参数资料
| 型号： | A8499SLJ-T |
| 厂商： | Allegro Microsystems Inc |
| 文件页数： | 4/7页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 2A 8SOIC |
| 标准包装： | 98 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.2 V ~ 24 V |
| 输入电压： | 8 V ~ 50 V |
| PWM 型： | 电流模式 |
| 电流 - 输出： | 2A |
| 同步整流器： | 无 |
| 工作温度： | -20°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm Width）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 8-SOIC-EP |
A8499
High Voltage Step-Down Regulator
Functional Description
R TSET (2)
t OFF = ,
TheA8499 is a fixed off-time, current-mode–controlled buck
switching regulator. The regulator requires an external clamping
diode, inductor, and filter capacitor, and operates in both continu-
ous and discontinuous modes. An internal blanking circuit is used
to filter out transients resulting from the reverse recovery of the
external clamp diode. Typical blanking time is 200 ns.
The value of a resistor between the TSET pin and ground deter-
mines the fixed off-time (see graph in the t off section).
V OUT . The output voltage is adjustable from 1.2 to 24 V, based on
the combination of the value of the external resistor divider and
the internal 1.2 V ±3% reference. The voltage can be calculated
with the following formula:
V OUT = V FB × (1 + R1/R2) (1)
Light Load Regulation. To maintain voltage regulation during
light load conditions, the switching regulator enters a cycle-skip-
ping mode. As the output current decreases, there remains some
energy that is stored during the power switch minimum on-time.
In order to prevent the output voltage from rising, the regulator
skips cycles once it reaches the minimum on-time, effectively
making the off-time larger.
Soft Start. An internal ramp generator and counter allow the out-
put to slowly ramp up. This limits the maximum demand on the
external power supply by controlling the inrush current required
to charge the external capacitor and any dc load at startup.
Internally, the ramp is set to 10 ms nominal rise time. During soft
start, current limit is 2.2 A minimum.
The following conditions are required to trigger a soft start:
to enable the device and begin the soft start sequence. When the
ENB is open circuited, the switcher is disabled and the output
decays to 0 V.
Protection. The buck switch will be disabled under one or more
of the following fault conditions:
? V IN < 6 V
? ENB pin = open circuit
? TSD fault
When the device comes out of a TSD fault, it will go into a soft
start to limit inrush current.
t OFF . The value of a resistor between the TSET pin and ground
determines the fixed off-time. The formula to calculate t OFF ( μ s)
is:
1.2 10 10
where R TSET (k Ω ) is the value of the resistor. Results are shown
in the following graph:
Resistance vs. Off-Time
17
15
13
11
9
7
5
3
? V IN > 6 V
? ENB pin input falling edge
? Reset of a TSD (thermal shut down) event
1
12
36
60
84 108
R TSET (k Ω )
132
156
180
( V OUT + V f + I OUT R L ) t OFF
V BIAS . Toimproveoverallsystemefficiency,theregulatoroutput,
V OUT , is connected to the VBIAS input to supply the operating
bias current during normal operating conditions. During start up
the circuitry is run off of the VIN supply. VBIAS should be con-
nected to VOUT when the V OUT target level is between 3.3 and
5 V. If the output voltage is less than 3.3 V, then the A8499 can
operate with an internal supply and pay a penalty in efficiency,
as the bias current will come from the high voltage supply, VIN.
VBIAS can also be supplied with an external voltage source. No
power-up sequencing is required for normal opperation.
ON/OFF Control. The ENB pin is externally pulled to ground
t ON . From the volt-second balance of the inductor, the turn-on
time, t ON , can be calculated approximately by the equation:
t ON =
V IN – I OUT R DS(on) – I OUT R L – V OUT
where
V f is the voltage drop across the external Schottky diode,
R L is the winding resistance of the inductor, and
R DS(on) is the on-resistance of the switching MOSFET.
Allegro MicroSystems, LLC
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
(3)
4
相关PDF资料 |
PDF描述 |
|---|---|
| A8582KLPTR-T | IC REG BUCK ADJ 2A 16TSSOP |
| A8583KLPTR-T | IC REG BUCK ADJ 3.5A 16TSSOP |
| A8601KLPTR-T | IC REG MULTIPLE OUTPUT 28-TSSOP |
| A8670EESTR-T | IC REG BUCK ADJ 2A 20QFN |
| A8697ELJ-T | IC REG BUCK ADJ 4A 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A8499SLJ-T | 制造商:Allegro MicroSystems 功能描述:Voltage Regulator IC |
| A8499SLJTR-T | 功能描述:IC REG BUCK ADJ 2A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| A84N2518FSLP | 制造商:HOFFMAN ENCLOSURES 功能描述:LARGE TYPE 1 ENCLOSURE;84.00X25.50X18.00;STEEL;GRAY |
| A84N3624FSLP | 制造商:Pentair Technical Products / Hoffman 功能描述:Lrg Type1 Freestand Enc Gray, 84.00x36.00x24.00, Steel |
| A84N7218FSLP | 制造商:HOFFMAN ENCLOSURES 功能描述:LARGE TYPE 1 ENCLOSURE;84.00X72.00X18.00;STEEL;GRAY |
发布紧急采购，3分钟左右您将得到回复。