参数资料
| 型号： | AD8290ACPZ-R2 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 8/20页 |
| 文件大小： | 0K |
| 描述： | IC AMP CS CMOS LP 16LFCSP |
| 标准包装： | 250 |
| 放大器类型： | 电流检测 |
| 电路数： | 1 |
| -3db带宽： | 250Hz |
| 电流 - 输入偏压： | 100pA |
| 电流 - 电源： | 1.2mA |
| 电压 - 电源，单路/双路(±)： | 2.6 V ~ 5.5 V，±1.3 V ~ 2.75 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-UFQFN 裸露焊盘，CSP |
| 供应商设备封装： | 16-LFCSP-UQ |
| 包装： | 带卷 (TR) |
AD8290
Rev. B | Page 16 of 20
APPLICATIONS INFORMATION
TYPICAL CONNECTIONS
Figure 45 shows the typical connections for single-supply
operation when used with a sensor bridge.
CURRENT EXCITATION
the IOUT pin. The formula for the excitation current IOUT is
IOUT = (900/RSET) mA
where RSET is the resistor between Pin 10 (GND) and Pin 11
(RSET).
The AD8290 is internally set by the factory to provide the
current excitation described by the previous formula (within the
3 kΩ, resulting in a corresponding IOUT of 1300 μA to 300 μA,
respectively.
ENABLE/DISABLE FUNCTION
Pin 3 (ENBL) provides the enabling/disabling function of the
AD8290 to conserve power when the device is not needed. A
Logic 1 turns the part on and allows it to operate normally. A
Logic 0 disables the output and excitation current and reduces
the quiescent current to less than 10 μA.
The turn-on time upon switching Pin 3 high is dominated
by the output filters. When the device is disabled, the output
becomes high impedance, enabling the muxing application of
multiple AD8290 instrumentation amplifiers.
OUTPUT FILTERING
Filter Capacitor CFILTER is required to limit the amount of
switching noise present at the output. The recommended
bandwidth of the filter created by CFILTER and an internal
100 kΩ is 235 Hz. Select CFILTER based on
CFILTER = 1/(235 × 2 × π × 100 kΩ) = 6.8 nF
For bandwidths greater than 10 Hz, an additional single-pole
RC filter of 235 Hz is required on the output, which is also
recommended when driving an ADC requiring an antialiasing
filter. Internal to the AD8290 is a series 10 kΩ resistor at the
output (R3 in Figure 43) and using an external 68 nF capacitor
to ground produces an RC filter of 235 Hz on the output as well.
These two filters produce an overall bandwidth of approximately
160 Hz for the output signal.
In addition, when driving low impedances, the internal series
10 kΩ resistor creates a voltage divider at the output. If it is
necessary to access the output of the internal amplifier prior
to the 10 kΩ resistor, it is available at the CF2 pin.
For applications with low bandwidths (<10 Hz), only the first
filter capacitor (CFILTER) is required. In this case, the high
frequency noise from the auto-zero amplifier (output amplifier)
is not filtered before the following stage.
CLOCK FEEDTHROUGH
The AD8290 uses two synchronized clocks to perform
autocorrection. The input voltage-to-current amplifiers
are corrected at 60 kHz.
Trace amounts of these clock frequencies can be observed at
the output. The amount of feedthrough is dependent upon the
gain because the autocorrection noise has an input- and output-
referred term. The correction feedthrough is also dependent
upon the values of the external capacitors, C2 and CFILTER.
06
74
5-
0
25
CBRIDGE
NOTES
LAYOUT CONSIDERATIONS:
1. KEEP C1 CLOSE TO PIN 2 AND PIN 10.
2. KEEP RSET CLOSE TO PIN 11.
NC = NO CONNECT
ENBL
VOUT
VOUT
VCC
VINP
VINN
IOUT
RSET
GND
AD8290
4
3
2
10
11
15
14
13
C1
0.1F
CF2
CF1
5
6
C2
68nF
RSET
692 TO 3k
5.0V
NC
16
1
12
9
7
8
CFILTER
6.8nF
Figure 45. Typical Single-Supply Connections
相关PDF资料 |
PDF描述 |
|---|---|
| AD8293G80BRJZ-R2 | IC AMP INST R-R LDRIFT SOT23-8 |
| AD8295ACPZ-R7 | IC AMP INST 1MHZ TRPL LN 16LFCSP |
| AD8330ARQZ-R7 | IC AMP VGA 150MHZ LN LP 16QSOP |
| AD8352ACPZ-R7 | IC AMP RF/IF DIFF 2GHZ 16-LFCSP |
| AD8366ACPZ-R7 | IC DUAL AMP VGA 32LFCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8290ACPZ-R7 | 功能描述:IC SENSOR AMP CMOS G-50 16-LFCSP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:100 系列:- 放大器类型:通用 电路数:1 输出类型:- 转换速率:0.2 V/µs 增益带宽积:- -3db带宽:- 电流 - 输入偏压:100pA 电压 - 输入偏移:30µV 电流 - 电源:380µA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):±2 V ~ 18 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SO 包装:管件 |
| AD8290ACPZ-RL | 功能描述:IC AMP CS CMOS LP 16LFCSP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1,000 系列:- 放大器类型:电压反馈 电路数:4 输出类型:满摆幅 转换速率:33 V/µs 增益带宽积:20MHz -3db带宽:30MHz 电流 - 输入偏压:2nA 电压 - 输入偏移:3000µV 电流 - 电源:2.5mA 电流 - 输出 / 通道:30mA 电压 - 电源，单路/双路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOIC 包装:带卷 (TR) |
| AD8293 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Noise, Low Gain Drift, G = 2000 Instrumentation Amplifier |
| AD8293G160 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Cost, Zero-Drift In-Amp with Filter and Fixed Gain |
| AD8293G160ARJZ-R2 | 功能描述:IC AMP INST R-R LDRIFT SOT23-8 RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:160 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:10 V/µs 增益带宽积:9MHz -3db带宽:- 电流 - 输入偏压:1pA 电压 - 输入偏移:250µV 电流 - 电源:730µA 电流 - 输出 / 通道:28mA 电压 - 电源，单路/双路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC N 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。