- 您现在的位置：买卖IC网 > PDF目录30701 > 48SD6404RPFH (MAXWELL TECHNOLOGIES) 1500PF 100V 5% MONOLITH CERM CAP PDF资料下载
参数资料
| 型号： | 48SD6404RPFH |
| 厂商： | MAXWELL TECHNOLOGIES |
| 元件分类： | DRAM |
| 英文描述： | 1500PF 100V 5% MONOLITH CERM CAP |
| 中文描述： | 64M X 4 SYNCHRONOUS DRAM, 6 ns, DFP72 |
| 封装： | DFP-72 |
| 文件页数： | 3/42页 |
| 文件大小： | 596K |
| 代理商： | 48SD6404RPFH |
第1页第2页当前第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
48SD6404
M
em
o
ry
11
All data sheets are subject to change without notice
2005 Maxwell Technologies
All rights reserved.
256Mb (16-Meg X 4-Bit X 4-Banks) SDRAM
01.11.05 Rev 2
CKE Truth Table
Note: H:V
IH L:VIL x VIH or VIL
Clock suspend mode entry: The SDRAM enters clock suspend mode from active mode by setting CKE to
Low. If a command is input in the clock suspend mode entry cycle, the command is valid. The clock suspend
mode change depending on the current status (1 clock before) as described below.
ACTIVE clock suspend: This suspend mode ignores inputs after the next clock by internally maintaining
the bank active status.
READ suspend and READ with Auto-precharge suspend: The data being output is held ( and continues
to be output).
WRITE suspend and WRIT with Auto-precharge suspended: In this mode, external signals are not
accepted. However, the internal state is held.
Clock suspend: During clock suspend mode, keep the CKE to Low.
Clock suspend mode exit: The SDRAM exits from clock suspend mode by setting CKE to High during the
clock suspend state.
IDLE: In this state, all banks are not selected, and have completed precharge operation.
Auto-refresh command (REF): When this command is input from the IDLE state, the SDRAM starts auto-
refresh operation. (The auto-refresh is the same as the CBR refresh of conventional DRAMs.) During the
auto-refresh operation, refresh address and bank select address are generated inside the SDRAM. For
every auto-refresh cycle, the internal address counter is updated. Accordingly, 8192 cycles are required to
refresh the entire memory contents. Before executing the auto-refresh command, all the banks must be in
CURRENT STATE
COMMAND
N
-1
N
CS
RAS
CAS
WE
ADDRESS
Active
Clock suspended mode entry
H
L
x
Any
Clock Suspend
L
x
Clock Suspend
Clock Suspend mode exit
L
H
x
Idle
Auto-refresh command (REF)
H
L
H
x
Idle
Self-refresh entry (SELF)
H
L
H
x
Idle
Power down entry
HL
LH
H
x
H
L
HL
xxx
x
Self Refresh
Self Refresh exit (SELFX)
L
H
L
H
x
Power down
Power down exit
LH
H
x
L
H
xxx
x
相关PDF资料 |
PDF描述 |
|---|---|
| 48SD6404RPFI | 256 Mb SDRAM 16-Meg X 4-Bit X 4-Banks |
| 48SD6404RPFK | 256 Mb SDRAM 16-Meg X 4-Bit X 4-Banks |
| 48SD6404 | CAP 2.2UF 50V CERAMIC MONO 20% |
| 48TQFP | 48 PIN TQFP/TQN PACKAGE OUTLINE |
| 4900 | Dual Winding Surface Mount Inductors |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 48SD6404RPFI | 制造商:MAXWELL 制造商全称:Maxwell Technologies 功能描述:256 Mb SDRAM 16-Meg X 4-Bit X 4-Banks |
| 48SD6404RPFK | 制造商:MAXWELL 制造商全称:Maxwell Technologies 功能描述:256 Mb SDRAM 16-Meg X 4-Bit X 4-Banks |
| 48SFK0001 | 制造商:MADISON CABLE / TYC 功能描述: |
| 48SFKLF001 | 制造商:MADISON CABLE / TYC 功能描述: |
| 48SING-N5-25WH | 制造商:Edwards Signaling & Security Systems 功能描述:STDY_GRN_120AC |
发布紧急采购，3分钟左右您将得到回复。