- 您现在的位置：买卖IC网 > PDF目录20635 > 78M6631-IM/F (Maxim Integrated)IC POWER MEAS/MON 3 PHASE 56TQFN PDF资料下载
参数资料
| 型号： | 78M6631-IM/F |
| 厂商： | Maxim Integrated |
| 文件页数： | 7/30页 |
| 文件大小： | 0K |
| 描述： | IC POWER MEAS/MON 3 PHASE 56TQFN |
| 产品培训模块： | Obsolescence Mitigation Program |
| 标准包装： | 260 |
| 系列： | Teridian™ |
| 输入阻抗： | 40 千欧 ~ 90 千欧 |
| 测量误差： | 0.5% |
| 电压 - 高输入/输出： | 2V |
| 电压 - 低输入/输出： | 0.8V |
| 电源电压： | 3 V ~ 3.6 V |
| 测量仪表类型： | 3 相 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 56-WFQFN 裸露焊盘 |
| 供应商设备封装： | 56-TQFN-EP（7x7） |
| 包装： | 散装 |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
DS_6631_056
78M6631 Data Sheet
1.2
Device Reset
When the RESET pin is pulled high, all digital activity stops. Only the oscillator and RTC module continue
to run. Additionally, all IORAM bits are set to their default states. As long as V1 (the input voltage at the
power fault block) is greater than VBIAS, the internal 2.5 V regulator continues to provide power to the
digital section.
Once initiated, the reset mode persists until the reset timer times out. This occurs in 4096 cycles of the
crystal clock after RESET goes low, at which time the MPU begins executing its preboot and boot
sequences from address 0x0000.
1.3
Power Management
1.3.1 Voltage Regulator
The 78M6631 provides an on-chip voltage regulator to create a 2.5 V supply for the digital logic. This
regulator can be run off of the V3P3SYS or VBAT inputs depending upon power availability.
1.3.2 Power Fault Management
The 78M6631 provides for both hardware and software controlled power fault management. The V1 pin is
connected to a comparator to monitor system power fault conditions. When the input to the comparator
falls (V1 < VBIAS) the device can enter a BROWNOUT mode, if supported in firmware and there is
sufficient voltage on VBAT, that reduces the MPU rate to 32 kHz and disables all the measurement front-
end circuits. If the overhead on VBAT is insufficient to maintain a BROWNOUT mode, then the device can
also attempt to enter a SLEEP mode where only RTC functions are active.
If there is not sufficient voltage on VBAT (or it is not supported), then the part enters RESET mode when
the comparator fails.
Rev 2
7
相关PDF资料 |
PDF描述 |
|---|---|
| 572D336X0010A2T | CAP TANT 33UF 10V 20% 1206 |
| R1D12-1224/P | CONV DC/DC 1W 12VIN +/-24VOUT |
| 572D226X9016A2T | CAP TANT 22UF 16V 10% 1206 |
| MBR3060PT | DIODE SCHOTTKY 30A 60V TO-247 AD |
| R1D12-053.3/P | CONV DC/DC 1W 05VIN +/-3.3VOUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 78M6631-IMR/F | 功能描述:计量片上系统 - SoC 3-Phase Power Measure/Mtr SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel |
| 78M6631-IMR/F/P48 | 制造商:Maxim Integrated Products 功能描述:3 PHASE ENERGY MEAS SOC (4800 BAUD) - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC ENERGY MEAS 3PHASE SOC 56TQFN 制造商:Maxim Integrated Products 功能描述:Prog One-Shot Pulse Generator |
| 78MKV-102 | 功能描述:精度电位计 WOONSOCKET POSITION RoHS:否 制造商:Bourns 产品:Precision Potentiometer 安装风格:Panel 线性: 锥度: 转数:3 元件类型:Wirewound 轴类型:Slotted 电阻:2 kOhms 端接类型:Solder Lug 电压额定值: 容差:5 % |
| 78MKV-103 | 功能描述:精度电位计 WOONSOCKET POSITION RoHS:否 制造商:Bourns 产品:Precision Potentiometer 安装风格:Panel 线性: 锥度: 转数:3 元件类型:Wirewound 轴类型:Slotted 电阻:2 kOhms 端接类型:Solder Lug 电压额定值: 容差:5 % |
| 78MKV-110 | 功能描述:精度电位计 WOONSOCKET POSITION RoHS:否 制造商:Bourns 产品:Precision Potentiometer 安装风格:Panel 线性: 锥度: 转数:3 元件类型:Wirewound 轴类型:Slotted 电阻:2 kOhms 端接类型:Solder Lug 电压额定值: 容差:5 % |
发布紧急采购，3分钟左右您将得到回复。