- 您现在的位置：买卖IC网 > PDF目录97841 > ACPM-7833-BLK 1850 MHz - 1910 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER PDF资料下载
参数资料
| 型号： | ACPM-7833-BLK |
| 元件分类： | 放大器 |
| 英文描述： | 1850 MHz - 1910 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| 封装： | 4 X 4 MM, 1.10 MM HEIGHT, SMT, 10 PIN |
| 文件页数： | 20/20页 |
| 文件大小： | 208K |
| 代理商： | ACPM-7833-BLK |
9
Specification
Spread Rate1
ERP at Maximum Output Power
Lower limit +23 dBm
Upper limit +30 dBm
Minimum Controlled Output Power
-50 dBm/1.23 MHz
Waveform Quality Factor and Frequency Accuracy
>0.944
SR1, Band Class 0(Cellular band)
SR1, Band Class1(PCS band)
885 kHz to 1.98 MHz
1.25 MHz to 1.98 MHz
Less stringent of -42 dBc/30 kHz
or -54 dBm/1.23 MHz
1.98 MHz to 3.125 MHz
1.98 MHz to 2.25 MHz
Less stringent of -54 dBc/30 kHz
Less stringent of -50 dBc/30 kHz
or -54 dBm/1.23 MHz
3.125 MHz to 5.625 MHz
2.25 MHz to 6.25 MHz
-13 dBm/100 kHz
-13 dBm/1 MHz
Spurious Emission at
Maximum RF output
power offset frequency
within the range
cdma 2000 1xRTT Characterization
System Description
CDMA2000 is the TIA’s standard for third generation
(3G) technology and is an evolution of the IS-95 CDMA
format. CDMA2000 includes 1X RTT in the single-carrier
mode and 3X RTT in the multi-carrier mode. This paper
describes the CDMA2000 1X RTT approach and its
performance with Avago Technologies 4x4 CDMA PAs,
ACPM-7833. CDMA2000 1X RTT, being an extension of
the IS-95 standard, has a chip rate of 1.2288Mchip/s.
However, in 1xRTT, the reverse link transmits more than
one code channel to accommodate the high data rates.
The minimum configuration consists of a reverse pilot
(R-Pilot) channel for synchronous detection by the Base
Transceiver System (BTS) and a reverse fundamental
channel (R-FCH) for voice. Additional channels such as
the reverse supplemental channels (R-SCHs) and the
reverse dedicated channel (R-DCCH) are used to send
data or signaling information. Channels can exist at
different rates and power levels.
Table 1 shows the transmitter specification in
CDMA2000 reverse link.
Table 1. Transmitter Specification in Reverse Link.
Typical channel configurations below are based on the transmitter test
condition in the reverse link.
1) “Basic” Voice only configuration
– R-PICH @ -5.3 dB
– R-FCH @ -1.5 dB 9.6 kbps
2) Voice and Data configuration
– R-PICH @ -5.3 dB
– R-FCH @ -4.54 dB 9.6 kbps
– R-SCH1 @ -4.54 dB 9.6 kbps
3) Voice and Control configuration
– R-PICH @ -5.3 dB
– R-FCH @ -3.85 dB 9.6 kbps
– R-DCCH @ -3.85 dB 9.6 kbps
4) Control channel only configuration
– R-PICH @ -5.3 dB
– R-DCCH @ -1.5 dB 9.6 kbps
相关PDF资料 |
PDF描述 |
|---|---|
| ACPM-7833-TR1 | 1850 MHz - 1910 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| AD8343ARUZ-REEL7 | 0 MHz - 2500 MHz RF/MICROWAVE DOUBLE BALANCED MIXER |
| AD8343ARUZ-REEL | 0 MHz - 2500 MHz RF/MICROWAVE DOUBLE BALANCED MIXER |
| AD8345AREZ1 | 140 MHz - 1000 MHz RF/MICROWAVE QUADRAPHASE MODULATOR |
| AD8345AREZ-RL7 | 140 MHz - 1000 MHz RF/MICROWAVE QUADRAPHASE MODULATOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ACPM-7833-TR1 | 功能描述:射频放大器 CDMA Amp 1850-1910MHz RoHS:否 制造商:Skyworks Solutions, Inc. 类型:Low Noise Amplifier 工作频率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 输出截获点:37.5 dBm 功率增益类型:32 dB 噪声系数:0.85 dB 工作电源电压:5 V 电源电流:125 mA 测试频率:2.6 GHz 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-16 封装:Reel |
| ACPM-7868 | 制造商:AVAGO 制造商全称:AVAGO TECHNOLOGIES LIMITED 功能描述:5 x 5 mm Power Amplifier Module Linear Quad-Band GSM/EDGE |
| ACPM-7868-BLK | 制造商:Avago Technologies 功能描述:PA MODULE, LINEAR EDGE, 5X5MM - Bulk |
| ACPM-7868-TR1 | 制造商:Avago Technologies 功能描述:PA MODULE, LINEAR EDGE, 5X5MM |
| ACPM-7881-BLK | 功能描述:射频放大器 W-CDMA Amp 1920-1980MHz RoHS:否 制造商:Skyworks Solutions, Inc. 类型:Low Noise Amplifier 工作频率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 输出截获点:37.5 dBm 功率增益类型:32 dB 噪声系数:0.85 dB 工作电源电压:5 V 电源电流:125 mA 测试频率:2.6 GHz 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-16 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。