参数资料
型号: AD648JRZ-REEL7
厂商: Analog Devices Inc
文件页数: 12/12页
文件大小: 0K
描述: IC OPAMP BIFET 1MHZ DUAL 8SOIC
标准包装: 750
放大器类型: J-FET
电路数: 2
转换速率: 1.8 V/µs
增益带宽积: 1MHz
电流 - 输入偏压: 5pA
电压 - 输入偏移: 750µV
电流 - 电源: 340µA
电流 - 输出 / 通道: 15mA
电压 - 电源,单路/双路(±): ±4.5 V ~ 18 V
工作温度: 0°C ~ 70°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SO
包装: 带卷 (TR)
AD648
REV. E
–9–
TEMP
RSH
VOS
IB
C(M )( V)
(1 + RF/RSH) VOS
(pA)
IBRF
TOTAL
–25
15,970
150
151
V
0.30
30
V
181
V
0
2,830
225
233
V
2.26
262
V
495
V
+25
500
300
360
V
10.00
1.0 mV
1.36 mV
+50
88.5
375
800
V
56.6
5.6 mV
6.40 mV
+75
15.6
450
3.33 mV
320
32 mV
35.3 mV
+85
7.8
480
6.63 mV
640
64 mV
70.6 mV
Figure 28. Photodiode Pre-Amp Errors Over Temperature
DUAL PHOTODIODE PREAMP
The performance of the dual photodiode preamp shown in
Figure 27 is enhanced by the AD648’s low input current, input
voltage offset, and offset voltage drift. Each photodiode sources
a current proportional to the incident light power on its surface.
RF converts the photodiode current to an output voltage equal
to RF
× IS.
An error budget illustrating the importance of low amplifier
input current, voltage offset, and offset voltage drift to minimize
output voltage errors can be developed by considering the
equivalent circuit for the small (0.2 mm
2 area) photodiode
shown in Figure 27. The input current results in an error pro-
portional to the feedback resistance used. The amplifier’s offset
will produce an error proportional to the preamp’s noise gain
(1+RF/RSH), where RSH is the photodiode shunt resistance. The
amplifier’s input current will double with every 10
°C rise in
temperature, and the photodiode’s shunt resistance halves with
every 10
°C rise. The error budget in Figure 28 assumes a room
temperature photodiode RSH of 500 M
, and the maximum
input current and input offset voltage specs of an AD648C.
The capacitance at the amplifier’s negative input (the sum of the
photodiode’s shunt capacitance, the op amp’s differential input
capacitance, stray capacitance due to wiring, etc.) will cause a
rise in the preamp’s noise gain over frequency. This can result in
excess noise over the bandwidth of interest. CF reduces the
noise gain “peaking” at the expense of signal bandwidth.
Figure 27. A Dual Photodiode Pre-Amp
The AD648 in this configuration provides a 700 kHz small signal
bandwidth and 1.8 V/
s typical slew rate. The 33 pF capacitor
across the feedback resistor optimizes the circuit’s response. The
oscilloscope photos in Figures 26a and 26b show small and
large signal outputs of the circuit in Figure 24. Upper traces
show the input signal VIN. Lower traces are the resulting output
voltage with the DAC’s digital input set to all 1s. The circuit
settles to
±0.01% for a 20 V input step in 14 s.
Figure 26a. Response to
±20 V p-p Reference Square
Wave
Figure 26b. Response to
±100 mV p-p Reference Square
Wave
相关PDF资料
PDF描述
AD684AQ IC AMP SAMPLE HOLD QUAD 16CDIP
AD704AR-16 IC OPAMP GP QUAD PREC LN 16SOIC
AD706JRZ-REEL7 IC OPAMP GP DUAL PREC 15MA 8SOIC
AD708BQ IC OPAMP GP DUAL PREC 8CDIP
AD711KRZ-REEL7 IC OPAMP BIFET PREC 25MA 8SOIC
相关代理商/技术参数
参数描述
AD648K 制造商:AD 制造商全称:Analog Devices 功能描述:Dual Precision, Low Power BiFET Op Amp
AD648KN 制造商:Rochester Electronics LLC 功能描述:LOW POWER DUAL OP AMP IC - Bulk 制造商:Analog Devices 功能描述:IC OP AMP DUAL BIFET DIP8 648
AD648KN/+ 制造商:未知厂家 制造商全称:未知厂家 功能描述:Operational Amplifier
AD648KNZ 功能描述:IC OPAMP BIFET 1MHZ DUAL LP 8DIP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源,单路/双路(±):3 V ~ 32 V,±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP(0.173",4.40mm 宽) 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR
AD648KR 制造商:Analog Devices 功能描述:OP Amp Dual GP ±18V 8-Pin SOIC N 制造商:Rochester Electronics LLC 功能描述:LOW POWER DUAL OP AMP IC - Bulk