参数资料
| 型号： | 79201 |
| 厂商： | Desco |
| 文件页数： | 5/6页 |
| 文件大小： | 0K |
| 描述： | TAPE CLEAR ANTISTATIC 3/4"X36YDS |
| MSDS 材料安全数据表： | Westcorp Cellulose Tape MSDS |
| 标准包装： | 1 |
| 胶带类型： | 抗静电 |
| 胶合剂： | 橡胶 |
| 背衬，载体： | 纤维素 |
| 厚度： | 0.0024"（2.4 mils，0.061mm） |
| 宽： | 0.75"（19.05mm）3/4" |
| 长度： | 108'（32.9m）36 码 |
| 颜色： | 透明 |
| 使用： | 包装 |
| 温度范围： | 14 ~ 160°F（-10 ~ 71°C） |
0
Material Safety Data Sheet
May be used to comply with
OSHA’s Hazard Communication Standard,
29 CFR 1910.1200, Standard must be
consulted for specific requirements.
NFPA Designation 704
Degree of Hazard:
4 = Extreme 1 = Slight
3 = High 0 = Insignificant
2 = Moderate Special Hazard
Health
(Blue)
0
0
Flammability
(Red)
0
Reactivity
(Yellow)
IDENTITY (As Used on Label and List)
Wescorp ESD Hi Temp Polyimide Tape
SECTION I
Manufacturer’s Name
Desco Industries Inc.
Address (Number, Street, City, State, and Zip Code)
3651 Walnut Avenue, Chino, CA 91710
Date Prepared
Note: Blank spaces are not permitted. If any item it not applicable, or no
information is available,the space must be marked to indicate that.
Emergency Telephone Number
(909) 627-8178
Telephone Number for Information
(909) 627-8178
Signature of Preparer (Optional)
12-6-2011
SECTION II - PHYSICAL/CHEMICAL CHARACTERISTICS
Polyimide Film
Electrically conductive particles embedded in a layer of polysiloxane adhesive
SECTION III - HAZARDOUS INGREDIENTS
No hazardous materials present
(1) According to Commission Directive 88/379/EEC (Article 3 6aa).
SECTION IV - FIRST AID MEASURES
4.1. Skin: No irritation is expected from handling the tape, however ensure good industrial hygiene and wash exposed areas with soap
and Water.
4.2. Eyes: Rinse opened eye for several minutes under running water.
4.3. Inhalation: Not a probable route of exposure for adhesive tape. Exposure to the encapsulated electrically conductive articles in the
adhesive layer is not likely.
4.4. Ingestion: Not a probable route of exposure for adhesive for adhesive tape. Treat symptomatically.
4.5. Other first aid information: Not known
SECTION V - FIRE EXTINGUISHING MEASURES
5.1. Extinguishing media: Carbon dioxide, foam, dry powder, or fine water spray.
5.2. Unsuitable extinguishing media: None known
5.3. Unusual firefighting hazards: None known
5.4. Special firefighting procedures: Self-contained respirator should be worn.
5.5. Other recommendations: None known
5.6. Combustion products: Polyimide film chars but does not burn in air, however it will burn in an atmosphere of 100% oxygen. The major
off-gases are carbon dioxide and carbon monoxide. The silicone adhesive layer also tends to char leaving residues of silica and off-gases
containing carbon dioxide, traces of incompletely burned carbon products and formaldehyde.
SECTION VI - ACCIDENTAL RELEASE MEASURE
6.1. Personal protection: Avoid contact with eyes.
6.2. Precautions to protect the environment: None established
6.3. Clean up procedure: Pick up to prevent floor
SECTION VII - HANDLING AND STORAGE
7.1. Handling precautions: Avoid contact with eyes. Ensure good industrial hygiene and wash skin with soap and water after contact.
7.2. Storage: No special measures are required.
7.3. Unsuitable packaging materials : None known.
7.4. Incompatibilities: None known.
7.5. Other information: None known.
SECTION VIII - EXPOSURE CONTROLS AND PERSONAL PROTECTION
8.1 Exposure controls: Safe handling/usage of Wescorp ESD Hi Temp Polymide Tape at high temperatures (above 200°C/392°F) requires
adequate ventilation. Using small quantities normal air circulation may be adequate otherwise further ventilation measures are recommended.
8.2. Exposure controls for hazardous components: No hazardous materials present
8.3. Personal protective equipment:
Respiratory: Not required for normal handling.
Protective gloves: Not required for normal handling, if tape is hot gloves are recommended as good industrial practice.
Eye/Face: Safety glasses are recommended as good industrial practice.
Industrial Hygiene: Wash after handling, especially before eating, drinking or smoking. Exercise good industrial hygiene practice.
DESCO INDUSTRIES INC. ? 3651 Walnut Avenue, Chino, CA 91710 ? (909) 627-8178 ? Web Site: DescoIndustries.com
TB-3010 Page 5 of 6
? 2012 DESCO INDUSTRIES INC.
Employee Owned
相关PDF资料 |
PDF描述 |
|---|---|
| 350689-1 | CONN SOCKET 18-24AWG TIN CRIMP |
| 81261 | TAPE MASKING HI TEMP 3/4"X60YDS |
| 325020-08-0 | TERM BARRIER 8CIRC SGL ROW .325 |
| 81250 | TAPE SHIELDING.GRID 118FT 1/2" |
| 81260 | TAPE MASKING HI TEMP 60YDS 1/2" |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 79201 SL001 | 功能描述:多芯电缆 20AWG 2C SHIELDED 1000FT SPOOL SLATE RoHS:否 制造商:Alpha Wire 导体数量:3 线规 - 美国线规（AWG）:16 绞合:19 x 29 屏蔽:Shielded 长度:100 ft 电压额定值:600 V 外壳材料:Polytetrafluoroethylene (PTFE) 绝缘材料:Polytetrafluoroethylene (PTFE) 类型:Communication and Control |
| 79201 SL005 | 功能描述:多芯电缆 20AWG 2C SHIELDED 100FT SPOOL SLATE RoHS:否 制造商:Alpha Wire 导体数量:3 线规 - 美国线规（AWG）:16 绞合:19 x 29 屏蔽:Shielded 长度:100 ft 电压额定值:600 V 外壳材料:Polytetrafluoroethylene (PTFE) 绝缘材料:Polytetrafluoroethylene (PTFE) 类型:Communication and Control |
| 7920100000 | 功能描述:JUMPER 16MM 138A 2POS RoHS:是 类别:连接器，互连式 >> 接线座 - 配件 - 跳线 系列:ZQV 标准包装:10 系列:- 类型:接线板 － 交叉连接 位置数:4 样式:- 适用于相关产品:接线座 其它名称:FBSTB 4-6 |
| 79201-10120-6EC | 制造商:3M Electronic Products Division 功能描述: |
| 79201-102 | 制造商:FCI 功能描述:BRGSTK II R/A 30au 2X1 |
发布紧急采购，3分钟左右您将得到回复。