STANDARD
MICROCIRCUIT DRAWING
SIZE
A
5962-98639
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43216-5000
REVISION LEVEL
A
SHEET
3
DSCC FORM 2234
APR 97
1.3 Absolute maximum ratings. 1/
Supply voltage (VS)................................................................................................
±22.0 V dc
Input voltage (VIN)..................................................................................................
±22.0 V dc 2/
Differential input voltage ........................................................................................
±30 V dc
Internal power dissipation (PD) .............................................................................. 500 mW
Output short circuit duration.................................................................................. Indefinite
Lead temperature (soldering, 10 seconds)........................................................... +300
°C
Junction temperature (TJ) ..................................................................................... +150
°C
Storage temperature range ................................................................................... -65
°C to +150°C
Thermal resistance, junction-to-case (
θJC)............................................................See MIL-STD-1835
Thermal resistance, junction-to-ambient (
θJA):
Cases G and H .................................................................................................. +150
°C/W
Case P ............................................................................................................... +119
°C/W
Case 2................................................................................................................ +110
°C/W
1.4 Recommended operating conditions.
Supply voltage range (VS) .....................................................................................
±4.5 V dc to ±20 V dc
Ambient operating temperature range (TA)........................................................... -55
°C to +125°C
1.5 Radiation features.
Maximum total dose available (dose rate = 50 – 300 rads (Si)/s)......................... 100 krads
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part of
this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed in the issue
of the Department of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation.
SPECIFICATION
DEPARTMENT OF DEFENSE
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-883
-
Test Method Standard Microcircuits.
MIL-STD-973
-
Configuration Management.
MIL-STD-1835 -
Interface Standard For Microcircuit Case Outlines.
HANDBOOKS
DEPARTMENT OF DEFENSE
MIL-HDBK-103 -
List of Standard Microcircuit Drawings (SMD's).
MIL-HDBK-780 -
Standard Microcircuit Drawings.
(Unless otherwise indicated, copies of the specification, standards, and handbooks are available from the Standardization
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
1/
Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/
For supply voltage less than
±22 V, the absolute maximum input voltage is equal to the supply voltage.