- 您现在的位置：买卖IC网 > PDF目录5870 > AD8001AR-REEL (Analog Devices Inc)IC OPAMP CF LP LDIST 70MA 8SOIC PDF资料下载
参数资料
| 型号： | AD8001AR-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 3/17页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP CF LP LDIST 70MA 8SOIC |
| 标准包装： | 2,500 |
| 放大器类型： | 电流反馈 |
| 电路数： | 1 |
| 转换速率： | 1200 V/µs |
| -3db带宽： | 715MHz |
| 电流 - 输入偏压： | 5µA |
| 电压 - 输入偏移： | 2000µV |
| 电流 - 电源： | 5mA |
| 电流 - 输出 / 通道： | 70mA |
| 电压 - 电源，单路/双路(±)： | ±3 V ~ 6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SO |
| 包装： | 带卷 (TR) |
REV. D
AD8001
–10–
THEORY OF OPERATION
A very simple analysis can put the operation of the AD8001, a
current feedback amplifier, in familiar terms. Being a current
feedback amplifier, the AD8001’s open-loop behavior is expressed
as transimpedance,
VO/I–IN, or TZ. The open-loop transimped-
ance behaves just as the open-loop voltage gain of a voltage
feedback amplifier, that is, it has a large dc value and decreases
at roughly 6 dB/octave in frequency.
Since the RIN is proportional to 1/gM, the equivalent voltage
gain is just TZ
× g
M, where the gM in question is the trans-
conductance of the input stage. This results in a low open-loop
input impedance at the inverting input, a now familiar result.
Using this amplifier as a follower with gain, Figure 4, basic
analysis yields the following result.
V
G
TS
G
R
G
R
Rg
O
IN
Z
ZIN
IN
M
=×
+×
+
=+
=
≈
()
/
1
2
150
VOUT
R1
R2
RIN
VIN
Figure 4. Follower with Gain
Recognizing that G
× R
IN << R1 for low gains, it can be seen to
the first order that bandwidth for this amplifier is independent
of gain (G). This simple analysis in conjunction with Figure 5
can, in fact, predict the behavior of the AD8001 over a wide
range of conditions.
FREQUENCY – Hz
1M
10
100k
1M
1G
100M
10M
100
100k
10k
1k
T
Z
–
Figure 5. Transimpedance vs. Frequency
Considering that additional poles contribute excess phase at
high frequencies, there is a minimum feedback resistance below
which peaking or oscillation may result. This fact is used to
determine the optimum feedback resistance, RF. In practice,
parasitic capacitance at Pin 2 will also add phase in the feedback
loop, so picking an optimum value for RF can be difficult.
Figure 6 illustrates this problem. Here the fine scale (0.1 dB/
div) flatness is plotted versus feedback resistance. These plots
were taken using an evaluation card which is available to cus-
tomers so that these results may readily be duplicated.
Achieving and maintaining gain flatness of better than 0.1 dB at
frequencies above 10 MHz requires careful consideration of
several issues.
OUTPUT
–
dB
0.1
0
–0.9
1M
10M
100M
–0.1
–0.2
–0.3
–0.4
–0.5
FREQUENCY – Hz
–0.6
–0.7
–0.8
G = +2
RF =
649
RF = 698
RF = 750
Figure 6. 0.1 dB Flatness vs. Frequency
Choice of Feedback and Gain Resistors
Because of the above-mentioned relationship between the band-
width and feedback resistor, the fine scale gain flatness will, to
some extent, vary with feedback resistance. It, therefore, is
recommended that once optimum resistor values have been
determined, 1% tolerance values should be used if it is desired to
maintain flatness over a wide range of production lots. In addition,
resistors of different construction have different associated parasitic
capacitance and inductance. Surface-mount resistors were used
for the bulk of the characterization for this data sheet. It is not
recommended that leaded components be used with the AD8001.
相关PDF资料 |
PDF描述 |
|---|---|
| TCA0372BDWR2G | IC OPAMP DUAL POWER 1A 16SOIC |
| TSM-104-01-T-SH | CONN HEADER 4POS .100" SNGL SMD |
| TSM-103-01-T-SH | CONN HEADER 3POS .100" SNGL SMD |
| TSW-139-23-S-D | CONN HEADER 78POS .100" DL GOLD |
| 302-R201 | CONN HEADER R/A 20POS GOLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8001AR-REEL7 | 功能描述:IC OPAMP CF LP LDIST 70MA 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:50 系列:- 放大器类型:J-FET 电路数:2 输出类型:- 转换速率:13 V/µs 增益带宽积:3MHz -3db带宽:- 电流 - 输入偏压:65pA 电压 - 输入偏移:3000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作温度:-40°C ~ 85°C 安装类型:通孔 封装/外壳:8-DIP（0.300"，7.62mm） 供应商设备封装:8-PDIP 包装:管件 |
| AD8001ART | 制造商:AD 制造商全称:Analog Devices 功能描述:800 MHz 50 mW Current Feedback Amplifier(222.93 k) |
| AD8001ART-EBZ | 功能描述:放大器 IC 开发工具 AD8001ART-EBZ_A00674_EB-O5/6RT-1Z RoHS:否 制造商:International Rectifier 产品:Demonstration Boards 类型:Power Amplifiers 工具用于评估:IR4302 工作电源电压:13 V to 23 V |
| AD8001ART-R2 | 制造商:Analog Devices 功能描述:OP Amp Single Current Fdbk 制造商:Rochester Electronics LLC 功能描述:SOT23 HI PERF LO PWR VIDEO AMP - Bulk |
| AD8001ART-REEL | 制造商:Analog Devices 功能描述:OP Amp Single Current Fdbk ±6V/12V 5-Pin SOT-23 T/R 制造商:Rochester Electronics LLC 功能描述:SOT23 HI PERF LO PWR VIDEO AMP - Tape and Reel |
发布紧急采购，3分钟左右您将得到回复。