- 您现在的位置：买卖IC网 > PDF目录10067 > AD7703CR (Analog Devices Inc)IC ADC 20BIT LC2MOS MONO 20-SOIC PDF资料下载
参数资料
| 型号： | AD7703CR |
| 厂商： | Analog Devices Inc |
| 文件页数： | 7/16页 |
| 文件大小： | 0K |
| 描述： | IC ADC 20BIT LC2MOS MONO 20-SOIC |
| 标准包装： | 1 |
| 位数： | 20 |
| 采样率（每秒）： | 4k |
| 数据接口： | 串行 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 37mW |
| 电压电源： | 模拟和数字，双 ± |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 20-SOIC W |
| 包装： | 管件 |
| 输入数目和类型： | 1 个单端，单极；1 个单端，双极 |
REV. E
AD7703
–15–
Synchronous External Clock Mode (SEC)
The SEC mode (MODE pin grounded) is designed for direct
interface to the synchronous serial ports of industry-standard
microprocessors such as the 68HC11 and 68HC05. The SEC
mode also allows customized interfaces, using I/O port pins, to
microprocessors that do not have a direct fit with the AD7703’s
other mode.
As shown in Figure 17, a falling edge on
CS enables the serial
data output with the MSB initially valid. Subsequent data bits
change on the falling edge of an externally supplied SCLK. After
the LSB has been transmitted,
DRDY and SDATA go three-state.
If
CS is low and the AD7703 is still transmitting data when a
new data-word becomes available, the old data-word continues
to be transmitted and the new data is lost.
If
CS is taken high at any time during data transmission, SDATA
will go three-state immediately. If
CS returns low, the AD7703
will continue transmission with the same data bit. If transmis-
sion has not been initiated and completed by the time the next
data-word becomes available, and if
CS is high, DRDY returns
high for four clock cycles, then falls as the new word is loaded
into the output register.
DIGITAL NOISE AND OUTPUT LOADING
As mentioned earlier, the AD7703 divides its internal timing
into two distinct phases, analog sampling and settling and digi-
tal computation. In the SSC mode, data is transmitted only
during the digital computation periods, to minimize the effects
of digital noise on analog performance. In the SEC mode, data
transmission is externally controlled, so this automatic safeguard
does not exist. To compensate, synchronize the AD7703 to the
digital system clock via CLKIN when used in the SEC mode.
Whatever mode of operation is used, resistive and capacitive
loads on digital outputs should be minimized in order to reduce
crosstalk between analog and digital portions of the circuit. For
this reason, connection to low power CMOS logic such as one
of the 4000 series or 74C families is recommended.
DRDY (O)
SDATA (O)
DB19 (MSB)
DB18
DB2
DB1
DB0 (LSB)
HI-Z
SCLK (O)
HI-Z
CS (I)
DB17
Figure 17. Timing Diagram for SEC Mode
相关PDF资料 |
PDF描述 |
|---|---|
| IDT72V83L20PA | IC ASYNCH FIFO 1024X18 56TSSOP |
| LT1139ACSW | IC 4DRV/4RCV RS232 5V 24-SOIC |
| AD9644CCPZRL7-80 | IC ADC 14BIT 80MSPS 3V 48LFCSP |
| IDT7283L20PA | IC MEM FIFO 2048X9 20NS 56-TSSOP |
| LT1136ACSW#PBF | IC 4DRV/5RCV RS232 5V 28-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7703CR-REEL | 功能描述:IC ADC 20BIT LC2MOS MONO 20-SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
| AD7703CRZ | 功能描述:IC ADC 20BIT LC2MOS MONO 20SOIC RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:- 位数:14 采样率（每秒）:83k 数据接口:串行，并联 转换器数目:1 功率耗散（最大）:95mW 电压电源:双 ± 工作温度:0°C ~ 70°C 安装类型:通孔 封装/外壳:28-DIP（0.600"，15.24mm） 供应商设备封装:28-PDIP 包装:管件 输入数目和类型:1 个单端，双极 |
| AD7703SQ | 制造商:AD 制造商全称:Analog Devices 功能描述:LC2MOS 20-Bit A/D Converter |
| AD7705 | 制造商:AD 制造商全称:Analog Devices 功能描述:3 V/5 V, 1 mW 2-/3-Channel 16-Bit, Sigma-Delta ADCs |
| AD7705_06 | 制造商:AD 制造商全称:Analog Devices 功能描述:3 V/5 V, 1 mW, 2-/3-Channel, 16-Bit, Sigma-Delta ADCs |
发布紧急采购，3分钟左右您将得到回复。