- 您现在的位置：买卖IC网 > PDF目录375159 > A82DL1642UG-70F (AMIC Technology Corporation) Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash PDF资料下载
参数资料
| 型号： | A82DL1642UG-70F |
| 厂商： | AMIC Technology Corporation |
| 英文描述： | Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| 中文描述： | 堆叠式多芯片封装（MCP）闪存和SRAM，A82DL16x2T（ü）16兆位（2Mx8 Bit/1Mx16位）的CMOS 3.3伏只，同时闪电行动 |
| 文件页数： | 20/57页 |
| 文件大小： | 883K |
| 代理商： | A82DL1642UG-70F |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页
A82DL16x2T(U) Series
PRELIMINARY (May, 2005, Version 0.1)
19
AMIC Technology, Corp.
Hardware Data Protection
The command sequence requirement of unlock cycles for
programming or erasing provides data protection against
inadvertent writes (refer to Table 12 for command definitions).
In addition, the following hardware data protection measures
prevent accidental erasure or programming, which might
otherwise be caused by spurious system level signals during
VCC_F power-up and power-down transitions, or from
system noise.
Low VCC Write Inhibit
When VCC_F is less than V
LKO
, the device does not accept
any write cycles. This protects data during VCC_F
power-up
and power-down. The command register and all internal
program/erase circuits are disabled, and the device resets to
reading array data. Subsequent writes are ignored until
VCC_F is greater than V
LKO
. The system must provide the
proper signals to the control pins to prevent unintentional
writes when VCC_F
is greater than V
LKO
.
Write Pulse “Glitch” Protection
Noise pulses of less than 5ns (typical) on
OE
,
CE_F
or
WE
do not initiate a write cycle.
Logical Inhibit
Write cycles are inhibited by holding any one of
OE
= V
IL
,
CE_F
= V
IH
or
WE
= V
IH
. To initiate a write cycle,
CE_F
and
WE
must be a logical zero while
OE
is a logical one.
Power-Up Write Inhibit
If
WE
=
CE_F
= V
IL
and
OE
= V
IH
during power up, the
device does not accept commands on the rising edge of
WE
.
The internal state machine is automatically reset to reading
array data on power-up.
COMMON FLASH MEMORY INTERFACE (CFI)
The Common Flash Interface (CFI) specification outlines
device and host system software interrogation handshake,
which allows specific vendor-specified software algorithms to
be used for entire families of devices. Software support can
then be device-independent, JEDEC ID-independent, and
forward- and backward-compatible for the specified flash
device families. Flash vendors can standardize their existing
interfaces for long-term compatibility.
This device enters the CFI Query mode when the system
writes the CFI Query command, 98h, to address 55h in word
mode (or address AAh in byte mode), any time the device is
ready to read array data. The system can read CFI
information at the addresses given in Tables 8-11. To
terminate reading CFI data, the system must write the reset
command.
The system can also write the CFI query command when the
device is in the autoselect mode. The device enters the CFI
query mode, and the system can read CFI data at the
addresses given in Tables 8-11. The system must write the
reset command to return the device to the autoselect mode.
Table 8. CFI Query Identification String
Addresses
(Word Mode)
10h
11h
12h
13h
14h
15h
16h
17h
18h
19h
1Ah
Addresses
(Byte Mode)
20h
22h
24h
26h
28h
2Ah
2Ch
2Eh
30h
32h
34h
Data
Description
0051h
0052h
0059h
0002h
0000h
0040h
0000h
0000h
0000h
0000h
0000h
Query Unique ASCII string “QRY”
Primary OEM Command Set
Address for Primary Extended Table
Alternate OEM Command Set (00h = none exists)
Address for Alternate OEM Extended Table (00h = none exists)
相关PDF资料 |
PDF描述 |
|---|---|
| A82DL1632UG-70I | Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1642UG-70I | Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1632UG-70IF | Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1642UG-70IF | Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1632UG-70U | Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A82DL1642UG-70I | 制造商:AMICC 制造商全称:AMIC Technology 功能描述:Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1642UG-70IF | 制造商:AMICC 制造商全称:AMIC Technology 功能描述:Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1642UG-70U | 制造商:AMICC 制造商全称:AMIC Technology 功能描述:Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1642UG-70UF | 制造商:AMICC 制造商全称:AMIC Technology 功能描述:Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x2T(U) 16 Megabit (2Mx8 Bit/1Mx16 Bit) CMOS 3.3 Volt-only, Simultaneous Operation Flash |
| A82DL1644 | 制造商:AMICC 制造商全称:AMIC Technology 功能描述:Stacked Multi-Chip Package (MCP) Flash Memory and SRAM, A82DL16x4T(U) 16 Megabit (2Mx8 Bit/1Simultaneous Operation Flash Memory and 4M (256Kx16 Bit) S |
发布紧急采购，3分钟左右您将得到回复。