参数资料
型号: 935287981518
厂商: NXP SEMICONDUCTORS
元件分类: 网络接口
英文描述: DATACOM, INTERFACE CIRCUIT, PDSO14
封装: 3.90 MM, PLASTIC, MS-012, SOT108-1, SOP-14
文件页数: 1/28页
文件大小: 281K
代理商: 935287981518
1.
General description
The TJA1054 is the interface between the protocol controller and the physical bus wires in
a Controller Area Network (CAN). It is primarily intended for low-speed applications up to
125 kBd in passenger cars. The device provides differential receive and transmit
capability but will switch to single-wire transmitter and/or receiver in error conditions.
The TJA1054T is pin and downwards compatible with the PCA82C252T and the
TJA1053T. This means that these two devices can be replaced by the TJA1054T with
retention of all functions.
The most important improvements of the TJA1054 with respect to the PCA82C252 and
TJA1053 are:
Very low EME due to a very good matching of the CANL and CANH output signals
Good EMI, especially in low power modes
Full wake-up capability during bus failures
Extended bus failure management including short-circuit of the CANH bus line to VCC
Support for easy system fault diagnosis
Two-edge sensitive wake-up input signal via pin WAKE
2.
Features
2.1 Optimized for in-car low-speed communication
I Baud rate up to 125 kBd
I Up to 32 nodes can be connected
I Supports unshielded bus wires
I Very low ElectroMagnetic Emission (EME) due to built-in slope control function and a
very good matching of the CANL and CANH bus outputs
I Very high ElectroMagnetic Immunity (EMI) in normal and low power operating modes
I Fully integrated receiver lters
I Transmit Data (TxD) dominant time-out function
2.2 Bus failure management
I Supports single-wire transmission modes with ground offset voltages up to 1.5 V
I Automatic switching to single-wire mode in the event of bus failures, even when the
CANH bus wire is short-circuited to VCC
I Automatic reset to differential mode if bus failure is removed
I Full wake-up capability during failure modes
TJA1054
Fault-tolerant CAN transceiver
Rev. 04 — 24 September 2009
Product data sheet
相关PDF资料
PDF描述
07488-01100 EINPRESSMUTTERN KIT
07488-09470 M3 EINSAETZE
07488-09500 M6 EINSAETZE
935261652118 SPECIALTY MICROPROCESSOR CIRCUIT, PDSO28
935261633118 SPECIALTY MICROPROCESSOR CIRCUIT, PDSO28
相关代理商/技术参数
参数描述
935288287551 制造商:NXP Semiconductors 功能描述:- Trays
935288287557 制造商:NXP Semiconductors 功能描述:- Trays
935288465027 制造商:NXP Semiconductors 功能描述:IC SMARTCARD RTC OSC COUNTER
935288948115 制造商:NXP Semiconductors 功能描述:IC ANALOG SWITCH SP3T 10XQFN
935288949115 制造商:NXP Semiconductors 功能描述:IC ANALOG SWITCH SPDT 10XQFN