64 100SF | CABLE 64COND 50FT ROUND SHIELDED |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 363894-5 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| 3638C331MT | 功能描述:固定电感器 3638C 330UH 20% RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm |
| 3638C471MT | 功能描述:固定电感器 3638C 470UH 20% RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm |
| 3638F | 制造商:JT&T Products 功能描述: |
| 3638NF | 功能描述:拨动开关 SPDT 12A 28V 17.5mm RoHS:否 制造商:C&K Components 触点形式:DPDT 开关功能:ON - ON - ON 电流额定值: 电压额定值 AC:20 V 电压额定值 DC:20 V 功率额定值:0.4 VA 端接类型:V-Bracket 安装风格: 端子密封:Epoxy 触点电镀:Gold 照明:Not Illuminated |
发布紧急采购，3分钟左右您将得到回复。