参数资料
| 型号： | AD8367ARUZ-RL7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 13/24页 |
| 文件大小： | 0K |
| 描述： | IC AMP VGA 14TSSOP |
| 标准包装： | 1,000 |
| 系列： | X-AMP® |
| 放大器类型： | 可变增益 |
| 电路数： | 1 |
| -3db带宽： | 500MHz |
| 电流 - 输入偏压： | 27µA |
| 电流 - 电源： | 26mA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 14-TSSOP |
| 包装： | 带卷 (TR) |
AD8367
Rev. A | Page 20 of 24
Table 7 details the various configuration options of the evaluation board.
Table 7. Evaluation Board Configuration Options
Component
Function
Default Condition
TP1, TP2
Supply and Ground Vector Pins.
Not Applicable
TP3, TP4
Mode and Gain Vector Pins.
Not Applicable
SW1
VGA/AGC Select: Used to select VGA (Position A) or AGC (Position B) mode of
operation. SW2 must be set for Position A for AGC mode of operation.
SW1 = A
SW2
MODE Select. Used to select positive or negative VGA slope. Set to Position B for an
increasing gain with VGAIN, Position A for decreasing gain law.
SW2 = B
LK1
Device Enable. When LK1 is installed, the ENBL pin is connected to the positive supply
and the AD8367 is in operating mode.
LK1 = Installed
R1, R2
Input Interface. R1 and R2 are used to provide an L-pad impedance-transforming
network. The broadband matching network transforms a 50 Ω source to match a
200 Ω load with 11.5 dB of insertion loss.
R1 = 57.6 Ω (Size 0603)
R2 = 174 Ω (Size 0603)
R3, R4, C4
Output Interface. R3 and R4 are used to transform a 50 Ω load termination to look like
a 200 Ω load with 11.5 dB of insertion loss. The ac coupling capacitor, C4, can be
increased to obtain a lower high-pass corner frequency.
R3 = 57.6 Ω (Size 0603)
R4 = 174 Ω (Size 0603)
C4 = 0.1 μF (Size 0603)
C1, C2, C3, R5, R6
Power Supply Decoupling. The nominal supply decoupling consists of a 1 μF capacitor
to ground, a 4.7 Ω series resistor, and a 0.1 μF capacitor to ground. The same
decoupling network should be used on both the VPSI and VPSO supply lines.
C1 = 1 μF (Size 0603)
R5 = R6 = 4.7 Ω (Size 0805)
C2 = C3 = 0.1 μF (Size 0603)
C5
Internal Supply Decoupling. Capacitor C5 provides midsupply decoupling.
C5 = 10 nF (Size 0603)
CHP
Filter Capacitor. HPFL capacitor, sets the high-pass corner frequency.
CHP = 0.01 μF (Size 0805)
RHP = 0 Ω (Size 0603)
CAGC
AGC Filter Capacitor. Capacitor, CAGC, sets closed-loop AGC response time.
CAGC = 0.1 μF (Size 0805)
R7
Mode Pull-Up Resistor.
R7 = 10 kΩ (Size 0805)
RHP
High-Pass Filter Resistor.
RHP = 100 Ω (Size)
CHARACTERIZATION SETUP AND METHODS
Minimum-loss, L-pad matching networks were used to
interface standard 50 Ω. A test equipment to the 200 Ω input
impedance during the characterization process. Using a 57.6 Ω
shunt resistor followed by a 174 Ω series resistor provides a
broadband match between the 50 Ω test equipment and the
200 Ω device impedance, as illustrated in Figure 45. The
insertion loss of this network is 11.5 dB.
02710-
045
57.6
Ω
174
Ω
57.6
Ω
174
Ω
AD8367
Figure 45. Characterization Test Setup
相关PDF资料 |
PDF描述 |
|---|---|
| 98414-S06-20ULF | MINITEK |
| 2-647135-8 | CONN HEADER 8POS MTA-156 STR AU |
| 52717-1 | CONN SPRING SPADE 12-10AWG SOLIS |
| 66506-223 | QUICKIE*II HEADER |
| 2-647135-7 | CONN HEADER 7POS MTA-156 STR AU |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8367-EVAL | 制造商:Analog Devices 功能描述:Evaluation Kit For 500 MHz, Linear-In-DB VGA With AGC Detector 制造商:Analog Devices 功能描述:AD8367 EVALUATION BOARD - Bulk 制造商:Analog Devices 功能描述:SEMICONDUCTOR ((NS)) |
| AD8367-EVALZ | 制造商:Analog Devices 功能描述:EVAL BOARD - Bulk 制造商:Analog Devices 功能描述:AD8367 EVALUATION BOARD*NIC* |
| AD8367R703F | 制造商:Analog Devices 功能描述:AEROSPACE 500 MHZ, 45 DB LINEAR-IN-DB VARIABLE GAIN AMPLIFIE - Rail/Tube |
| AD8368 | 制造商:AD 制造商全称:Analog Devices 功能描述:800 MHz, Linear-in-dB VGA with AGC Detector |
| AD8368_07 | 制造商:AD 制造商全称:Analog Devices 功能描述:800 MHz, Linear-in-dB VGA with AGC Detector |
发布紧急采购，3分钟左右您将得到回复。