参数资料
| 型号： | AD5446YRMZ-RL7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 8/29页 |
| 文件大小： | 0K |
| 描述： | IC DAC 14BIT SRL 10MSOP |
| 设计资源： | Versatile High Precision Programmable Current Sources Using DACs, Op Amps, and MOSFET Transistors (CN0151) |
| 标准包装： | 1,000 |
| 位数： | 14 |
| 数据接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 转换器数目： | 1 |
| 电压电源： | 单电源 |
| 功率耗散（最大）： | 50.5µW |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 10-MSOP |
| 包装： | 带卷 (TR) |
| 输出数目和类型： | 2 电流，单极；2 电流，双极 |
| 采样率（每秒）： | 2.7M |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
Data Sheet
AD5444/AD5446
Rev. E | Page 15 of 28
GENERAL DESCRIPTION
DAC SECTION
The AD5444/AD5446 are 12-bit and 14-bit current output
DACs consisting of segmented (4 bits), inverting R– 2R ladder
configurations. A simplified diagram for the 12-bit AD5444
is shown in Figure 37.
2R
S1
2R
S2
2R
S3
2R
S12
2R
DAC DATA LATCHES
AND DRIVERS
R
RFB
IOUT1
IOUT2
VREF
0
4
464
-02
9
RR
R
Figure 37. Simplified Ladder
The feedback resistor (RFB) has a value of R. The value of R is
typically 9 kΩ (7 kΩ minimum, 11 kΩ maximum). If IOUT1 is
kept at the same potential as GND, a constant current flows in
each ladder leg, regardless of digital input code. Therefore, the
input resistance presented at VREF is always constant and nomi-
nally of value R. The DAC output (IOUT1) is code-dependent,
producing various resistances and capacitances. The external
amplifier choice should take into account the variation in
impedance generated by the DAC on the amplifiers inverting
input node.
Access is provided to the VREF, RFB, and both IOUT terminals of
the DAC, making the device extremely versatile and allowing it
to be configured in several different operating modes. For
example, the device provides unipolar output mode, 4-quadrant
multiplication in bipolar mode, and single-supply mode of
operation. Note that a matching switch is used in series with the
internal RFB. Power must be applied to VDD to achieve continuity
when measuring RFB.
CIRCUIT OPERATION
Unipolar Mode
Using a single op amp, the AD5444/AD5446 can easily be
configured to provide 2-quadrant multiplying operation or
a unipolar output voltage swing, as shown in Figure 38.
When an output amplifier is connected in unipolar mode, the
output voltage is given by
REF
n
OUT
V
D
V
2
where:
D
is the fractional representation of the digital word loaded to
the DAC:
D
= 0 to 4095 (12-bit AD5444)
D
= 0 to 16383 (14-bit AD5446)
n
is the number of bits.
Note that the output voltage polarity is opposite to the VREF
polarity for dc reference voltages.
This DAC is designed to operate with either negative or positive
reference voltages. The VDD power pin is used by the internal
digital logic only to drive the on and off states of the DAC
switches. The DAC is also designed to accommodate ac refer-
ence input signals in the range of 10 V to +10 V. With a fixed
+10 V reference, the circuit shown in Figure 38 provides a
unipolar 0 V to 10 V output voltage swing. When VIN is an
ac signal, the circuit performs 2-quadrant multiplication.
Table 5 shows the relationship between digital code and
expected output voltage for unipolar operation.
Table 5. Unipolar Code
Digital Input
Analog Output (V)
1111 1111 1111
VREF (4095/4096)
1000 0000 0000
VREF (2048/4096) = VREF/2
0000 0000 0001
VREF (1/4096)
0000 0000 0000
VREF (0/4096) = 0
AD5444/
AD5446
04
588
-03
0
NOTES
1. R1 AND R2 USED ONLY IF GAIN ADJUSTMENT IS REQUIRED.
2. C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE REQUIRED,
IF A1 IS A HIGH SPEED AMPLIFIER.
IOUT1
IOUT2
VREF
VDD
C1
A1
VOUT = 0V TO –VREF
AGND
R2
VDD
VREF
SDIN
SCLK
SYNC
MICROCONTROLLER
RFB
R1
Figure 38. Unipolar Operation
相关PDF资料 |
PDF描述 |
|---|---|
| VI-J52-MY | CONVERTER MOD DC/DC 15V 50W |
| VI-J50-MY | CONVERTER MOD DC/DC 5V 50W |
| AD5420ACPZ-REEL | IC DAC 16BIT SRL 40LFCSP |
| V300A28H500BG2 | CONVERTER MOD DC/DC 28V 500W |
| V300A24H500BG3 | CONVERTER MOD DC/DC 24V 500W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD5447 | 制造商:AD 制造商全称:Analog Devices 功能描述:Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface |
| AD5447YRU | 功能描述:IC DAC 12BIT DUAL MULT 24-TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:47 系列:- 设置时间:2µs 位数:14 数据接口:并联 转换器数目:1 电压电源:单电源 功率耗散（最大）:55µW 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:28-SSOP（0.209"，5.30mm 宽） 供应商设备封装:28-SSOP 包装:管件 输出数目和类型:1 电流，单极；1 电流，双极 采样率（每秒）:* |
| AD5447YRU-REEL | 功能描述:IC DAC 12BIT DUAL MULT 24-TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 产品培训模块:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色产品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 标准包装:91 系列:- 设置时间:4µs 位数:10 数据接口:MICROWIRE?，串行，SPI? 转换器数目:8 电压电源:单电源 功率耗散（最大）:2.7mW 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-DFN-EP（4x3） 包装:管件 输出数目和类型:8 电压，单极 采样率（每秒）:* |
| AD5447YRU-REEL7 | 制造商:Analog Devices 功能描述:DAC 2-CH R-2R 12-bit 24-Pin TSSOP T/R 制造商:Analog Devices 功能描述:DAC 2CH R-2R 12-BIT 24TSSOP - Tape and Reel |
| AD5447YRUZ | 功能描述:IC DAC 12BIT DUAL MULT 24-TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 设置时间:4µs 位数:12 数据接口:串行 转换器数目:2 电压电源:单电源 功率耗散（最大）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-uMAX 包装:管件 输出数目和类型:2 电压，单极 采样率（每秒）:* 产品目录页面:1398 (CN2011-ZH PDF) |
发布紧急采购，3分钟左右您将得到回复。