- 您现在的位置：买卖IC网 > PDF目录14778 > A8697ELJTR-T (Allegro Microsystems Inc)IC REG BUCK ADJ 4A 8SOIC PDF资料下载
参数资料
| 型号： | A8697ELJTR-T |
| 厂商： | Allegro Microsystems Inc |
| 文件页数： | 9/13页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 4A 8SOIC |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 20 V |
| 输入电压： | 8 V ~ 25 V |
| PWM 型： | 电流模式 |
| 电流 - 输出： | 4A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm Width）裸露焊盘 |
| 包装： | 标准包装 |
| 供应商设备封装： | 8-SOIC-EP |
| 产品目录页面： | 1142 (CN2011-ZH PDF) |
| 其它名称： | 620-1178-6 |
A8697
Wide Input Voltage 4.0 A Step Down Regulator
The switching frequency is calculated as follows:
to the minimum on-time of the switcher.
f SW =
1
t ON + t OFF
(4)
The extension of the off-time is based on the value of the TSET
multiplier and the FB voltage, as shown in the following table:
V FB (V) TSET Multiplier
Shorted Load. If the voltage on the FB pin falls below 0.4 V, the
regulator will invoke a 1.5 A typical overcurrent limit to handle
the shorted load condition at the regulator output. For low output
voltages at power up and in the case of a shorted output, the off-
time is extended to prevent loss of control of the current limit due
Component Selection
< 0.16
< 0.32
< 0.5
> 0.5
8 × t OFF
4 × t OFF
2 × t OFF
t OFF
L1. The inductor must be rated to handle the total load current.
The value should be chosen to keep the ripple current to a reason-
able value. The ripple current, I RIPPLE , can be calculated by:
Substituting into equation 8:
t ON = 2.05 A × 3.8 μ H / 9.94 V = 0.785 μ s
I RIPPLE = V L(OFF) × t OFF / L
V L(OFF) = V OUT + V f + I L(AV) × R L
(5)
(6)
Substituting into equation 7:
f SW = 1 / (5 μ s + 0.785 μ s) = 173 kHz
Higher inductor values can be chosen to lower the ripple cur-
Example:
Given V OUT = 1.06 V, V f = 0.3 V, V IN = 12 V, I LOAD = 4.0 A,
power inductor with L = 3.8 μ H and R L = 0.05 Ω Rdc at 55°C,
t OFF = 5.0 μ s, and R DS(on) = 0.2 Ω .
Substituting into equation 6:
V L(OFF) = 1.06 V + 0.3 V+ 4 A × 0.05 Ω = 1.56 V
Substituting into equation 5:
I RIPPLE = 1.56 V × 5 μ s / 3.8 μ H = 2.05 A
The switching frequency, f SW , can then be estimated by:
rent. This may be an option if it is required to increase the total
maximum current available above that drawn from the switching
regulator. Please refer to the Maximum Load Current graph for
the maximum load recommended.
D1. The Schottky catch diode should be rated to handle 1.2 times
the maximum load current. The voltage rating should be higher
than the maximum input voltage expected during all operating
conditions. The duty cycle for high input voltages can be very
close to 100%.
f SW = 1 / ( t ON + t OFF )
t ON = I RIPPLE × L / V L(ON)
V L(ON) = V IN – I L(AV) × R DS(on) – I L(AV) × R L – V OUT
(7)
(8)
(9)
COUT. The main consideration in selecting an output capacitor
is voltage ripple on the output. For electrolytic output capacitors,
a low-ESR type is recommended.
The peak-to-peak output voltage ripple is simply I RIPPLE × ESR.
Substituting into equation 9:
V L(ON) = 12 V – 4 A × 0.2 Ω – 4 A × 0.05 Ω – 1.06 V = 9.94 V
Note that increasing the inductor value can decrease the ripple
current. The ESR should be in the range from 50 to 500 m Ω .
Allegro MicroSystems, LLC
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
8
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6380XR44+T | IC VOLT DETECT LP 4.38V SC70-3 |
| MAX6379XR46+T | IC VOLT DETECT LP 4.63V SC70-3 |
| SC120SKTRT | IC REG BST SYNC 3.3V/ADJ SOT23-6 |
| GBB34DHND | CONN EDGECARD 68POS .050 DIP SLD |
| GCM28DRAH | CONN EDGECARD 56POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A8698 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:Wide Input Voltage 3.0 A Step Down Regulator |
| A86989-000 | 制造商:TE Connectivity 功能描述:TXR40SJ00-2014BI 制造商:TE Connectivity 功能描述:TXR40SJ00-2014BI - Bulk |
| A8698ELJ-T | 功能描述:IC REG BUCK ADJ 3A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:20 系列:SIMPLE SWITCHER® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:12V 输入电压:4 V ~ 60 V PWM 型:电压模式 频率 - 开关:52kHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:16-DIP 其它名称:*LM2575HVN-12LM2575HVN-12 |
| A8698ELJTR-T | 功能描述:IC REG BUCK ADJ 3A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:MIC23xxx HyperLight Load™ Regulators 标准包装:5,000 系列:HyperLight Load® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.8V 输入电压:2.7 V ~ 5.5 V PWM 型:混合物 频率 - 开关:4MHz 电流 - 输出:2A 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘，8-MLF? 包装:带卷 (TR) 供应商设备封装:8-MLF?（2x2） 产品目录页面:1094 (CN2011-ZH PDF) 其它名称:576-3303-2 |
| A-869-M | 功能描述:端子 DISC MFG 07/01 22-18 MALE BLT DISC RoHS:否 制造商:AVX 产品:Junction Box - Wire to Wire 系列:9826 线规:26-18 接线柱/接头大小: 绝缘: 颜色:Red 型式:Female 触点电镀:Tin over Nickel 触点材料:Beryllium Copper, Phosphor Bronze 端接类型:Crimp |
发布紧急采购，3分钟左右您将得到回复。