参数资料
| 型号： | AD7934BRUZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 17/32页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT 4CH 1.5MSPS 28TSSOP |
| 标准包装： | 50 |
| 位数： | 12 |
| 采样率（每秒）： | 1.5M |
| 数据接口： | 并联 |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 13.5mW |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 28-TSSOP |
| 包装： | 管件 |
| 输入数目和类型： | 4 个单端，单极；2 个差分，单极；2 个伪差分，单极 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页当前第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
AD7933/AD7934
Rev. B | Page 24 of 32
Reading Data from the AD7933/AD7934
With the W/B pin tied logic high, the AD7933/AD7934
interface operates in word mode. In this case, a single read
operation from the device accesses the conversion data-word on
Pin DB0 to Pin DB11 (12-bit word) and Pin DB2 to DB11
(10-bit word). The DB8/HBEN pin assumes its DB8 function.
With the W/B pin tied to logic low, the AD7933/AD7934
interface operates in byte mode. In this case, the DB8/HBEN
pin assumes its HBEN function.
Conversion data from the AD7933/AD7934 must be accessed in
two read operations with eight bits of data provided on DB0 to
DB7 for each of the read operations. The HBEN pin determines
whether the read operation accesses the high byte or the low
byte of the 12- or 10-bit word. For a low byte read, DB0 to DB7
provide the eight LSBs of the 12-bit word. For 10-bit operation,
the two LSBs of the low byte are 0s and are followed by six bits
of conversion data. For a high byte read, DB0 to DB3 provide the
four MSBs of the 12-/10-bit word. DB4 and DB5 of the high byte
provide the Channel ID. DB6 and DB7 are always 0.
Figure 34 shows the read cycle timing diagram for a 12- or
10-bit transfer. When operating in word mode, the HBEN input
does not exist and only the first read operation is required to
access data from the device. When operating in byte mode, the
two read cycles shown in Figure 35 are required to access the
full data-word from the device.
The CS and RD signals are gated internally and the level is
triggered active low. In either word mode or byte mode, CS and
RD can be tied together as the timing specifications for t10 and
t11 are 0 ns minimum. This means the bus is constantly driven
by the AD7933/AD7934.
The data is placed onto the data bus a time t13 after both CS and
RD go low. The RD rising edge can be used to latch data out of
the device. After a time, t14, the data lines become three-stated.
Alternatively, CS and RD can be tied permanently low, and the
conversion data is valid and placed onto the data bus a time, t9,
before the falling edge of BUSY.
Note that if RD is pulsed during the conversion time, this
causes a degradation in linearity performance of approximately
0.25 LSB. Reading during conversion, by way of tying CS and
RD low, does not cause any degradation.
t11
t10
t13
t15
t16
t14
t12
t17
LOW BYTE
HIGH BYTE
DB0 TO DB7
HBEN/DB8
RD
CS
0
371
3-
0
05
Figure 35. AD7933/AD7934 Parallel Interface—Read Cycle Timing for Byte Mode Operation (W/B = 0)
相关PDF资料 |
PDF描述 |
|---|---|
| AD7938BCPZ-6 | IC ADC 12BIT 8CH 625KSPS 32LFCSP |
| AD7938BCPZ | IC ADC 12BIT 8CH 1.5MSPS 32LFCSP |
| AD7940BRM | IC ADC 14BIT UNIPOLAR 8-MSOP |
| AD7942BRMZ-RL7 | IC ADC 14BIT 250KSPS 10-MSOP |
| AD7944BCPZ | IC ADC 14BIT 2.5MSPS 20LFCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7934BRUZ-6 | 功能描述:IC ADC 12BIT 4CH 625KSPS 28TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| AD7934BRUZ-6REEL7 | 功能描述:IC ADC 12BIT 4CH 625KSPS 28TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| AD7934BRUZ-REEL7 | 功能描述:IC ADC 12BIT 4CH 1.5MSPS 28TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| AD7937 | 制造商:AD 制造商全称:Analog Devices 功能描述:LC2MOS 8+4 Loading Dual 12-Bit DAC |
| AD7937AR | 功能描述:IC DAC 12BIT DUAL 8+4 24-SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:2,400 系列:- 设置时间:- 位数:18 数据接口:串行 转换器数目:3 电压电源:模拟和数字 功率耗散（最大）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:36-TFBGA 供应商设备封装:36-TFBGA 包装:带卷 (TR) 输出数目和类型:* 采样率（每秒）:* |
发布紧急采购，3分钟左右您将得到回复。