参数资料
型号: AD8561AR-REEL
厂商: Analog Devices Inc
文件页数: 11/12页
文件大小: 0K
描述: IC COMP 7NS ULTRA-FAST 8-SOIC
标准包装: 2,500
类型: 通用
元件数: 1
输出类型: CMOS,补充型,TTL
电压 - 电源,单路/双路(±): 3 V ~ 10 V,±1.5 V ~ 5 V
电压 - 输入偏移(最小值): 7mV @ 5V
电流 - 输入偏压(最小值): 6µA @ 5V
电流 - 静态(最大值): 6mA,3.3mA,5.5mA
CMRR, PSRR(标准): 85dB CMRR,65dB PSRR
传输延迟(最大): 9.8ns
工作温度: -40°C ~ 85°C
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
安装类型: 表面贴装
包装: 带卷 (TR)
AD8561
–8–
INPUT STAGE AND BIAS CURRENTS
The AD8561 uses a PNP differential input stage that enables
the input common-mode range to extend all the way from the
negative supply rail to within 2.2 V of the positive supply rail.
The input common-mode voltage can be found as the average
of the voltage at the two inputs of the device. To ensure the
fastest response time, care should be taken not to allow the
input common-mode voltage to exceed either of these voltages.
The input bias current for the AD8561 is 3
μA. As with any
PNP differential input stage, this bias current will go to zero on
an input that is high and will double on an input that is low.
Care should be taken in choosing resistor values to be con-
nected to the inputs as large resistors could cause significant
voltage drops due to the input bias current.
The input capacitance for the AD8561 is typically 3 pF. This is
measured by inserting a 5 k
Ω source resistance to the input and
measuring the change in propagation delay.
USING HYSTERESIS
Hysteresis can easily be added to a comparator through the
addition of positive feedback. Adding hysteresis to a comparator
offers an advantage in noisy environments where it is not desir-
able for the output to toggle between states when the input
signal is near the switching threshold. Figure 17 shows a
method for configuring the AD8561 with hysteresis.
VREF
R1
SIGNAL
COMPARATOR
R2
CF
Figure 17. Configuring the AD8561 with Hysteresis
The input signal is connected directly to the noninverting input
of the comparator. The output is fed back to the inverting input
through R1 and R2. The ratio of R1 to R1 + R2 establishes the
width of the hysteresis window with VREF setting the center of
the window, or the average switching voltage. The Q output will
switch high when the input voltage is greater than VHI and will
not switch low again until the input voltage is less than VLO as
given in Equation 1:
V HI
= V+ –1–VREF
() R1
R1
+ R2
+V
REF
V LO
=V
REF
1–
R1
+ R2
(1)
Where V+ is the positive supply voltage.
The capacitor CF can also be added to introduce a pole into the
feedback network. This has the effect of increasing the amount
of hysteresis at high frequencies. This can be useful when com-
paring a relatively slow signal in a high frequency noise environ-
ment. At frequencies greater than fP =
1
2
π C
F R2
, the hysteresis
window approaches VHI = V+ – 1 V and VLO = 0 V. At frequen-
cies less than fP the threshold voltages remain as in Equation 1.
Rev. B
相关PDF资料
PDF描述
HIN213EIBZ IC 4DRVR/5RCVR RS232 5V 28-SOIC
LTC1444CDHD#PBF IC COMP QD LP 1.221VREF 16-DFN
LTC1445CDHD#PBF IC COMP QD LP 1.221VREF 16-DFN
LTC2487IDE#PBF IC ADC 16BIT DELTA SIG 14-DFN
LT1711IMS8 IC COMP R-RINOUT SINGLE 8-MSOP
相关代理商/技术参数
参数描述
AD8561AR-REEL7 功能描述:IC COMP 7NS ULTRA-FAST 8-SOIC RoHS:否 类别:集成电路 (IC) >> 线性 - 比较器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:通用 元件数:1 输出类型:CMOS,推挽式,满摆幅,TTL 电压 - 电源,单路/双路(±):2.5 V ~ 5.5 V,±1.25 V ~ 2.75 V 电压 - 输入偏移(最小值):5mV @ 5.5V 电流 - 输入偏压(最小值):1pA @ 5.5V 电流 - 输出(标准):- 电流 - 静态(最大值):24µA CMRR, PSRR(标准):80dB CMRR,80dB PSRR 传输延迟(最大):450ns 磁滞:±3mV 工作温度:-40°C ~ 85°C 封装/外壳:6-WFBGA,CSPBGA 安装类型:表面贴装 包装:管件 其它名称:Q3554586
AD8561ARU 制造商:Analog Devices 功能描述:
AD8561ARUREEL 制造商:AD 功能描述:New
AD8561ARU-REEL 功能描述:IC COMP 7NS ULTRA-FAST 8-TSSOP RoHS:否 类别:集成电路 (IC) >> 线性 - 比较器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 类型:通用 元件数:1 输出类型:CMOS,推挽式,满摆幅,TTL 电压 - 电源,单路/双路(±):2.5 V ~ 5.5 V,±1.25 V ~ 2.75 V 电压 - 输入偏移(最小值):5mV @ 5.5V 电流 - 输入偏压(最小值):1pA @ 5.5V 电流 - 输出(标准):- 电流 - 静态(最大值):24µA CMRR, PSRR(标准):80dB CMRR,80dB PSRR 传输延迟(最大):450ns 磁滞:±3mV 工作温度:-40°C ~ 85°C 封装/外壳:6-WFBGA,CSPBGA 安装类型:表面贴装 包装:管件 其它名称:Q3554586
AD8561ARUZ 功能描述:IC COMP 7NS ULTRA FAST 8-TSSOP RoHS:是 类别:集成电路 (IC) >> 线性 - 比较器 系列:- 标准包装:1 系列:- 类型:通用 元件数:1 输出类型:CMOS,开路集电极,TTL 电压 - 电源,单路/双路(±):2.7 V ~ 5.5 V 电压 - 输入偏移(最小值):7mV @ 5V 电流 - 输入偏压(最小值):0.25µA @ 5V 电流 - 输出(标准):84mA @ 5V 电流 - 静态(最大值):120µA CMRR, PSRR(标准):- 传输延迟(最大):600ns 磁滞:- 工作温度:-40°C ~ 85°C 封装/外壳:SC-74A,SOT-753 安装类型:表面贴装 包装:剪切带 (CT) 产品目录页面:1268 (CN2011-ZH PDF) 其它名称:*LMV331M5*LMV331M5/NOPBLMV331M5CT