- 您现在的位置：买卖IC网 > PDF目录67336 > 5962-9319302HXC (CRANE ELECTRONICS INC) 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | 5962-9319302HXC |
| 厂商： | CRANE ELECTRONICS INC |
| 元件分类： | 电源模块 |
| 英文描述： | 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | HERMETIC SEALED PACKAGE-12 |
| 文件页数： | 1/13页 |
| 文件大小： | 576K |
| 代理商： | 5962-9319302HXC |
description
The SMFL Series 28-volt DC/DC converters are rated up to 65
watts output power over a -55° to +125°C temperature range with
a 28 Vdc nominal input. On dual output models up to 70% of the
rated output power can be drawn from either the positive or negative
outputs. Current sharing allows the units to be paralleled for total
power of up to 148 watts. The welded, hermetically sealed package
is only 3.0 x 1.5 x 0.40 inches, giving the series an overall power
density of up to 43 watts per cubic inch.
Screening
SMFL converters offer the following screening options: Space
Prototype (O), Class H, or Class K. Radiation tolerant to Radiation
Hardness Assurance (RHA) levels of “-” (O) or “R”, per MIL-STD-
38534. Interpoint model numbers use an “O” in the RHA designator
position to indicate the “-” (dash) Radiation Hardness Assurance
level of MIL-PRF-38534, which is defined as “no RHA”. See “Class H
and K, MIL-PRF-38534 Screening” tables for more information.
DeSign FeatureS
SMFL Series converters are switching regulators that use a quasi-
square wave, single ended forward converter design with a constant
switching frequency of 600 kHz typical.
Isolation between input and output circuits is provided with a trans-
former in the forward path and a wide bandwidth magnetic coupling
in the feedback control loop. The SMFL uses a unique dual loop
feedback technique that controls output current with an inner feed-
back loop and an output voltage with a cascaded voltage mode
feedback loop. The additional secondary current mode feedback loop
improves transient response in a manner similar to primary current
mode control and allows for ease of paralleling, but without the cost
and complexity.
The constant frequency, pulse-width modulated converters use a
quasi-square wave single-ended forward design. Tight load regula-
tion is achieved through a wide-bandwidth magnetic feedback circuit.
The output voltage on single SMFL models can be trimmed to a
specific output voltage by adding an external resistor (see Figure 1
for resistor values).
inhibit
The SMFL Series converters have two inhibit terminals (INH1 and
INH2) that can be used to disable power conversion, resulting in
a very low quiescent input current and no generation of switching
noise. A logic low (<0.8 volts) is required to inhibit the converter
between INH1 (pin 4) and Input Common (pin 2). A logic low (<0.5
volts) is required to inhibit the converter between INH2 (pin 12) and
Output Common (pin 8). The application of intermediate voltages to
these pins (1.5 to 10.5 volts) should be avoided.
Sync
Converters may be synced to an external clock (525 to 675 kHz) or
to one another by using the sync in or out pins. The nominal free-run
switching frequency is 600 kHz (see Application Note titled “Inhibit
and Synchronization”).
current anD Parallel OPeratiOn
Multiple single output SMFL converters may be used in parallel to
drive a common load. In this mode of operation the load current is
shared by two or three SMFL converters. In current sharing mode,
one SMFL converter is designated as a master. The SLAVE pin (pin
11) of the master is left unconnected and the MSTR/INH2 pin (pin
12) of the master is connected to the SLAVE pin (pin 11) of the slave
units. The units designated as slaves have the MSTR/INH2 pin (pin
12) connected to the SNS RTN pin (pin 9). Note that synchronizing
the units together is not required for current sharing operation. A
second slave unit may be placed in parallel with a master and slave;
this requires the TRI pin (pin 3) of the master unit to be connected to
the SNS RTN pin (pin 9). See Figure 2 for a block diagram of parallel
connections.
When paralleled, 76% of the total combined power ratings of the
SMFL converters are available at the load. Overload and short circuit
performance are not adversely affected during parallel operation.
Features
FullyqualifiedtoClassHorK
-55°to+125°Coperation
16to40VDCinput
FullyIsolated
Magneticfeedback
Fixedfrequency,600kHztypical
Topology–SingleEndedForward
50Vforupto120mstransientprotection
Inhibitinputsideandoutputside
Syncfunction
Outputtrimonsingleoutputmodels
Indefiniteshortcircuitprotection
Remotesenseonsingleoutputmodels
Upto85%efficiency/43W/in3
Parallelableupto148watts
MODELS
VDC Output
SINgLE
3.3
5
12
15
DUal
±5
±12
±15
ClearedbyU.S.DoDOSRforPublicRelease
OSR case number 09S-0995, dated March 13, 2009.
Crane Aerospace & Electronics Power Solutions
sMFL single and dual dc/dc converters
Crane Aerospace & Electronics
Electronics group (Interpoint Brand)
POBox97005RedmondWa98073-9705
425.882.3100electronics@craneae.com
www.craneae.com
Page 1 of 13
Rev H - 20071102
28 VoLt input – 65 Watt
相关PDF资料 |
PDF描述 |
|---|---|
| 5962-9316302HXC | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| 5962-9316102HXC | 1-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| 5962-9316301HXC | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
| 5962-9316201HXC | 1-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
| 5962-0621301HXC | 1-OUTPUT 40 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 5962-9319801HXA | 功能描述:模数转换器 - ADC Analog to Digital Converter RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| 5962-9319801HXC | 功能描述:模数转换器 - ADC Analog to Digital Converter RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| 5962-9319803HXA | 功能描述:模数转换器 - ADC Analog to Digital Converter RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| 5962-9319803HXC | 功能描述:模数转换器 - ADC Analog to Digital Converter RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32 |
| 59629319901MXA | 制造商:TI 功能描述:SNJ54ABT16240WD |
发布紧急采购，3分钟左右您将得到回复。