参数资料
| 型号： | 724 |
| 厂商： | 3M |
| 文件页数： | 11/28页 |
| 文件大小： | 0K |
| 描述： | WORKSTATION MONITOR KIT W/HDWR |
| 标准包装： | 1 |
| 类型： | 工作站监视器 |
| 使用： | 工作面，腕带（2）监视 |
| 特点： | 连续监视，双芯系统 |
| 电源类型： | AC 适配器 |
| 包括： | 监视器 软线，接地线，双缆芯遥控输入插孔，AC 适配器，说明书，安装螺钉（4），双线连接器 |
| 相关产品： | SCP245-ND - CORD COIL DL R/A 3.4MM PLUG 20' SCP244-ND - CORD COIL DL R/A 3.4MM PLUG 10' SCP243-ND - CORD COIL DUAL R/A 3.4MM PLUG 5' SCP242-ND - CORD COIL DUAL COND GND R/A 20' SCP241-ND - CORD COIL DUAL COND GND R/A 10' SCP240-ND - CORD COILED DUAL COND GND R/A 5' SCP305-ND - KIT VERIFICATION SCP246-ND - CORD COILED DUAL COND GND 20' SCP329-ND - KIT REMOTE SPLITTER SCP234-ND - COILED CORD DUAL COND GND 10' 更多... |
| 其它名称： | 98-0798-3713-8 98-0798-3713-8-ND 98079837138 SCP226 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
19
SECTION 10
Installation of 3M Dual Conductor Remote Input Jack Model 733
a) Insert the plug connector of the Dual
Conductor Remote Input Jack Model
733 cable into the Model 733 jack
at the rear of the 3M Workstation
Monitor Model 724 (Figure 14).
b) Fully insert the small plastic plug
that comes with the kit into the
#2 wrist strap input on the Dual
Conductor Remote Input Jack Model
732. This disables the #2 input and
prevents a situation where two users
would simultaneously attempt to use
the input lines to the Workstation
Monitor Model 724.
c) Position and mount both remote input jacks in convenient locations.
SECTION 11
Verification Procedure for the Workstation Monitor Model 724
The Workstation Monitor Model 724 cannot be recalibrated after the initial
factory calibration. However, the following steps can be used to determine if the
Workstation Monitor Model 724 is operating within its specifications.
Equipment Needed:
Small blade screwdriver.
Resistance Substitution Box (RSB), 1 Ohm to 45 Megohms ±1%.
One two-conductor cable with standard 3.5 mm (miniature) phone plug
attached on one end and appropriate connectors on the other end to
connect to RSB.
Note: Two-conductor cable must have an isolation resistance of >1 Gigohm
between conductors. Two separated wires may also be used to obtain higherisolation resistance.
Two wires with alligator clips.
Ohmmeter capable of measuring to 45 Megohms ±0.5%, to verify the RSB.
Figure 14 – Inserting 3M Dual Conductor
Remote Input Jack Model 733 plug into rear of
3M Workstation Monitor Model 724
相关PDF资料 |
PDF描述 |
|---|---|
| 725 | MONITOR WRIST STRAP DUAL COND |
| 73859 | JACKET W/CUFFS TEAL 6XLARGE |
| 741 | FOOTPLATE FOR 740 TESTER |
| 746 CERTIFIED | WRIST STRAP TESTER AC CERTIFIED |
| 749 | PEDESTAL STAND FOR 3M TESTERS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 72-4 | 功能描述:电池座、电池扣和电池接头 T-9V-SNAP-4" RoHS:否 制造商:Eagle Plastic Devices 产品:Battery Snaps 电池组电池大小:9 V 电池数量:1 端接类型:Snaps 颜色:Black 材料:Polyvinyl Chloride (PVC) 安装风格:Snap-In |
| 7-2-4 SCREENED | 制造商:Farnell / Pro-Power 功能描述:CABLE DEF 7-2-4C 4CORE 500M 制造商:pro-power 功能描述:CABLE, DEF 7-2-4C, 4CORE, 500M |
| 7-2-4 SCREENED | 制造商:Farnell / Pro-Power 功能描述:CABLE DEF 7-2-4C 4 CORE 500M |
| 724 | 制造商:3M Electronic Products Division 功能描述:Static protection 制造商:CML Innovative Technologies 功能描述:LAMP MID.FLANGE T1.3/4 6V 1.2W |
| 724 | 制造商:SLI EBT 功能描述:LAMP T1.3/4 MID.FLANGE 6V 1.2W |
发布紧急采购，3分钟左右您将得到回复。