参数资料
| 型号： | 81260 |
| 厂商： | Desco |
| 文件页数： | 5/6页 |
| 文件大小： | 0K |
| 描述： | TAPE MASKING HI TEMP 60YDS 1/2" |
| MSDS 材料安全数据表： | Westcorp Hi-Temp Masking Tape MSDS |
| 标准包装： | 1 |
| 胶带类型： | 屏蔽，高温 |
| 胶合剂： | 橡胶 |
| 背衬，载体： | 绉纸 |
| 厚度： | 0.0070"（7.0 mils，0.178mm） |
| 宽： | 0.50"（12.70mm）1/2" |
| 长度： | 180'（55.0m）60 码 |
| 颜色： | 自然色 |
| 使用： | 波动焊接 |
| 温度范围： | -32 ~ 275°F（-35 ~ 135°C） |
| 其它名称： | WAMT-1/2 |
0
Material Safety Data Sheet
May be used to comply with
OSHA’s Hazard Communication Standard,
29 CFR 1910.1200, Standard must be
consulted for specific requirements.
NFPA Designation 704
Degree of Hazard:
4 = Extreme 1 = Slight
3 = High 0 = Insignificant
2 = Moderate Special Hazard
Health
(Blue)
0
0
Flammability
(Red)
0
Reactivity
(Yellow)
IDENTITY (As Used on Label and List)
Wescorp ESD Hi Temp Polyimide Tape
SECTION I
Manufacturer’s Name
Desco Industries Inc.
Address (Number, Street, City, State, and Zip Code)
3651 Walnut Avenue, Chino, CA 91710
Date Prepared
Note: Blank spaces are not permitted. If any item it not applicable, or no
information is available,the space must be marked to indicate that.
Emergency Telephone Number
(909) 627-8178
Telephone Number for Information
(909) 627-8178
Signature of Preparer (Optional)
12-6-2011
SECTION II - PHYSICAL/CHEMICAL CHARACTERISTICS
Polyimide Film
Electrically conductive particles embedded in a layer of polysiloxane adhesive
SECTION III - HAZARDOUS INGREDIENTS
No hazardous materials present
(1) According to Commission Directive 88/379/EEC (Article 3 6aa).
SECTION IV - FIRST AID MEASURES
4.1. Skin: No irritation is expected from handling the tape, however ensure good industrial hygiene and wash exposed areas with soap
and Water.
4.2. Eyes: Rinse opened eye for several minutes under running water.
4.3. Inhalation: Not a probable route of exposure for adhesive tape. Exposure to the encapsulated electrically conductive articles in the
adhesive layer is not likely.
4.4. Ingestion: Not a probable route of exposure for adhesive for adhesive tape. Treat symptomatically.
4.5. Other first aid information: Not known
SECTION V - FIRE EXTINGUISHING MEASURES
5.1. Extinguishing media: Carbon dioxide, foam, dry powder, or fine water spray.
5.2. Unsuitable extinguishing media: None known
5.3. Unusual firefighting hazards: None known
5.4. Special firefighting procedures: Self-contained respirator should be worn.
5.5. Other recommendations: None known
5.6. Combustion products: Polyimide film chars but does not burn in air, however it will burn in an atmosphere of 100% oxygen. The major
off-gases are carbon dioxide and carbon monoxide. The silicone adhesive layer also tends to char leaving residues of silica and off-gases
containing carbon dioxide, traces of incompletely burned carbon products and formaldehyde.
SECTION VI - ACCIDENTAL RELEASE MEASURE
6.1. Personal protection: Avoid contact with eyes.
6.2. Precautions to protect the environment: None established
6.3. Clean up procedure: Pick up to prevent floor
SECTION VII - HANDLING AND STORAGE
7.1. Handling precautions: Avoid contact with eyes. Ensure good industrial hygiene and wash skin with soap and water after contact.
7.2. Storage: No special measures are required.
7.3. Unsuitable packaging materials : None known.
7.4. Incompatibilities: None known.
7.5. Other information: None known.
SECTION VIII - EXPOSURE CONTROLS AND PERSONAL PROTECTION
8.1 Exposure controls: Safe handling/usage of Wescorp ESD Hi Temp Polymide Tape at high temperatures (above 200°C/392°F) requires
adequate ventilation. Using small quantities normal air circulation may be adequate otherwise further ventilation measures are recommended.
8.2. Exposure controls for hazardous components: No hazardous materials present
8.3. Personal protective equipment:
Respiratory: Not required for normal handling.
Protective gloves: Not required for normal handling, if tape is hot gloves are recommended as good industrial practice.
Eye/Face: Safety glasses are recommended as good industrial practice.
Industrial Hygiene: Wash after handling, especially before eating, drinking or smoking. Exercise good industrial hygiene practice.
DESCO INDUSTRIES INC. ? 3651 Walnut Avenue, Chino, CA 91710 ? (909) 627-8178 ? Web Site: DescoIndustries.com
TB-3010 Page 5 of 6
? 2012 DESCO INDUSTRIES INC.
Employee Owned
相关PDF资料 |
PDF描述 |
|---|---|
| OSTYK60305130 | CONN BARRIER STRIP 5CIRC 10MM |
| 79200 | TAPE CLEAR ANTISTATIC 1/2"X36YDS |
| 1-175194-5 | CONN RCPT 24-28AWG CRIMP TIN |
| 3M1093-12X36YD | TAPE POLYIMIDE HI-TEMP 12X36YD |
| OSTYK41508330 | CONN BARRIER STRIP 8CIRC 8.25MM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 812600-1 | 制造商:TE Connectivity 功能描述:FRAME-MACHINING T TERM UNIT - Bulk |
| 812-6022-134 | 制造商:Amphenol Corporation 功能描述: |
| 81261 | 功能描述:TAPE MASKING HI TEMP 3/4"X60YDS RoHS:是 类别:胶带，粘合剂 >> 带 系列:- 标准包装:1 系列:- 胶带类型:标记 - 印有“无铅区域”字样 胶合剂:- 背衬，载体:- 厚度:- 厚度 - 胶合剂:- 厚度 - 背胶，载体，衬垫:- 宽:1.00"（25.40mm） 长度:360'（109.7m）120 码 颜色:白色字符，绿色背景 使用:标记 温度范围:- 包装:卷 |
| 8126152001 | 制造商:TE Connectivity 功能描述:Heat Shrink Tubing ST Fluoropolymer Black Thin Stick 制造商:TE Connectivity 功能描述:HEAT SHRNK TBING FLUOROPOLYMER BLCK STK - Shrink Tubing that comes in 4ft sticks 制造商:TE Connectivity 功能描述:HEAT SHRINK TUBING 1=1FT 制造商:TE Connectivity 功能描述:HEAT SHRINK TUBING 1=1000FT 制造商:TE Connectivity 功能描述:MT1000-3/8-0-STK |
| 812619-2 | 制造商:TE Connectivity 功能描述:MOUNT, PIVOT BAR (C/S CYL.) - Bulk |
发布紧急采购，3分钟左右您将得到回复。