参数资料
| 型号： | AD8010ANZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 2/12页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP CF 200MA LP 8DIP |
| 标准包装： | 50 |
| 放大器类型： | 电流反馈 |
| 电路数： | 1 |
| 转换速率： | 800 V/µs |
| -3db带宽： | 230MHz |
| 电流 - 输入偏压： | 10µA |
| 电压 - 输入偏移： | 5000µV |
| 电流 - 电源： | 15.5mA |
| 电流 - 输出 / 通道： | 200mA |
| 电压 - 电源，单路/双路(±)： | 9 V ~ 12 V，±4.5 V ~ 6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
AD8010
–10–
REV. B
Differential Line Driver
Twisted pair transmission lines are more often being used for
high frequency analog and digital signals. Over long distances,
however, the attenuation characteristics of these lines can
degrade the performance of the transmission system. To com-
pensate for this, larger signals are transmitted, which after the
attenuation, will still have useful signal strength.
The high output current of two AD8010s can be used along
with a transformer to create a high power differential line driver.
The differential configuration effectively doubles the output
swing, while the step-up transformer further increases the out-
put voltage.
In the circuit in Figure 31 the A device is configured as a gain-
of-two follower, while the B device is a gain-of-two inverter.
These will produce a differential output signal whose maximum
value is twice the peak-to-peak value of the maximum output
of one device. For this circuit a 12 V peak-to-peak output can
be obtained.
The op amps drive a 1:2 step-up transformer that drives a
100
transmission line. Since the impedance reflected back to
the primary varies as the square of the turns ratio, it will appear
as 25
at the primary. This source terminating resistor is split
as a 12.4
resistor at the output of each device.
The circuit shown is capable of delivering 12 V p-p to the line
and operates with a –3 dB bandwidth of 40 MHz. The peak
current output of either op amp is 100 mA.
AD8010
VIN
499
150
402
AD8010
150
806
12.4
+6
–6
1:2
100
Figure 31. High Output Differential Line Driver Using Two AD8010s.
NOTE: Please see Figure 29 for Recommended Bypassing Technique.
相关PDF资料 |
PDF描述 |
|---|---|
| AD8002ANZ | IC OPAMP CF DUAL LP LDIST 8DIP |
| SMBJ24CA/54 | TVS J-LEAD 600W 24V BI-DIR SMD |
| SY88309BLMG | IC AMP PECL LIMITING POST 16-MLF |
| SMBJ20CA/54 | TVS J-LEAD 600W 20V BI-DIR SMD |
| SY88305BLMG | IC AMP CML LIMITING POST 16-MLF |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8010AR | 功能描述:IC OPAMP CF 200MA LP 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:Excalibur™ 放大器类型:J-FET 电路数:1 输出类型:- 转换速率:45 V/µs 增益带宽积:10MHz -3db带宽:- 电流 - 输入偏压:20pA 电压 - 输入偏移:490µV 电流 - 电源:1.7mA 电流 - 输出 / 通道:48mA 电压 - 电源，单路/双路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:带卷 (TR) |
| AD8010AR-16 | 制造商:Analog Devices 功能描述:ADSL Driver Single 16-Pin SOIC W Tube 制造商:Rochester Electronics LLC 功能描述:SOIC-WB 160MA OUTPUT CURRENT HI SPD AMP - Bulk |
| AD8010AR-16-REEL | 制造商:Analog Devices 功能描述:ADSL Driver Single 16-Pin SOIC W T/R |
| AD8010AR-16-REEL7 | 制造商:Analog Devices 功能描述:ADSL Driver Single 16-Pin SOIC W T/R 制造商:Rochester Electronics LLC 功能描述:SOIC-WB 160MA OUTPUT CURRENT HI SPD AMP - Tape and Reel |
| AD8010AR-EBZ | 功能描述:BOARD EVAL FOR AD8010 RoHS:是 类别:编程器，开发系统 >> 评估板 - 运算放大器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- |
发布紧急采购，3分钟左右您将得到回复。