- 您现在的位置：买卖IC网 > PDF目录10252 > AD7829BRU (Analog Devices Inc)IC ADC 8BIT 8CH 2MSPS 28TSSOP PDF资料下载
参数资料
| 型号： | AD7829BRU |
| 厂商： | Analog Devices Inc |
| 文件页数： | 5/28页 |
| 文件大小： | 0K |
| 描述： | IC ADC 8BIT 8CH 2MSPS 28TSSOP |
| 标准包装： | 50 |
| 位数： | 8 |
| 采样率（每秒）： | 2M |
| 数据接口： | 并联 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 36mW |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 28-TSSOP |
| 包装： | 管件 |
| 输入数目和类型： | 8 个单端，单极 |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
AD7822/AD7825/AD7829
Rev. C | Page 13 of 28
Capacitor C2 in Figure 15 is typically about 4 pF and can be
primarily attributed to pin capacitance. The resistor, R1, is a
lumped component made up of the on resistance of several
components, including that of the multiplexer and the track-
and-hold. This resistor is typically about 310 Ω. Capacitor C1
is the track-and-hold capacitor and has a capacitance of 0.5 pF.
Switch 1 is the track-and-hold switch, and Switch 2 is that of the
VIN
C2
4pF
D1
D2
R1
310
SW1
C1
0.5pF A
B
SW2
VDD
01
32
1-
0
15
Figure 15. Equivalent Analog Input Circuit
When in track phase, Switch 1 is closed and Switch 2 is in
Position A. When in hold mode, Switch 1 opens and Switch 2
remains in Position A. The track-and-hold remains in hold
mode for 120 ns (see the Circuit Description section), after
which it returns to track mode and the ADC enters its conversion
phase. At this point, Switch 1 opens and Switch 2 moves to
Position B. At the end of the conversion, Switch 2 moves back
to Position A.
Analog Input Selection
On power-up, the default VIN selection is VIN1. When returning
to normal operation from power-down, the VIN selected is the
same one that was selected prior to initiation of power-down.
Table 6 shows the multiplexer address corresponding to each
analog input from VIN1 to VIN4(8) for the AD7825 or AD7829.
Table 6.
A2
A1
A0
Analog Input Selected
0
VIN1
0
1
VIN2
0
1
0
VIN3
0
1
VIN4
1
0
VIN5
1
0
1
VIN6
1
0
VIN7
1
VIN8
Channel selection on the AD7825 and AD7829 is made without
the necessity of a write operation. The address of the next channel
to be converted is latched at the start of the current read operation,
that is, on the falling edge of RD while CS is low, as shown in
Figure 16. This allows for improved throughput rates in “channel
hopping” applications.
CONVST
DB0 TO DB7
A0 TO A2
EOC
CS
RD
t2
t1
t3
t13
VALID
DATA
ADDRESS CHANNEL y
TRACK CHx
HOLD CHx
TRACK CHy
HOLD CHy
120ns
0
13
21-
016
Figure 16. Channel Hopping Timing
There is a minimum time delay between the falling edge of RD
and the next falling edge of the CONVST signal, t13. This is the
minimum acquisition time required of the track-and-hold to
maintain 8-bit performance. Figure 17 shows the typical perform-
ance of the AD7825 when channel hopping for various acquisition
times. These results are obtained using an external reference
and internal VMID while channel hopping between VIN1 and VIN4
with 0 V on Channel 4 and 0.5 V on Channel 1.
ACQUISITION TIME (ns)
8.0
5.0
10
500
200
EN
O
B
100
50
40
30
20
15
7.5
7.0
6.5
6.0
5.5
8.5
01
32
1-
0
17
Figure 17. Effective Number of Bits vs. Acquisition Time for the AD7825
The on-chip track-and-hold can accommodate input frequencies
to 10 MHz, making the AD7822/AD7825/AD7829 ideal for
subsampling applications. When the AD7825 is converting a
10 MHz input signal at a sampling rate of 2 MSPS, the effective
number of bits typically remains above seven, corresponding to
a signal-to-noise ratio of 42 dBs, as shown in Figure 18.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC2447IUHF#TRPBF | IC ADC 24BIT 8CH HI SPEED 38QFN |
| LTC1867CGN | IC ADC 16BIT 8CH 200KSPS 16SSOP |
| VE-22V-MX-F3 | CONVERTER MOD DC/DC 5.8V 75W |
| VE-22V-MX-F2 | CONVERTER MOD DC/DC 5.8V 75W |
| LTC2449IUHF#TRPBF | IC ADC 24BIT HI SPEED 38QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7829BRU-1 | 制造商:Analog Devices 功能描述:ADC Single Semiflash 2Msps 8-bit Parallel 28-Pin TSSOP |
| AD7829BRU-1REEL7 | 制造商:Analog Devices 功能描述:ADC Single Semiflash 2Msps 8-bit Parallel 28-Pin TSSOP T/R 制造商:Analog Devices 功能描述:ADC SGL SEMIFLASH 2MSPS 8BIT PARALLEL 28TSSOP - Tape and Reel |
| AD7829BRU-REEL | 功能描述:IC ADC 8BIT 8CH 2MSPS 28TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 位数:12 采样率（每秒）:3M 数据接口:- 转换器数目:- 功率耗散（最大）:- 电压电源:- 工作温度:- 安装类型:表面贴装 封装/外壳:SOT-23-6 供应商设备封装:SOT-23-6 包装:带卷 (TR) 输入数目和类型:- |
| AD7829BRU-REEL7 | 功能描述:IC ADC 8BIT 8CH 2MSPS 28TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| AD7829BRUZ | 功能描述:IC ADC 8BIT 8CH 2MSPS 28TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 其它有关文件:TSA1204 View All Specifications 标准包装:1 系列:- 位数:12 采样率（每秒）:20M 数据接口:并联 转换器数目:2 功率耗散（最大）:155mW 电压电源:模拟和数字 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-TQFP 供应商设备封装:48-TQFP（7x7） 包装:Digi-Reel® 输入数目和类型:4 个单端，单极；2 个差分，单极 产品目录页面:1156 (CN2011-ZH PDF) 其它名称:497-5435-6 |
发布紧急采购，3分钟左右您将得到回复。