参数资料
| 型号： | AD5547BRUZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 4/20页 |
| 文件大小： | 0K |
| 描述： | IC DAC 16BIT DUAL 38-TSSOP |
| 产品培训模块： | Data Converter Fundamentals DAC Architectures |
| 设计资源： | Precision, Unipolar, Inverting Conversion Using AD5547/57 DAC (CN0026) Precision, Unipolar, Noninverting Configuration for the AD5547/57 DAC (CN0027) Precision, Bipolar, Configuration for AD5547/AD5557 DAC (CN0028) |
| 标准包装： | 50 |
| 设置时间： | 500ns |
| 位数： | 16 |
| 数据接口： | 并联 |
| 转换器数目： | 2 |
| 电压电源： | 单电源 |
| 功率耗散（最大）： | 55µW |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-TFSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 38-TSSOP |
| 包装： | 管件 |
| 输出数目和类型： | 2 电流，单极；2 电流，双极 |
| 采样率（每秒）： | 2M |
| 产品目录页面： | 783 (CN2011-ZH PDF) |
AD5547/AD5557
Data Sheet
Rev. D | Page 12 of 20
CIRCUIT OPERATION
DAC SECTION
The AD5547/AD5557 are 16-/14-bit, multiplying, current-
output, parallel input DACs. The devices operate from a single
2.7 V to 5.5 V supply and provide both unipolar (0 V to –VREF
or 0 V to +VREF) and bipolar (±VREF) output ranges from –18 V
to +18 V references. In addition to the precision conversion RFB
commonly found in current output DACs, there are three addi-
tional precision resistors for 4-quadrant bipolar applications.
The AD5547/AD5557 consist of two groups of precision R-2R
ladders, which make up the 12/10 LSBs, respectively. Furthermore,
the 4 MSBs are decoded into 15 segments of resistor value 2R.
Figure 18 shows the architecture of the 16-bit AD5547. Each of
the 16 segments and the R-2R ladder carries an equally weighted
current of one-sixteenth of full scale. The feedback resistor RFB
and 4-quadrant resistor ROFS have values of 10 k. Each 4-quadrant
resistor, R1 and R2, equals 5 k. In 4-quadrant operation, R1,
R2, and an external op amp work together to invert the reference
voltage and apply it to the VREF input. With ROFS and RFB
connected as shown in Figure 2, the output can swing from
VREF to +VREF.
The reference voltage inputs exhibit a constant input resistance
of 5 k ± 20%. The impedance of IOUT, the DAC output, is code
dependent. External amplifier choice should take into account
feedback resistance in parallel with the DAC ladder resistance
dominates output voltage noise. To maintain good analog
performance, it is recommended that the power supply is
bypassed with a 0.01 F to 0.1 F ceramic or chip capacitor in
parallel with a 1 F tantalum capacitor. Also, to minimize gain
error, PCB metal traces between VREF and RFB should match.
Every code change of the DAC corresponds to a step function;
gain peaking at each output step may occur if the op amp has
limited GBP and excessive parasitic capacitance present at the
inverting node of the op amp. A compensation capacitor, therefore,
may be needed between the I-to-V op amp inverting and output
nodes to smooth the step transition. Such a compensation capacitor
should be found empirically, but a 20 pF capacitor is generally
adequate for the compensation.
The VDD power is used primarily by the internal logic to drive
the DAC switches. Note that the output precision degrades if
the operating voltage falls below the specified voltage. Users
should also avoid using switching regulators because device
power supply rejection degrades at higher frequencies.
04452-
0
1
2R
80k
R
40k
2R
80k
2R
80k
2R
80k
2R
80k
2R
80k
R
40k
2R
80k
R
2R
80k
R
2R
80k
R
2R
80k
R
2R
80k
2R
80k
R
40k
R2
5k
R1
5k
VREF
2R
80k
R
40k
2R
80k
R
40k
2R
80k
R
40k
2R
80k
R
40k
2R
80k
R
40k
2R
80k
RCOM
R1
ADDRESS DECODER
DAC REGISTER
INPUT REGISTER
LDAC
WR
RS
4 MSB
15 SEGMENTS
8-BIT R2R
4-BIT R2R
15
8
4
LDAC
WR
D15
D14
D0
RS
10k 10k
ROFS
RFB
IOUT
AGND
RA
RB
Figure 18. 16-Bit AD5547 Equivalent R-2R DAC Circuit with Digital Section, One Channel Shown
相关PDF资料 |
PDF描述 |
|---|---|
| VE-20W-MY-F4 | CONVERTER MOD DC/DC 5.5V 50W |
| VE-20V-MY-F4 | CONVERTER MOD DC/DC 5.8V 50W |
| VE-20V-MY-F2 | CONVERTER MOD DC/DC 5.8V 50W |
| AD5547CRUZ | IC DAC 16BIT PAR DUAL 38TSSOP |
| VE-20T-MY-F4 | CONVERTER MOD DC/DC 6.5V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD5547CRUZ | 功能描述:IC DAC 16BIT PAR DUAL 38TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:50 系列:- 设置时间:4µs 位数:12 数据接口:串行 转换器数目:2 电压电源:单电源 功率耗散（最大）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-uMAX 包装:管件 输出数目和类型:2 电压，单极 采样率（每秒）:* 产品目录页面:1398 (CN2011-ZH PDF) |
| AD5547CRUZ-REEL7 | 功能描述:IC DAC 16BIT PAR DUAL 38TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 产品培训模块:Data Converter Fundamentals DAC Architectures 标准包装:750 系列:- 设置时间:7µs 位数:16 数据接口:并联 转换器数目:1 电压电源:双 ± 功率耗散（最大）:100mW 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-LCC（J 形引线） 供应商设备封装:28-PLCC（11.51x11.51） 包装:带卷 (TR) 输出数目和类型:1 电压，单极；1 电压，双极 采样率（每秒）:143k |
| AD5547-EP | 制造商:AD 制造商全称:Analog Devices 功能描述:Dual-Current Output, Parallel Input |
| AD5547SRU-EP | 制造商:AD 制造商全称:Analog Devices 功能描述:Dual-Current Output, Parallel Input |
| AD5551 | 制造商:AD 制造商全称:Analog Devices 功能描述:5 V, Serial-Input Voltage-Output, 14-Bit DACs |
发布紧急采购，3分钟左右您将得到回复。