参数资料
型号: AD8348ARU-REEL7
厂商: Analog Devices Inc
文件页数: 18/28页
文件大小: 0K
描述: IC QUADRATUR DEMOD 50MHZ 28TSSOP
标准包装: 1,000
功能: 解调器
LO 频率: 100MHz ~ 2GHz
RF 频率: 50MHz ~ 1GHz
P1dB: -22dBm
增益: 25.5dB
噪音数据: 10.75dB
电流 - 电源: 58mA
电源电压: 2.7 V ~ 5.5 V
封装/外壳: 28-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 28-TSSOP
包装: 带卷 (TR)

AD8348
THEORY OF OPERATION
ENBL 15
BIAS
CELL
VREF
14
VREF
IMXO
8
IOFS
13
IAIN
6
DIVIDE
IOPP
4
VCMO
IOPN
3
5
1
VCMO
LOIP
PHASE SPLITTER
Quadrature generation is achieved using a divide-by-2 frequency
divider. Unlike a polyphase filter that achieves quadrature over
a limited frequency range, the divide-by-2 approach maintains
IFIP 11
BY 2
quadrature over a broad frequency range and does not attenuate
IFIN 10
PHASE
SPLITTER
28
LOIN
the LO. The user, however, must provide an external signal XLO
AD8348
that is twice the frequency of the desired LO frequency. XLO drives
VGIN 17
GAIN
CONTROL
VCMO
the clock inputs of two flip-flops that divide down the frequency
by a factor of 2. The outputs of the two flip-flops are one-half
18 19 24
MXIP MXIN ENVG
21
QXMO
16
QOFS
23
QAIN
25 26
QOPP QOPN
period of XLO out of phase. Equivalently, the outputs are one-
Figure 48. Functional Block Diagram
VGA
The VGA is implemented using the patented X-AMP architecture.
The single-ended IF signal is attenuated in eight discrete 6 dB
steps by a passive R-2R ladder. Each discrete attenuated version
of the IF signal is applied to the input of a transconductance
stage. The current outputs of all transconductance stages are
summed together and drive a resistive load at the output of the
VGA. Gain control is achieved by smoothly turning on and
off the relevant transconductance stages with a temperature-
compensated interpolation circuit. This scheme allows the gain
to continuously vary over a 44 dB range with linear-in-decibel
gain control. This configuration also keeps the relative dynamic
range constant (for example, IIP3 ? NF in dB) over the gain
setting; however, the absolute intermodulation intercepts and
noise figure vary directly with gain. The analog voltage VGIN
sets the gain. VGIN = 0.2 V is the maximum gain setting, and
VGIN = 1.2 V is the minimum voltage gain setting.
DOWNCONVERSION MIXERS
The output of the VGA drives two (I and Q) double-balanced
Gilbert cell downconversion mixers. Alternatively, driving the
ENVG pin low can disable the VGA, and the mixers can be
externally driven directly via the MXIP and MXIN ports. At
the input of the mixer, a degenerated differential pair performs
linear voltage-to-current conversions. The differential output
current feeds into the mixer core where it is downconverted by
the mixing action of the Gilbert cell. The phase splitter provides
quadrature LO signals that drive the LO ports of the in-phase
and quadrature mixers.
Buffers at the output of each mixer drive the IMXO and QMXO
pins. These linear, low output impedance buffers drive 40 Ω,
temperature-stable, passive resistors in series with each output
pin (IMXO and QMXO). This 40 Ω should be considered when
calculating the reverse termination if an external filter is inserted
between IMXO (QMXO) and IAIN (QAIN). The VCMO pin sets
the dc output level of the buffer. This can be set externally or
connected to the on-chip 1.0 V reference, VREF.
quarter period (90°) of the desired LO frequency out of phase.
Because the transitions on XLO define the phase difference at
the outputs, deviation from 50% duty cycle translates directly to
quadrature phase errors.
If the user generates XLO from a 1× frequency (f REF ) and a
frequency-doubling circuit (XLO = 2 × f REF ), fundamentally
there is a 180° phase uncertainty between f REF and the AD8348
internal quadrature LO. The phase relationship between I and Q
LO, however, is always 90°.
I/Q BASEBAND AMPLIFIERS
Two (I and Q) fixed gain (20 dB), single-ended-to-differential
amplifiers are provided to amplify the demodulated signal
after off-chip filtering. The amplifiers use voltage feedback to
linearize the gain over the demodulation bandwidth. These
amplifiers can be used to maximize the dynamic range at the
input of an ADC following the AD8348.
The input to the baseband amplifiers, IAIN (QAIN), feeds into
the base of a bipolar transistor with an input impedance of
roughly 50 kΩ. The baseband amplifiers sense the single-ended
difference between IAIN (QAIN) and VCMO. IAIN (QAIN)
can be dc biased by terminating it with a shunt resistor to
VCMO, such as when an external filter is inserted between
IMXO (QMXO) and IAIN (QAIN). Alternatively, any dc
connection to IMXO (QXMO) can provide appropriate bias via
the offset-nulling loop.
ENABLE
A master biasing cell that can be disabled using the ENBL pin
controls the biasing for the chip. If the ENBL pin is held low,
the entire chip powers down to a low power sleep mode,
typically consuming 75 μA at 5 V.
BASEBAND OFFSET CANCELLATION
A low output current integrator senses the output voltage offset
at IOPP and IOPN (QOPP and QOPN) and injects a nulling
current into the signal path. The integration time constant of the
offset-nulling loop is set by Capacitor COFS from IOFS (QOFS) to
Rev. A | Page 18 of 28
相关PDF资料
PDF描述
AD8348ARUZ-REEL7 IC QUADRATURE DEMOD 28-TSSOP TR
D2VW-01-3M MINIATURE BASIC SWITCH
D2VW-01-1M MINIATURE BASIC SWITCH
GLEB07A1B SWITCH SIDE-ROTRY SNAP SPDT
HUF75639G3 MOSFET N-CH 100V 56A TO-247
相关代理商/技术参数
参数描述
AD8348ARUZ 功能描述:IC QUADRATURE DEMOD 28-TSSOP RoHS:是 类别:RF/IF 和 RFID >> RF 解调器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:解调器 LO 频率:- RF 频率:70MHz ~ 300MHz P1dB:-9dBm 增益:- 噪音数据:6.36dB 电流 - 电源:41.5mA 电源电压:2.7 V 封装/外壳:28-WFQFN 裸露焊盘 供应商设备封装:28-TQFN-EP(5x5) 包装:带卷 (TR)
AD8348ARUZ-REEL7 功能描述:IC QUADRATURE DEMOD 28-TSSOP TR RoHS:是 类别:RF/IF 和 RFID >> RF 解调器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 功能:解调器 LO 频率:- RF 频率:70MHz ~ 300MHz P1dB:-9dBm 增益:- 噪音数据:6.36dB 电流 - 电源:41.5mA 电源电压:2.7 V 封装/外壳:28-WFQFN 裸露焊盘 供应商设备封装:28-TQFN-EP(5x5) 包装:带卷 (TR)
AD8348-EVAL 制造商:Analog Devices 功能描述:AD8348ARU EVAL - Bulk
AD8348-EVALZ 功能描述:BOARD EVAL FOR AD8348 RoHS:是 类别:编程器,开发系统 >> 评估演示板和套件 系列:* 标准包装:1 系列:PSoC® 主要目的:电源管理,热管理 嵌入式:- 已用 IC / 零件:- 主要属性:- 次要属性:- 已供物品:板,CD,电源
AD8348XRU 制造商:Analog Devices 功能描述:QUADRATURE MODULATOR X-GRADE - Rail/Tube