参数资料
型号: 73S1210F-44IMR/F/P
厂商: Maxim Integrated Products
文件页数: 113/126页
文件大小: 0K
描述: IC SMART CARD READER PROG 44-QFN
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 2,500
系列: 73S12xx
核心处理器: 80515
芯体尺寸: 8-位
速度: 24MHz
连通性: I²C,智能卡,UART/USART
外围设备: LED,POR,WDT
输入/输出数: 8
程序存储器容量: 32KB(32K x 8)
程序存储器类型: 闪存
RAM 容量: 2K x 8
电压 - 电源 (Vcc/Vdd): 2.7 V ~ 6.5 V
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 44-VFQFN 裸露焊盘
包装: 带卷 (TR)
DS_1210F_001
73S1210F Data Sheet
Rev. 1.4
87
STX Data Register (STXData): 0xFE07
0x00
Table 79: The STXData Register
MSB
LSB
STXDAT.7
STXDAT.6
STXDAT.5 STXDAT.4 STXDAT.3
STXDAT.2
STXDAT.1
STXDAT.0
Bit
Function
STXData.7
Data to be transmitted to smart card. Gets stored in the TX FIFO and then extracted by
the hardware and sent to the selected smart card. When the MPU reads this register,
the byte pointer is changed to effectively “read out” the data. Thus, two reads will
always result in an “empty” FIFO condition. The contents of the FIFO registers are not
cleared, but will be overwritten by writes.
STXData.6
STXData.5
STXData.4
STXData.3
STXData.2
STXData.1
STXData.0
SRX Control/Status Register (SRXCtl): 0xFE08
0x00
This register is used to monitor reception of data from the smart card.
Table 80: The SRXCtl Register
MSB
LSB
BIT9DAT
LASTRX
CRCERR
RXFULL
RXEMTY RXOVRR
PARITYE
Bit
Symbol
Function
SRXCtl.7
BIT9DAT
Bit 9 Data - When in sync mode and with MODE9/8B set, this bit will contain
the data on IO (or SIO) pin that was sampled on the ninth CLK (or SCLK)
rising edge. This is used to read data in synchronous 9-bit formats.
SRXCtl.6
SRXCtl.5
LASTRX
Last RX Byte - User sets this bit during the reception of the last byte. When
byte is received and this bit is set, logic checks CRC to match 0x1D0F (T=1
mode) or LRC to match 00h (T=1 mode), otherwise a CRC or LRC error is
asserted.
SRXCtl.4
CRCERR
(Read only) 1 = CRC (or LRC) error has been detected.
SRXCtl.3
RXFULL
(Read only) RX FIFO is full. Status bit to indicate RX FIFO is full.
SRXCtl.2
RXEMTY
(Read only) RX FIFO is empty. This is only a status bit and does not generate
an RX interrupt.
SRXCtl.1
RXOVRR
RX Overrun - (Read Only) Asserted when a receive-over-run condition has
occurred. An over-run is defined as a byte was received from the smart card
when the RX FIFO was full. Invalid data may be in the receive FIFO.
Firmware should take appropriate action. Cleared when read. Additional
writes to the RX FIFO are discarded when a RXOVRR occurs until the overrun
condition is cleared. Will generate an RXERR interrupt.
SRXCtl.0
PARITYE
Parity Error - (Read only) 1 = The logic detected a parity error on incoming
data from the smart card. Cleared when read. Will generate an RXERR
interrupt.
相关PDF资料
PDF描述
MAXQ613E-0000+ IC MCU 16BIT IR MOD 32LQPF
73S1210F-44IM/F/P IC SMART CARD READER PROG 44-QFN
73S1209F-68IM/F/P IC SMART CARD READER PROG 68-QFN
73S1209F-44IMR/F/P IC SMART CARD READER PROG 44-QFN
73S1209F-44IM/F/P IC SMART CARD READER PROG 44-QFN
相关代理商/技术参数
参数描述
73S1210F-44M/F/PC 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
73S1210F-44M/F/PD 制造商:Maxim Integrated Products 功能描述:SCR+PIN PAD/SRL INTRFC/PWR MGT-PROG - Rail/Tube
73S1210F-44MR/F/PC 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
73S1210F-68IM/F 功能描述:8位微控制器 -MCU SoC Smart Card Readr w/PINpad & PWR Mgt RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
73S1210F-68IM/F/P 功能描述:IC SMART CARD READER PROG 68-QFN RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:73S12xx 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:260 系列:73S12xx 核心处理器:80515 芯体尺寸:8-位 速度:24MHz 连通性:I²C,智能卡,UART/USART,USB 外围设备:LED,POR,WDT 输入/输出数:9 程序存储器容量:64KB(64K x 8) 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:2K x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:68-VFQFN 裸露焊盘 包装:管件