- 您现在的位置：买卖IC网 > PDF目录1983 > AD7723BSZ-REEL (Analog Devices Inc)IC ADC 16BIT SIGMA-DELTA 44MQFP PDF资料下载
参数资料
| 型号： | AD7723BSZ-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 13/32页 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT SIGMA-DELTA 44MQFP |
| 标准包装： | 800 |
| 位数： | 16 |
| 采样率（每秒）： | 1.2M |
| 数据接口： | 串行，并联 |
| 转换器数目： | 1 |
| 电压电源： | 模拟和数字 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 44-QFP |
| 供应商设备封装： | 44-MQFP（10x10） |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 1 个差分，单极；1 个差分，双极 |
| 配用： | EVAL-AD7723CBZ-ND - BOARD EVALUATION FOR AD7723 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
AD7723
Rev. C | Page 20 of 32
APPLYING THE AD7723
ANALOG INPUT RANGE
The AD7723 has differential inputs to provide common-mode
noise rejection. In unipolar mode, the analog input range is 0 to
8/5 × VREF2, while in bipolar mode, the analog input range is
±4/5 × VREF2. The output code is twos complement binary in
both modes with 1 LSB = 61 V. The ideal input/output transfer
characteristics for the two modes are shown in Figure 34. In
both modes, the absolute voltage on each input must remain
within the supply range AGND to AVDD. The bipolar mode
allows either single-ended or complementary input signals.
011…111
011…110
000…010
000…001
000…000
111…111
111…110
100…000
100…001
–4/5
×V
REF2
0V
+4/5
× V
REF2 – 1LSB BIPOLAR
(0V)
(+4/5
× V
REF2)
(+8/5
× V
REF2 – 1LSB) UNIPOLAR
01186-
034
Figure 34. Bipolar (Unipolar) Mode Transfer Function
The AD7723 accepts full-scale, in-band signals. However, large
scale out-of-band signals can overload the modulator inputs.
Figure 35 shows the maximum input signal level as a function
of frequency. A minimal single-pole, RC, antialias filter set to
fCLKIN/24 allows full-scale input signals over the entire frequency
spectrum.
INPUT SIGNAL FREQUENCY RELATIVE TO
fCLKIN
0
0.5
0.02
0.04
0.06
0.08
0.10
0.12
0.14
2.2
2.1
1.3
PEAK
INPUT
(V
p-p)
1.7
1.6
1.5
1.4
1.9
1.8
2.0
VREF = 2.5V
01186-035
Figure 35. Peak Input Signal Level vs. Signal Frequency
ANALOG INPUT
The analog input of the AD7723 uses a switched capacitor
technique to sample the input signal. For the purpose of driving
the AD7723, an equivalent circuit of the analog inputs is shown
in Figure 36. For each half clock cycle, two highly linear
sampling capacitors are switched to both inputs, converting the
input signal into an equivalent sampled charge. A signal source
driving the analog inputs must be able to source this charge
while also settling to the required accuracy by the end of each
half-clock phase.
500
500
AD7723
CLKIN
VIN(+)
VIN(–)
AC
GROUND
2pF
ΦA
ΦB
ΦA
ΦB
Φ
A ΦB
Φ
A ΦB
20
19
01186-036
Figure 36. Analog Input Equivalent Circuit
DRIVING THE ANALOG INPUTS
To interface the signal source to the AD7723, at least one op
amp is generally required. Choice of op amp is critical to
achieving the full performance of the AD7723. The op amp not
only has to recover from the transient loads that the ADC
imposes on it, but it must also have good distortion
characteristics and very low input noise. Resistors in the signal
path can also add to the overall thermal noise floor,
necessitating the choice of low value resistors.
Placing an RC filter between the drive source and the ADC
inputs, as shown in Figure 37, has a number of beneficial
effects. Transients on the op amp outputs are significantly
reduced because the external capacitor now supplies the
instantaneous charge required when the sampling capacitors are
switched to the ADC input pins and input circuit noise at the
sample images is now significantly attenuated, resulting in
improved overall SNR. The external resistor serves to isolate the
external capacitor from the ADC output, thus improving op
amp stability while also isolating the op amp output from any
remaining transients on the capacitor. By experimenting with
different filter values, the optimum performance can be
achieved for each application. As a guideline, the RC time
constant (R × C) should be less than a quarter of the clock
period to avoid nonlinear currents from the ADC inputs being
stored on the external capacitor and degrading distortion. This
restriction means that this filter cannot form the main antialias
filter for the ADC.
相关PDF资料 |
PDF描述 |
|---|---|
| AD7725BSZ | IC ADC 16BIT PROG 44MQFP |
| AD7730BN | IC ADC TRANSDUCER BRIDGE 24-DIP |
| AD7731BN | IC ADC 24BIT SIGMA-DELTA 24-DIP |
| AD7732BRU | IC ADC 24BIT 2-CH 28-TSSOP |
| AD7734BRU | IC ADC 24BIT 4-CH 28-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7723BSZ-REEL1 | 制造商:AD 制造商全称:Analog Devices 功能描述:16-Bit, 1.2 MSPS CMOS, Sigma-Delta ADC |
| AD7724 | 制造商:AD 制造商全称:Analog Devices 功能描述:Dual CMOS Modulators |
| AD7724ACPZ | 功能描述:IC MOD SIGMA-DELTA DUAL 制造商:analog devices inc. 系列:* 零件状态:上次购买时间 标准包装:1 |
| AD7724ACPZ-REEL | 功能描述:IC MOD SIGMA-DELTA DUAL 制造商:analog devices inc. 系列:* 零件状态:上次购买时间 标准包装:1 |
| AD7724AST | 制造商:Analog Devices 功能描述:ADC Dual Delta-Sigma 30Msps 15-bit Serial 48-Pin LQFP |
发布紧急采购，3分钟左右您将得到回复。